c11209-110 kacc1211e

MPPC® module
C11209-110
Optical measurement modules for low-level
light detection
The C11209-110 is an optical measurement module capable of detecting low level light. It consists of an MPPC, a high-speed
amplifier circuit, a high-voltage circuit, and a temperature compensation circuit. Utilizing a small pixel pitch (10 μm) MPPC
allows high-speed measurement over a wide dynamic range, making the C11209-110 suitable for high-speed signal measurement such as distance measurement. The C11209-110 operate just by connecting it to an external single power supply (+5 V).
Features
Applications
High sensitivity in the short wavelength range
Rangefinders
High-speed response
Fluorescence measurement
Built-in temperature compensation circuit
Analytical instruments
Compact and lightweight
Structure
Parameter
Internal MPPC
Effective photosensitive area
Pixel pitch
Number of pixels
Symbol
-
Value
S12571-010C
1×1
10
10000
Unit
mm
μm
-
Absolute maximum ratings
Parameter
Supply voltage
Operating temperature
Storage temperature
Symbol
Vs
Topr
Tstg
Condition
Value
+6
-10 to +40
-20 to +50
No condensation
No condensation
Unit
V
°C
°C
Note: Exceeding the absolute maximum ratings even momentarily may cause a drop in product quality. Always be sure to use the
product within the absolute maximum ratings.
Electrical and optical characteristics (Typ. Ta=25 °C, λ=470 nm, unless otherwise noted)
Parameter
Spectral response range
Peak sensitivity wavelength
Temperature stability of
output voltage
Photoelectric sensitivity
Rise time
High band
Cutoff
frequency Low band
Noise equivalent power
Minimum detection limit
Saturation incident light level
Symbol
λ
λp
-
Condition
Ta=25 ± 10 °C
fc
NEP
-
-
Dark state
Dark state
Min.
Max.
-
Typ.
320 to 900
520
-
Unit
nm
nm
-
-
±5
%
2.1 × 106
-
2.6 × 106
500
40
10
3
20
3.2 × 106
-
V/W
ps
MHz
kHz
fW/Hz1/2
pW rms
-
100
-
nW
www.hamamatsu.com
1
MPPC module
C11209-110
Electrical characteristics
Parameter
Supply voltage
Current consumption*1
Symbol
Vs
Ic
Condition
Min.
4.75
-
Dark state
Typ.
5
35
Max.
5.25
70
Unit
V
mA
*1: If strong light exceeding the saturation light level enters the MPPC module, a power supply current of about 200 mA flows in the
module, so use an external power supply with a capacity of at least 300 mA.
Block diagram
High-speed amplifier
Analog output
MPPC
Temperature
sensor
Power supply
for MPPC
C11204-01
+5 V
KACCC0710EA
Connection example
Using the supplied power cable, connect the MPPC module to a power supply. You can monitor the output waveform by connecting the
MPPC module to an oscilloscope.
Oscilloscope
Analog signal
cable
Power cable
(accessory)
Light source
Photons
MPPC module
C11209-110
Power supply (+5 V)
Subject
KACCC0681EA
2
MPPC module
C11209-110
Measurement examples
Toggle output
5 mV
5 mV
Analog output
GND
GND
4 ns
1 ns
Photoelectric sensitivity vs. wavelengh
Linearity (typical example)
(Typ. Ta=25 °C)
3.0 × 106
(Ta=25 °C, λ=λp)
100
2.5 × 106
10-1
Output voltage (V)
Photoelectric sensitivity (V/W)
Ideal value
C11209-110
2.0 × 106
1.5 × 106
1.0 × 106
10-3
10-4
5.0 × 105
0
300
10-2
400
500
600
700
800
900
Wavelength (nm)
10-5
10-11
10-10
10-9
10-8
10-7
10-6
Incident light level (W)
KACCB0307EA
KACCB0310EA
3
MPPC module
C11209-110
Dimensional outline (unit: mm)
Photosensitive
area
Analog output
(MMCX connector)
1
15
9.5
Photosensitive
surface
1
22
38 ± 0.3
(4 ×) M2 Depth 2*
1.5
(4 ×) M2.6 depth 4
9.5
40 ± 0.3
8
Power connector
20.5
13
Tolerance unless otherwise noted: ±0.2
Weight: 34 g
45 ± 0.3
4
M6 Depth 5
Do not use screws longer than 2 mm to avoid
damage to the internal circuit.
KACCA0312EB
Accessories
∙ Power cable
∙ Instruction manual
Related information
www.hamamatsu.com/sp/ssd/doc_en.html
Precautions
∙ Notice
Information described in this material is current as of July 2014.
Product specifications are subject to change without prior notice due to improvements or other reasons. This document has been carefully prepared and the
information contained is believed to be accurate. In rare cases, however, there may be inaccuracies such as text errors. Before using these products, always
contact us for the delivery specification sheet to check the latest specifications.
Type numbers of products listed in the delivery specification sheets or supplied as samples may have a suffix "(X)" which means preliminary specifications or
a suffix "(Z)" which means developmental specifications.
The product warranty is valid for one year after delivery and is limited to product repair or replacement for defects discovered and reported to us within that
one year period. However, even if within the warranty period we accept absolutely no liability for any loss caused by natural disasters or improper product
use.
Copying or reprinting the contents described in this material in whole or in part is prohibited without our prior permission.
www.hamamatsu.com
HAMAMATSU PHOTONICS K.K., Solid State Division
1126-1 Ichino-cho, Higashi-ku, Hamamatsu City, 435-8558 Japan, Telephone: (81) 53-434-3311, Fax: (81) 53-434-5184
U.S.A.: Hamamatsu Corporation: 360 Foothill Road, Bridgewater, N.J. 08807, U.S.A., Telephone: (1) 908-231-0960, Fax: (1) 908-231-1218
Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49) 8152-375-0, Fax: (49) 8152-265-8
France: Hamamatsu Photonics France S.A.R.L.: 19, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: 33-(1) 69 53 71 00, Fax: 33-(1) 69 53 71 10
United Kingdom: Hamamatsu Photonics UK Limited: 2 Howard Court, 10 Tewin Road, Welwyn Garden City, Hertfordshire AL7 1BW, United Kingdom, Telephone: (44) 1707-294888, Fax: (44) 1707-325777
North Europe: Hamamatsu Photonics Norden AB: Torshamnsgatan 35 16440 Kista, Sweden, Telephone: (46) 8-509-031-00, Fax: (46) 8-509-031-01
Italy: Hamamatsu Photonics Italia S.r.l.: Strada della Moia, 1 int. 6, 20020 Arese (Milano), Italy, Telephone: (39) 02-93581733, Fax: (39) 02-93581741
China: Hamamatsu Photonics (China) Co., Ltd.: B1201, Jiaming Center, No.27 Dongsanhuan Beilu, Chaoyang District, Beijing 100020, China, Telephone: (86) 10-6586-6006, Fax: (86) 10-6586-2866
Cat. No. KACC1211E03 Jul. 2014 DN
4