Tape and Reel Specifications and Packaging Specifications for Surface Mounted Mold Diodes Embossed Tape and Reel is used to facilitate automatic pick and place equipment feed requirements. The tape is used as the shipping container for various products and requires a minimum of handling. The antistatic / conductive tape provides a secure cavity for the product when sealed with the “peel-back” cover tape. • Two Reel Sizes Available (7" and 13") • SOD-123 / SC-76 / SOD-523 / SOD-723 / SOT-323 / SOT-523 / SOT-363 / TO-236 in 8 mm Tape • Used for Automatic Pick and Place Feed Systems Use the standard device title and add the required suffix as listed in the option table on the following page. Note that the individual reels have a finite number of devices depending on the type of product contained in the tape. Also note the minimum lot size is one full reel for each line item, and orders are required to be in increments of the single reel quantity. SOD-123 / SC-76 / SOD-523 / SOD-723 8 mm SOT-323 / TO-236 / SOT-523 8 mm E T EMBOSSED TAPE AND REEL ORDERING INFORMATION M E Tape Width (mm) Package TO-236 SOT-323 8 8 SOD-123 SC-76 8 8 SOD-523 SOT-523 8 8 SOD-723 8 8 SOT-363 8 S Pitch mm (inch) 4 ± 0.1 ( 0.157 ± 0.004 ) 4 ± 0.1 ( 0.157 ± 0.004 ) 4 ± 0.1 ( 0.157 ± 0.004 ) 4 ± 0.1 4 ± 0.1 H C SOT-363 T1 ORIENTATION 8 mm Reel Size Direction of feed Devices Per Reel and Minimum Order Quantity mm (inch) 178 330 (7) (13) 3,000 10,000 178 330 (7) (13) 3,000 10,000 178 330 (7) (13) 4,000 15,000 ( 0.157 ± 0.004 ) 178 330 (7) (13) 5,000 20,000 ( 0.157 ± 0.004 ) 178 330 (7) (13) 3,000 10,000 SEMTECH ELECTRONICS LTD. ® Dated:11/11/2013 Rev:02