P Ideas for Wireless Solutions 802.15.4-Modem PAN4561 OUTLINES - ENWC9A22xxEF The PAN4561 module is a long range, low power, 2.4 GHz ISM band transceiver which includes a complete 802.15.4 physical layer (PHY) modem, designed for the IEEE 802.15.4 wireless standard and a appropriate microcontroller (MCU) with reference oscillator which provides a cost effective solution for long range data links and networks. The RF frontend consists of a power amplifier (PA) and a lownoise amplifier (LNA) for extended range. This module will comply to EN300328, FCC CFR Part 15 and ARIB STD-T66 M ODULES Panasonic Electronic Devices Europe GmbH IRELESS W FEATURES - small size (35mm x 15mm x 3.8mm) 3 antenna options: Single port 50Ω, ceramic antenna or plug 16 selectable Channels with 250 kbps in the 2.4 GHz band Low power modes for increased battery life High sensitivity of -105 dBm typ. at 1% Packet Error Rate 20 dBm typ. output power programmable over a 30 dB range Low supply voltage (2.7 V to 3.3 V, 3.0 V typ.) Operating temperature range -40°C to +85°C Link Quality and Clear Channel Assessment capability 60k Flash and 4k RAM memory two UARTs and one I2C bus 8 channel A/D converter with 10 Bit for fast and easy conversion from analog inputs -such as temperature, pressure and fluid levels- to digital values. - 5 channel 16 Bit timer/pulse width modulation (TPM) outputs - BDM port for direct download programming - In total 33 digital I/O lines with programmable pull-ups and few with high-current driver. APPLICATIONS - Remote control and wire replacement in industrial systems such as wireless sensor networks - Factory / home automation and motor / lighting control - Inventory management and RF ID tagging and AMR - Monitoring (environmental, patient or fitness) Design and Specifications are subject to change without notice. Ask the factory for technical specifications before purchase and/or use. If there is any doubt regarding the safety of this product, kindly inform us immediately for technical consultation. 4561-100-101 Rev. E www.pedeu.panasonic.de [email protected] Hardware Status: Engineering Samples P CONTACT Carsten Pfaff Head of Product Marketing HY-LINE Communication Products Vertriebs GmbH Inselkammerstr. 10 82008 Unterhaching / Munich, Germany Tel. +49 (0) 89 614503236 Fax +49 (0) 89 6140960 Mobile +49 (0) 15116774046 [email protected] DIMENSIONS Pin no. Antenna 15.0 mm 1, 22, 32, GND 56 to 62 1 0.25 mm 22 Pad 1 = 4 x 1.30mm x 1.30mm Pad 2 = 58 x 0.60mm x 1.30mm 32 Pin name 53 Note: The pin names of the module and the internal MC1321x names fit to each other. All unmentioned pins are not connected and must be left open. 2 to 5 TPM2CH1-4 (PTD4-7) Pin no. Pin name 23 / 24 Vcc 25 / 26 32 kHz Xtal 27 /Reset 28 CLKO 30 BKGD/MS (PTG0) VDDA 6 TPM1CH2 (PTD2) 8 UART2 TxD (PTC0) 33 UART2 RxD (PTC1) I2C SDA1 34 to 41 KBI1 7-0 (PTA7-0) 42 to 45 PTC 7-4 9 10 11 12 to 19 46 UART1 TxD (PTE0) (PTC3) 47 AD1P 0-7 (PTB0-7) UART1 RxD (PTE1) 52 /PA_PwrDn (PTC2) I2C SCL1 20 ADC Ref. H 53 to 54 21 ADC Ref. L 55 GND 50 Ohm RF TECHNICAL CHARACTERISTICS Parameter Value Condition / Note Receiver Sensitivity -105 dBm typ. for 1% packet error rate Output Power 19 dBm typical Power Supply 2.7 V to 3.3 V single supply, 3.0 V typ. Power Control Range 30 dB Maximum Data Rate 250kbps Current Consumption receive mode transmit mode idle mode standby mode sleep mode off mode 53 mA typ. 210 mA typ. 1.6 mA typ. 36.3 µA typ. 2,2 µA typ. 0,55 µA typ. Operating Temperature Range over the air @output power max no CLKO -40°C to +85°C Notes: All parameters are valid for VDD = 2.7V and Tamb = 25°C. Software from E-Senza Technologies GmbH and Synapse Wireless Inc. will run on this module, to create a wireless mesh network. Freescale‘s MC13213 is included in the module and Mode Definitions and Transition Times for saving battery life can be seen in the data sheet MC1321x. Also the derivative MC13212 and MC13211 as well a pin compatible non-PA/LNA version (PAN4560) are available. www.pedeu.panasonic.de [email protected] Hardware Status: Engineering Samples