Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles Series P Internationally Approved Rockers/Paddles General Specifications B Electrical Capacity Resistive Load: Motor Load: Lamp Load: Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Angle of Throw: Materials & Finishes Frame: Case/Base: Movable Contacts: Stationary Contacts: Terminals: Environmental Data Operating Temp Range: Humidity: Vibration: Shock: 10A @ 125V AC or 6A @ 250V AC 400W @ 125V AC 2A @ 125V AC for On-Off-On circuit & 3A @ 125V AC for other circuits 10 milliohms maximum 1,000 megohms minimum @ 500V DC 2,000V AC minimum between contacts for 1 minute minimum; 4,000V AC minimum between contacts & case for 1 minute minimum 50,000 operations minimum 25,000 operations minimum 25° Stainless steel Diallyl phthalate resin (UL94V-0) Silver alloy with silver plating Pure silver with silver plating Copper with silver plating –10°C through +85°C (+14°F through +185°F) 90 ~ 95% humidity for 96 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Tactiles Installation Soldering Time & Temp: Cleaning: Flammability Standards: UL94V-0 rated case/base UL: File No. E44145 - Recognized only when ordered with marking on switch. Add “/U” before dash in part number to order UL recognized switch. Add “/CUL” before dash in part number to order cULus recognized switch. All models recognized at 10A @ 125V AC & 6A @ 250V AC. CSA: File No. 023535_0_000 - Certified only when ordered with marking on switch. Add “/C” before dash in part number to order CSA certified switch. All models certified at 10A @ 125V AC & 6A @ 250V AC. VDE: License No. 119174 All models approved at 10A @ 125V AC & 6A @ 250V AC. Marking on switch is standard. All models meet EN 61058-1 standard. Supplement Accessories Indicators Touch Tilt Standards & Certifications Wave Soldering (Straight PC): See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. These devices are not process sealed. Hand clean locally using alcohol based solution. B114 www.nkk.com Toggles Series P Distinctive Characteristics B Pushbuttons Meets EN 61058-1 standard. Rockers Internationally Approved Rockers/Paddles Programmable Illuminated PB Contacts of special silver alloy resist arcing and guarantee stable electrical contact and long life. Stainless steel frame resists corrosion and increases environmental safety. Keylocks High insulating barriers increase isolation of circuits in double pole devices and provide added protection to contact points. Rotaries Case/base of heat resistant resin meets UL94V-0 flammability standard. Slides Prominent external insulating barriers increase insulation resistance and dielectric strength. Tactiles Clinching of the frame to the case well above the base and terminals provides 4,000V dielectric strength. Tilt Epoxy sealed terminals prevent entry of flux, solvents, and other contaminants. Supplement Accessories Indicators Touch Actual Size www.nkk.com B115 Series P TYPICAL SWITCH ORDERING EXAMPLE P20 B Pushbuttons Rockers Toggles Internationally Approved Rockers/Paddles 22 Y J Keylocks Programmable Illuminated PB Poles & Circuits C Terminals 11 SPST ON NONE OFF 12 SPDT ON NONE ON 13 SPDT ON OFF ON 21 DPST ON NONE OFF 22 DPDT ON NONE ON 23 DPDT ON OFF ON Paddle/Rocker Frames Frame for Small Caps Y Frame for Large Caps Solder Lug* P Straight PC Z .187” (4.75mm) Quick Connect Rocker/Paddle Caps Cap Colors For N Frame Rotaries N No Code Black D .365” (9.27mm) Wide Rocker B White E .365” (9.27mm) Wide Paddle C Red E Yellow For Y Frame Slides A J .595” (15.11mm) Wide Rocker F Green H .595” (15.11mm) Wide Paddle G Blue H Gray IMPORTANT: Tilt Tactiles VDE is marked on all models. Switches