P Cut the Cable TM Bluetooth-Module PAN1321 OUTLINES - ENW89811x4CF (Module with shielding) M ODULES Panasonic Electronic Devices Europe GmbH IRELESS W Now you can integrate Bluetooth very easy in your final product, with the PAN1321-SPP as a full Bluetooth system solution. In comparison to our pin compatible HCI solution (PAN1310), there is no longer a powerful host needed. The PAN1321 is manufactured in a 15,6 x 8,7 x 1.8 mm³ SMD LGA package with shielded case and will be qualified to the Bluetooth 2.0 standard. Due to a very low price PAN1321 is well suited for units produced in all quantities, with the simple AT command set you are able to integrate PAN1321 into your application. This module follows the national and international regulations, e.g. EMC, Safety, EN300328, FCC. FEATURES General - Supported Profiles: RFCOMM, SPP device A and B - Complete Bluetooth 2.0 + EDR solution - Ultra low power design - Temperature from -40°C to +70°C, optional +85°C (Industrial Range) - No external components needed - Integrates ARM7TDMI, RAM and patchable 256k EEPROM (for device configuration data and application) - On-module voltage regulator. External supply 2.7-3.6V - Reference clock included - Low power clock from internal oscillator or external low power clock Interfaces - 3.25 MBaud UART - General purpose I/Os with interrupt and wake-up capabilities - JTAG for boundary scan and debug Bluetooth - Scatternet with one slave role while still being visible - Power control and RSSI - Sniff mode, Adaptive Frequency Hopping and Quality of Service ORDERING CODE - PAN1321 with SPP and max. +70°C - PAN1321 with SPP and max. +85°C ENW89811J4CF ENW89811K4CF Design and Specifications are subject to change without notice. Ask the factory for technical specifications before purchase and/or use. If there is any doubt regarding the safety of this product, kindly inform us immediately for technical consultation. PAN1311 Rev. A3 www.pedeu.panasonic.de [email protected] Hardware Status: Under Development P APPLICATIONS All Wireless Applications - Printer Adapters and Scanners - Printers - Access Points - Wireless Sensors - Cable Replacement Personal Digital Assistants (PDAs) PC Motherboards & - Peripherals Industrial Applications BLOCK DIAGRAM TECHNICAL CHARACTERISTICS Parameter -3 Receiver Sensitivity (BER=10 ) Output Power Value Condition / Note -86 dBm typ. ideal wanted signal +3 dBm typ. @ 50 Ohm antenna pin Power Supply 2,7 - 3,6 V Single operation voltage Ultra Low Power Mode 80µA T = 25°C ACL (Transmit 3-DH1) 40mA Enhanced Data Rate, 531.2 kb/s (1) ACL (Receive 3-DH1) 37mA Enhanced Data Rate, 531.2 kb/s (1) Operating Temperature Range -40°C to +70°C optional +85°C (1) Figure indicates maximum possible data rate with this packet type. Total throughput depends on application and interface setting. www.pedeu.panasonic.de [email protected] Hardware Status: Under Development