40W DC-DC Converter P40B-Series ● ● ● ● ● ● ● ● ● ● ● ● Wide 4:1 input range Efficiency up to 92% Adjustable output voltage Remote control on/off 1600 VDC isolation Continuous short circuit protection Over voltage protection Over Temperature protection Standard package 2” x 2” x 0.4” MTBF >150 khrs -40...+85°C operating temperature range Soft start function Model selection guide Type Input nominal voltage [VDC] Single output P40B243R3S P40B2405S P40B2412S P40B2415S P40B483R3S P40B4805S P40B4812S P40B4815S Dual output P40B2412D P40B2415D P40B4812D P40B4815D Input current no load full load [mA] [mA] Output voltage Output current Ripple & noise *3 Z-Diode output protection Efficiency typ. @ full load Capacitive load *4 [VDC] [mA] [mVpk-pk] [VDC] [%] [µF] 9...36 9...36 9...36 9...36 18...75 18...75 18...75 18...75 80 100 50 50 60 60 30 30 1600 1900 1920 1920 800 950 960 950 3.3 5.0 12.0 15.0 3.3 5.0 12.0 15.0 10000 8000 3350 2650 10000 8000 3350 2650 50 50 75 75 50 50 75 75 3.9 6.2 15 18 3.9 6.2 15 18 89 91 90 90 89 92 90 91 25000 13000 2300 1500 25000 13000 2300 1500 9...36 9...36 18...75 18...75 60 60 30 30 1940 1940 960 960 ±12.0 ±15.0 ±12.0 ±15.0 ±1650 ±1350 ±1650 ±1350 150 150 150 150 ±15 ±18 ±15 ±18 89 89 90 90 2 x 1200 2 x 750 2 x 1200 2 x 750 Application example for single output version + INPUT C1 + 220µF < 90 mΩ L 12µH C2 1µF 100V The output voltage can be externally trimmed by using the method shown below. ( ) for dual output trim 1 6 Remote ON 5 +SENSE 3 DC/DC - Converter P40Bxxxxx Remote OFF + OUTPUT R - Trim down 8 C-load See table 4 -SENSE R - Trim up - OUTPUT - INPUT 7 2 1. For the Single output: Maximum output deviation is 10 % inclusive of remote sense and trim. If remote sense is not being used, the + SENSE should be connected to it’s corresponding +OUTPUT and likewise the - SENSE should be connected to its corresponding -OUTPUT. 2. One load is 25 % to 100 % load, the other load is 100 % load, the output voltage variable rate is within ± 5 %. 3. Measured with 20 MHz bandwidth and 1.0 µF ceramic capacitor. 4. Tested by minimal Vin and constant resistive load. 5. Tested by normal Vin and 25 % load step change ( 75 %-50 %-25 % of full load ). 6. Measured Input reflected ripple current with a simulated source inductance of 12 µH. 7. The remote on / off control pin is referenced to –Vin (pin 2). 8. The P40B-series can meet EN55022 Class A with an external filter in parallel with the input pins . 9. An external filter capacitor is required if the module has to meet EN61000-4-4 and EN61000-4-5. The filter capacitor PHI-CON suggest: NIPPON CHEMI-CONs KY - series, 220 µF / 100V. 10. Exceeding the absolute ratings of the unit could cause damage. It is not allowed for continuous operating! Page 1 of 3 Deutschland: Inselkammerstraße 10 D-82008 Unterhaching Tel.: 089 614 503-10 E-Mail: [email protected] Schweiz: Gründenstrasse 82 CH-8247 Flurlingen Tel.: 052 647 42 00 E-Mail: [email protected] 40W DC-DC Converter P40B-Series Specifications Input Under Voltage lockout Vin 24V types Vin 48V types Filter Reflected ripple current *6 Remote control levels *7 On Off Off input idle current Isolation: Rated voltage (tested for 3 s) Resistance Capacitance Output Voltage accuracy Output voltage trim range Voltage cross balance (dual outputs) *2 Line voltage regulation Load voltage regulation single Load voltage regulation dual Temperature coefficient Transient recovery time *5 Transient response deviation *5 Short circuit protection Over load protection Short circuit restart on @ 8.6 VDC, off @ 7.9 VDC on @ 17.8 VDC, off @ 16 VDC π - type 20 mAp-p, typ. 3~12 VDC or open input 0~1.2 VDC 5 mA, typ. 1600 VDC 9 10 Ω 2500 pF, typ. ±1% ± 10 % ±5 % @ 25 % / 100 % of load ± 0.5 % ± 0.5 % @ 0 %...100 % load ± 1 % @ 1 %...100 % load ± 0.02 % / °C 250 µs, typ 3% Continuous, hiccup 130 % of full load, typ. Automatic General Start up time Switching frequency Safety standard in accordance with Reliability Calculated MBTF EMC characteristics Radiated emissions Conducted emissions *8 ESD RS EFT *9 Surge *9 CS PFMF Environmental Operating temperatur (ambient) Case temperature Storage temperature Over temp. protection Humidity Cooling Physical Dimensions Weight Case material Potting Material Absolute max. ratings *10 Pin soldering temperature 1.5 mm distance from body Max. input voltage for 0.1s Vin 24 V types Vin 48 V types 25 ms @ R-load 270 kHz, typ. IEC / EN 60950-1 >150000 hrs EN55022 Class A EN55022 Class A EN61000-4-2 pref criteria A EN61000-4-3 pref criteria A EN61000-4-4 pref criteria A EN61000-4-5 pref criteria A EN61000-4-6 pref criteria A EN61000-4-8 pref criteria A -40 °C to +85 °C with derating -40 °C to +55 °C full load 105 °C, max. -40 °C to +125 °C t-case 110 °C, typ Up to 95 %, non-condensing Free-air convection 50.80 x 50.80 x 10.16 mm 60 g Nickel-coated brass Epoxy (UL94V-0 rated) 260°C for 10 sec -0.7~50 VDC -0.7~100 VDC Efficiency vias load change Page 2 of 3 Deutschland: Inselkammerstraße 10 D-82008 Unterhaching Tel.: 089 614 503-10 E-Mail: [email protected] Schweiz: Gründenstrasse 82 CH-8247 Flurlingen Tel.: 052 647 42 00 E-Mail: [email protected] 40W DC-DC Converter P40B-Series Dimensions Pin configuration Pin 1 2 3 4 5 6 7 8 Single + Vin - Vin Rem ctrl - Sense + Sense + Vout - Vout Trim Dual + Vin - Vin Rem ctrl + Vout Common Common - Vout Trim Only for professional use by professionals! Not for resale or distribution to the general public in any way! Read the instructions for use carefully before using! Life Support Policy: HY-LINE does not authorize the use of any of its products for use in life support devices or systems without the express written approval of an officer of the Company. Life support systems are devices which support or sustain life, and whose failure to perform, when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in significant injury to the user. Rev: 9.12 f Page 3 of 3 Deutschland: Inselkammerstraße 10 D-82008 Unterhaching Tel.: 089 614 503-10 E-Mail: [email protected] Schweiz: Gründenstrasse 82 CH-8247 Flurlingen Tel.: 052 647 42 00 E-Mail: [email protected]