are supplied without UL, cULus & CSA marking unless specified. UL, cULus & CSA recognized only when ordered with marking on the switch. Specific models, ratings, & ordering instructions are noted on General Specifications page. * Wire harness & cable assemblies offered only in Americas Touch DESCRIPTION FOR TYPICAL ORDERING EXAMPLE Indicators P2022Y-JC .595” (15.11mm) Wide Red Rocker Frame for Large Caps Accessories DPDT ON-NONE-ON Circuit Supplement Solder Lug Terminals B116 www.nkk.com Series P Toggles Internationally Approved Rockers/Paddles POLES & CIRCUITS Throw & Schematics Down Center Up Down Center Up B Note: Terminal numbers are on the switch. Pole Model SP P2011 ON NONE OFF 1-1b OPEN OPEN SPST SP P2012 P2013 ON ON NONE OFF ON ON 1-1b OPEN 1-1a SPDT DP P2021 ON NONE OFF 1-1b 2-2b OPEN OPEN DPST DP P2022 P2023 ON ON NONE OFF ON ON 1-1b 2-2b OPEN 1-1a 2-2a DPDT 1 (COM) 1b 1a 1b (COM) 2 1b 1 1a Programmable Illuminated PB 1 (COM) 1 2b (COM) 2 2a 2b Keylocks 1b ROCKER/PADDLE FRAMES Frame for Small Actuator Y Frame for Large Actuator Using AT4148 & AT4149 Rotaries N Rockers Connected Terminals Pushbuttons Rocker Position Using AT4156 & AT4157 (3.2) Dia Typ .126 Slides (3.2) Dia Typ .126 (17.8) .701 (41.3) 1.626 (10.1) .398 (34.9) 1.374 (3.5) Dia Typ .138 (28.5) 1.122 (34.9) 1.374 (3.5) Dia Typ .138 (16.0) .630 (12.8) .504 Tilt (12.8) .504 (13.5) .531 (34.9) 1.374 (41.3) 1.626 Tactiles (34.9) 1.374 Maximum Panel Thickness: .126” (3.2mm) Maximum Panel Thickness: .126” (3.2mm) P Z Epoxy Seal .187” (4.75mm) Quick Connect (6.35) .250 (2.0) (4.5) .079 (2.6) .177 .102 (1.25) .049 Thk = (1.0) .039 (1.3) Dia .051 (9.0) .354 Indicators Solder Lug (4.75) .187 Thk = (0.8) .031 Straight PC Epoxy Seal (4.8) .189 1b (7.6) .299 (1.17) .046 Thk = (1.0) .039 SPST 1 2b 1b (7.62) Typ .300 (1.8) Dia Typ .071 SPDT (7.62) Typ .300 1 1a (1.8) Dia Typ .071 www.nkk.com DPST 2 1b 1 (10.16) .400 (7.62) Typ .300 (1.8) Dia Typ .071 DPDT 2b 1b 2 1 2a (7.62) Typ .300 1a (10.16) .400 (1.8) Dia Typ .071 B117 Accessories No Code Touch TERMINALS Supplement (6.0) .236 Series P Toggles Internationally Approved Rockers/Paddles ROCKER/PADDLE CAPS B D AT4148 .365” (9.27mm) Wide Rocker (2.13) .084 (9.27) .365 (16.87) .664 (13.49) .531 (3.96) .156 (8.43) R .332 (18.8) .740 (8.8) .346 (7.9) (6.15) .311 .242 (3.5) .138 (16.8) .661 For Y Frame J AT4156 .595” (15.11mm) Wide Rocker (26.78) 1.054 (15.11) .595 (2.36) .093 (7.3) .287 Rotaries (3.5) .138 A Black B (13.5) R .531 (11.0) .433 (6.6) (10.11) .260 .398 Cap Colors Available: (4.75) .187 (29.82) 1.174 (23.01) .906 C White (15.11) .595 Red Material: Polyamide E Yellow F Green G (3.5) .138 (26.8) 1.055 Blue H Gray Finish: Matte Slides TYPICAL SWITCH DIMENSIONS Tactiles N Frame (12.3) .484 (12.8) .504 (0.6) .024 (3.2) Dia Typ .126 (1.25) x (2.0) Typ .049 x .079 (1.0) Typ .039 1b (0.8) .031 (34.9) 1.374 (41.3) 1.626 25° (7.62) .300 (20.5) .807 1 Tilt 1a (9.65) .380 (3.5) .138 (22.0) .866 (0.5) .020 (5.0) .197 (11.0) .433 (2.6) .102 P2012N-DC P2011 & P2021 models do not have terminals 1a & 2a. (14.5) .571 (3.2) Dia Typ .126 (0.6) .024 (1.25) x (2.0) Typ .049 x .079 (2.6) Typ .102 (1.0) Typ .039 (0.8) .031 (34.9) 1.374 25° (41.3) 1.626 Accessories Indicators Touch (9.27) .365 (13.5) .531 Y Frame (7.62) .300 2b 1b 2 1 2a (20.5) .807 1a (0.5) .020 Supplement (12.8) .504 (15.11) .595 (10.1) .398 P2022Y-JC B118 (3.5) .138 AT4157 .595” (15.11mm) Wide Paddle H (14.33) .564 Keylocks Programmable Illuminated PB AT4149 .365” (9.27mm) Wide Paddle E (9.27) .365 Pushbuttons Rockers For N Frame (3.5) .138 (21.7) .854 (5.0) .197 (10.16) .400 (20.0) .787 P2011 & P2021 models do not have terminals 1a & 2a. www.nkk.com