Package Outline Drawing (POD)

Plastic Packages for Integrated Circuits
Package Outline Drawing
L32.5x7B
32 LEAD QUAD FLAT NO-LEAD PLASTIC PACKAGE
Rev 0, 3/12
0.10 M C A B
0.10 M C A B
0.25
0.50
6
PIN 1
INDEX AREA
5.00
A
0.25
0.203
0.50
0.50
B
0.10 M C A B
1.18
SIDE VIEW
SEE DETAIL "X"
// 0.10 C
C
BASE PLANE
SEATING PLANE
0.08 C
1.00
0.55
1.31
7.00
0.83
0.83
0.02
0.90±0.10
(2X)
C 0.2 REF
0.25
0.05
5
0.00 MIN
0.05 MAX
TOP VIEW
DETAIL "X"
0.50
1.35
0.25
0.40 (28x)
0.10 M C A B
6
PIN #1
INDEX AREA
0.25 (32x)
0.65
0.19
6
PIN #1
INDEX AREA
0.65
1
1
0.25
2.07
1
0.65
3.70
0.610
0.25
7.00
0.55
0.469
1.00
0.30
0.305
0.825
(2x)
0.345
0.64
0.45
0.28
0.40
0.363
0.79
0.363
5.00
BOTTOM VIEW
1
3.90
0.15
0.55
3.90
0.441
4.45
2.254
6
PIN #1
INDEX AREA
Plastic Packages for Integrated Circuits
4.80
0.60 (28x)
3.70
3.50
0.50 (19x)
2.07
0.83
1.00
1.18
1.00
0.83
6.80
0.25 (27x)
4.35
1.025
(2x)
0.55
1.35
1.35
2.254
3.735
TYPICAL RECOMMENDED LAND PATTERN
NOTES:
1.
Dimensions are in millimeters.
Dimensions in ( ) for Reference Only.
2.
Dimensioning and tolerancing conform to ASME Y14.5m-1994.
3.
Unless otherwise specified, tolerance : Decimal ± 0.05
4.
Dimension applies to the metallized terminal and is measured
between 0.15mm and 0.25mm from the terminal tip.
5.
Tiebar shown (if present) is a non-functional feature.
6.
The configuration of the pin #1 identifier is optional, but must be
located within the zone indicated. The pin #1 identifier may be
either a mold or mark feature.
2