Specification Sheet

PB251A-CM Series
B AT T E R Y C H A R G E R S Y S T E M
FEATURES
•
•
•
•
•
•
•
•
•
•
•
•
220 - 330W Battery Charger System
DC UPS Connectable
Constant Float Voltage & Current Limit
Circuit Breakers & Alarm Relays
Independent Battery Charging Output
DC OK & Battery OK Alarms
Battery Connected Test
LVD - Battery Low Volts Disconnect
Optional Battery Charge Current Limit
Optional Network Connected
Optional Battery Temperature Probe
OPERATIONS INSTALLATION HANDBOOK AVAILABLE
SPECIFICATIONS
INPUT
Input Voltage:
190 to 264Vac, or 225 to 400Vdc
Frequency:
45 to 65 Hz
Input Current:
1.4A maximum
Inrush current:
10A maximum
Line regulation:
0.2%typical
OUTPUT
Output Voltage
13.8Vdc, 27.6Vdc
Output Current
13.8Vdc: 20A
27.6Vdc: 12A
Load regulation
0.5% typical
Ripple & noise
100 MHz bandwidth
28mVp-p (13.8Vdc output)
55mVp-p (27.6Vdc output)
Efficiency
> 80%
PROTECTION
ALARMS & BATTERY
FUNCTIONS
Green LED : ON=OK voltage free change over
relay contacts (32V,1A) Alarms on loss of AC
DC OK alarm
mains power or failure of off-line AC/DC
converter / battery charger
Green LED : ON=OK voltage free change over
relay contacts(32V,1A) Alarms on battery low
Battery OK alarm
voltage 11V, failure of battery fuse or battery
disconnected. Alarm cancelled when fuse or
battery replaced, or AC input restored
10.2 to 12.6V for 12V battery, adjustable 20.4 to
Battery low voltage disconnect 25.2V for 24V battery,adjustable Indicated by
voltage-free changeover relay contacts & green
(LVD)
LED: ON=BATT OK
9.6 to 12V for 12V battery, adjustable
Low voltage disconnect
19.2 to 24V for 24V battery, adjustable
Charger over-load protection
Auto-resetting electronic circuit breaker
Reverse polarity protection
Internal battery fuse
Battery to load voltage drop
0.2 to. 0.25V typical
Current limit
Load circuit - Constant current
Battery circuit - Constant current
Short circuit protection
Indefinite, auto-resetting
Short circuit protection
Indefinite, auto-resetting
Over-voltage protection
17.5 to 20V latching (13.8Vdc output)
31.5 to 39V latching (27.6Vdc output)
Heatsink
Input to Output: 4.2Kvdc 1 min
Output to Ground: 2.1Kvdc 1 min
Output to Ground: 700Vdc 1 min
Network enabled
Isolation
OPTIONAL FEATURES
Battery Charging Limit
ENVIRONMENTAL
Operating temperature
0 to 70°C ambient
Derating from full power at Ta=25°C
to 0W at Ta=70°C at -2.22%/°C
Humidity
5 to 90% relative humidity (non-condensing)
Over-temperature protection
Automatic & auto-resetting
Cooling requirement
Natural convection
STANDARDS & APPROVALS
Temperature compensation
Conformal Coating
MECHANICAL
Case size
IEC60320 inlet,10A Class 1
2 meter IEC mains cord with Australian plug is
supplied with each unit
4 way pluggable screw terminal block
Suitable for up to 4mm² wire
6 way pluggable screw terminal block
Suitable for up to 1.5mm² wire
264 L x 172 W x 67 H mm
Case size with heatsink
264 L x 186 W x 67 H mm
Weight
1.9kg
Weight with heatsink
2.1kg
Rack mount option
Refer to PB251-RM Series
Input connector
Output/Battery connector
C-Tick
AS/NZS CISPR11 Group 1 Class A.
Safety
Complies with AS/NZS 60950, class 1, NSW
Office of Fair Trading Approval N20602
EMC
Emissions comply with AS/NZS CISPR11,
Group 1, Class B. Complies with ACA EMC
Scheme,
Safety & EMC Regulatory Compliance
Marked
Option BCL: Factory set to maximum of the total
rated output current. The BCL charging current
based on A/H battery size and make of battery.
Option H: Supplementary heatsink
Option N: Internal network card in conjunction
with PB251A becomes a network enabled
device combining the benefits of SNMP V1, XML
and embedded webpage.
Option T: 2.5m cable probe
Option T5: 5m cable probe
Float voltage set to 2.3V/cell at 25°C with
compensation of 3.3mv/°C cell
Option CC: Tropic protection for moist areas
Alarm terminal
www.powerbox.com.au - 1800 251 380
www.powerbox.co.nz - 0800 104 480
Doc. No. PB251A-CM Rev.D 17-05-16
PB251A-CM Series
B AT T E R Y C H A R G E R S Y S T E M
SELECTION TABLE
MODEL NUMBER
OUTPUT VOLTAGE
TOTAL CURRENT
BATTERY CURRENT
OUTPUT POWER
PB251A-12CM
13.8V
16A
2A
220W
PB251A-12CM-H
13.8V
20A
4A
275W
PB251A-24CM
27.6V
11A
2A
300W
PB251A-24CM-H
27.6V
12A
2A
330W
TECHNICAL ILLUSTRATIONS
www.powerbox.com.au - 1800 251 380
www.powerbox.co.nz - 0800 104 480
Doc. No. PB251A-CM Rev.D 17-05-16