ETC AVR-P40B-8535-8MHZ

AVR-P40B-8535 PROTOTYPE BOARD WITH 10 PIN ICSP CONNECTOR
FOR AT90S8535 AVR MICROCONTROLLERS
Features:
AVR-P40B-8535 is prototype board for
AT90S8535
AVR
microcontrollers
with
following features:
- RS232 Tx, Rx interface with MAX232 IC
- ICSP 10 pin connector (STK compatible)
- RESET IC ZM33064C
- Status LED connected to PB0 via
removable jumper
- 4MHz, 8MHz quartz oscillator
- extension slot on each microcontroller pin
- DIL40 microcontroller socket
- AGND-GND and AVCC-VCC jumpers
- power supply plug in jack connector
- +5V power supply voltage regulator
- 0.1” (2.54 mm) grid
- dimensions: 100x80 mm
- four mounting holes
Lanconelli and the latest release may be
download for free from http://www.lancos.com
The parallel port ICSP programmer (AVRPG2B) works with AVR ISP from Atmel and
may be download for free from Atmel’s web site.
ICSP interface:
The ICSP connector is 2x5 pin with 0,1" step and
Atmel STKxxx compatible layout. The PIN.1 is
marked with square pad on bottom and arrow on
top. ICSP signals are: 1- MOSI, 2- VCC, 3- NC,
4- GND, 5- RST, 6- GND, 7- SCK, 8- GND, 9MISO, 10- GND
TOP view PCB board layout:
RS232 interface:
J1 removable jumper selects where RTS/DTR
line to be connected. In position 12 the line is
connected to RTS, in position 23 is connected to
DTR.
Status LED:
Connected to PB0 via removable jumper.
Oscillator circuit:
Crystal resonator connected to XTAL1 and
XTAL2.
Analog VCC and GND:
J2 connects AVCC to VCC.
J3 connects AGND to GND.
RESET supervisor circuit:
IC ZM33064C with 4.6V threshold.
Programming:
To program AVR-P40B-8535 you need serial
port or parallel port AVR-ICSP programmer
dongle (Olimex part # AVR-PG1B or AVRPG2B).
The serial port ICSP programmer (AVR-PG1B)
works with PonyProg software by from Claudio
Supported devices:
AT90S8535 and AT90S4434 microcontrollers.
Ordering codes:
AVR-P40B-8535-4Mhz - assembled and tested
AVR-P40B-8535-8MHz - assembled and tested
AVR-P40B-8535/PCB
- only PCB
Copyright(c) 2002, OLIMEX Ltd, All rights reserved.
Development boards for PIC, AVR and MSP430 microcontrollers http://www.olimex.com/dev