Internationally Approved Rockers/Paddles Series P Distinctive Characteristics International certifications from UL, CSA, VDE, SEMKO, and SEV. Contacts of special silver alloy resist arcing and guarantee stable electrical contact and long life. Stainless steel frame resists corrosion and increases environmental safety. High insulating barriers increase isolation of circuits in double pole devices and provide added protection to contact points. Case/base of heat resistant resin meets UL94V-0 flammability standard. Prominent external insulating barriers increase insulation resistance and dielectric strength. Clinching of the frame to the case well above the base and terminals provides 4,000V dielectric strength. Epoxy sealed terminals prevent entry of flux, solvents, and other contaminants. Actual Size NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles Series P General Specifications Electrical Capacity Resistive Load: Motor Load: Lamp Load: Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Angle of Throw: Materials & Finishes Frame: Case/Base: Movable Contacts: Stationary Contacts: Terminals: Environmental Data Operating Temp Range: Humidity: Vibration: Shock: 10A @ 125V AC or 6A @ 250V AC 400W @ 125V AC 2A @ 125V AC for On-Off-On circuit & 3A @ 125V AC for other circuits 10 milliohms maximum 1,000 megohms minimum @ 500V DC 2,000V AC minimum between contacts for 1 minute minimum; 4,000V AC minimum between contacts & case for 1 minute minimum 50,000 operations minimum 25,000 operations minimum 25° Stainless steel Diallyl phthalate resin (UL94V-0) Silver alloy with silver plating Pure silver with silver plating Copper with silver plating –10°C through +85°C (+14°F through +185°F) 90 ~ 95% humidity for 96 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Installation Soldering Time & Temp: Standards & Certifications Flammability Standards: UL Recognized: C-UL Recognized: R CSA Certified: V D E Wave Soldering (Straight PC): See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. UL94V-0 rated case/base All models recognized at 10A @ 125V AC & 6A @ 250V AC; UL File No. WOYR2.E44145. All models recognized at 10A @ 125V AC & 6A @ 250V AC; C-UL File No. WOYR8.E44145. Single pole models certified at 10A @ 125V AC & 6A @ 250V AC; CSA File No. 023535-0-000. VDE Approved: All models approved at 10A @ 125V AC & 6A @ 250V AC; VDE License No. 119174. Marking on switch is standard. SEMKO Approved: P2011Y, P2012Y, P2013Y, P2021Y, P2022Y models approved at 10A @ 125V AC & 6A @ 125/250V AC; Reference No. 9915205/01-02. Marking on switch is standard. SEV Approved: All models with quick connect terminals approved at 10A @ 125V AC & 6A @ 250V AC; (P2013 only for micro-switch off); Authorization No. 02.0466. Marking on switch is standard. NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Series P Internationally Approved Rockers/Paddles TYPICAL SWITCH ORDERING EXAMPLE P20 22 Y J POLES & CIRCUITS TERMINALS 11 SPST ON NONE OFF 12 SPDT ON NONE ON 13 SPDT ON OFF ON 21 DPST ON NONE OFF 22 DPDT ON NONE ON 23 DPDT ON OFF ON PADDLE/ROCKER FRAMES N Frame for Small Caps Y Frame for Large Caps C No Code Solder Lug P Straight PC Z .187” (4.75mm) Quick Connect CAP COLORS ROCKER/PADDLE CAPS For N Frame A Black D .365” (9.27mm) Wide Rocker B White E .365” (9.27mm) Wide Paddle C Red E Yellow For Y Frame J .595” (15.11mm) Wide Rocker F Green H .595” (15.11mm) Wide Paddle G Blue H Gray