Quick manual

PICO880 Series Quick Installation Guide
Quick Start
 CPU Board x1
 USB Cable x1
 SATA Cable x1
 SATA Power Cable x1
 Fan Cable x1
Note: When powering on PICO880 for the first time, video device must be
plugged into DisplayPort (DP). Then, after first power on, you can set
VGA on AX93275 or HDMI on AX93276 as primary IGFX boot display
from BIOS setting.
The basic procedures required to power on PICO880:
(1). Require at least 60W DC power adapter. Make sure that all
necessary peripheral devices are plugged properly.
(2). Check the jumper settings and make sure they are at default
settings; especially JP2 (open).
(3). To ensure normal functioning, DDR3L memory module must be
installed into connector SDIMM1 until fully seated.
Note: It must be DDR3L memory module.
(4). Firmly insert the DC adapter into CN11 and power on PICO880
by inserting power plug.
4
9418H880020E
©Copyright 2015 Axiomtek Co., Ltd.
Version A2 August 2015
Printed in Taiwan
 Product Information CD x1
 Quick Installation Guide x1
 Heatspreader x1
 Heatsink w/Fan x1
Note: Please contact your local vendors if any damaged or missing items. DO
NOT apply power to the board if there is any damaged component.
Note: Please refer to the PICO880 series product information CD for the
complete user’s manual, drivers and utilities. User’s manual and related
documents are in Acrobat PDF format.
Connectors
Connector
Description
CN1
CN2
CN4
CN5
CN6
CN7
CN8 (Optional)
CN9
CN10
CN11
CN12
CN13
LAN1
BAT1
SATA1
SCN1
SDIMM1
High Speed Board to Board Connector 1
High Speed Board to Board Connector 2
Fan Power Connector
Serial ATA Power Connector
SMBus Connector
Inverter Connector
DC Power Connector
USB 2.0 Wafer Connector
DisplayPort Connector
DC Power Jack w/ Screw
LVDS Connector
Power LED Header
LAN Port
CMOS Battery Connector
Serial ATA Connector
PCI-Express Mini Card Connector
DDR3L SO-DIMM Connector
9418H880020E
©Copyright 2015 Axiomtek Co., Ltd.
Version A2 August 2015
Printed in Taiwan
1
PICO880 4th/5th Generation Intel® CoreTM i7/i5/i3 and Celeron® Processor Pico-ITX
B
d
Checklist
Jumper Settings
Before applying power to the PICO880, please make sure all
of the jumpers are in factory default positions.
Jumper
JP1
JP2
JP3 (Optional)
JP4
JP5
Description
Setting
Restore BIOS Optimal Defaults
Default: Normal Operation
Auto Power On
Default: Enable
LVDS +12 Voltage Selection
Default: +12V
LVDS Brightness Control Mode Setting
Default: PWM Mode
LVDS +3.3V/+5V Voltage Selection
Default: +3.3V
1-2 Close
1-2 Open
1-2 Close
1-2 Close
1-2 Close
Board Layout
Bottom View
Top View
Side View
Side View
2
9418H880020E
©Copyright 2015 Axiomtek Co., Ltd.
Version A2 August 2015
Printed in Taiwan
9418H880020E
©Copyright 2015 Axiomtek Co., Ltd.
Version A2 August 2015
Printed in Taiwan
3