IMPORTANT: VDE, SEMKO & SEV are marked on approved models. Switches are supplied without UL, C-UL & CSA marking unless specified. Specific models & ratings noted on General Specifications page. DESCRIPTION FOR TYPICAL ORDERING EXAMPLE P2022Y-JC .595” (15.11mm) Wide Red Rocker DPDT ON-NONE-ON Circuit Frame for Large Caps Solder Lug Terminals NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Series P Internationally Approved Rockers/Paddles POLES & CIRCUITS Rocker Position Connected Terminals Throw & Schematics Down Center Up Down Center Up Note: Pole Model SP P2011 ON NONE OFF 1-1b OPEN OPEN SPST SP P2012 P2013 ON ON NONE OFF ON ON 1-1b OPEN 1-1a SPDT DP P2021 ON NONE OFF 1-1b 2-2b OPEN OPEN DPST DP P2022 P2023 ON ON NONE OFF ON ON 1-1b 2-2b OPEN 1-1a 2-2a DPDT Terminal numbers are on the switch. 1 (COM) 1b 1 (COM) 1a 1 1b (COM) 2 1b 1 1a 2b (COM) 1b 2 2a 2b ROCKER/PADDLE FRAMES N Frame for Small Actuator Y Frame for Large Actuator Using AT4148 & AT4149 Using AT4148 & AT4149 (3.2) Dia Typ .126 (3.2) Dia Typ .126 (34.9) 1.374 (6.0) .236 (17.8) .701 (41.3) 1.626 (10.1) .398 (12.8) .504 (13.5) .531 (34.9) 1.374 (41.3) 1.626 (34.9) 1.374 (3.5) Dia Typ .138 (28.5) 1.122 (34.9) 1.374 Maximum Panel Thickness: .126” (3.2mm) (3.5) Dia Typ .138 (16.0) .630 (12.8) .504 Maximum Panel Thickness: .126” (3.2mm) TERMINALS No Code Z Solder Lug .187” (4.75mm) Quick Connect Epoxy Seal (6.35) .250 (2.0) (4.5) .079 .177 (1.25) .049 Thk = (1.0) .039 (2.6) .102 Epoxy Seal P Straight PC (4.8) .189 (7.6) .299 (1.17) .046 Thk = (1.0) .039 (1.3) Dia .051 1b SPST 1 1b (7.62) Typ .300 (1.8) Dia Typ .071 SPDT 1 (7.62) Typ .300 1a (1.8) Dia Typ .071 DPST 2b 1b 2 1 (10.16) .400 (7.62) Typ .300 (1.8) Dia Typ .071 (9.0) .354 (4.75) .187 Thk = (0.8) .031 DPDT 2b 1b 2 1 2a (7.62) Typ .300 1a (10.16) .400 NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com (1.8) Dia Typ .071 03-07 Series P Internationally Approved Rockers/Paddles ROCKER/PADDLE CAPS For N Frame D AT4148 .365” (9.27mm) Wide Rocker AT4149 .365” (9.27mm) Wide Paddle E (2.13) .084 (9.27) .365 (16.87) .664 (13.49) .531 (9.27) .365 (8.8) .346 (7.9) (6.15) .311 .242 (3.96) .156 (8.43) R .332 (18.8) .740 (3.5) .138 (16.8) .661 For Y Frame J AT4156 .595” (15.11mm) Wide Rocker AT4157 .595” (15.11mm) Wide Paddle H (2.36) .093 (14.33) .564 (26.78) 1.054 (15.11) .595 (7.3) .287 (3.5) .138 A Black B White (13.5) R .531 (11.0) .433 (6.6) (10.11) .260 .398 Cap Colors Available: (4.75) .187 (29.82) 1.174 (23.01) .906 (3.5) .138 C (15.11) .595 Red Material: Polyamide E Yellow F Green G (3.5) .138 (26.8) 1.055 Blue H Gray Finish: Matte TYPICAL SWITCH DIMENSIONS N Frame (12.8) .504 (12.3) .484 (0.6) .024 (3.2) Dia Typ .126 (1.25) x (2.0) Typ .049 x .079 (1.0) Typ .039 1b (0.8) .031 (34.9) 1.374 (41.3) 1.626 25° (20.5) .807 1 (7.62) .300 1a (9.27) .365 (13.5) .531 (9.65) .380 P2012N-DC (3.5) .138 (22.0) .866 (0.5) .020 (5.0) .197 (11.0) .433 (2.6) .102 P2011 & P2021 models do not have terminals 1a & 2a. Y Frame (3.2) Dia Typ .126 (14.5) .571 (0.6) .024 (1.25) x (2.0) Typ .049 x .079 (2.6) Typ .102 (1.0) Typ .039 (0.8) .031 (34.9) 1.374 25° (41.3) 1.626 (7.62) .300 2b 1b 2 1 2a (20.5) .807 1a (0.5) .020 (12.8) .504 (15.11) .595 P2022Y-JC (10.1) .398 (3.5) .138 (21.7) .854 (5.0) .197 (10.16) .400 (20.0) .787 P2011 & P2021 models do not have terminals 1a & 2a. NKK Switches • email: [email protected] • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07