Operation Manual

AS1359 - Demo Board Manual
Low Dropout Regulator
Demo Board Manual
AS1359
300mA, Ultra-Low-Noise, High-PSRR Low
Dropout Regulators
www.austriamicrosystems.com/LDO/AS1359
www.austriamicrosystems.com
Revision 1.00
1-4
AS1359 - Demo Board Manual
Low Dropout Regulator
General Description
Board Description
F
D
A
J
E
C
H
F
B
K
Figure 1: Board Description - Connectors
G I
Figure 2: Board Description ā€“ Measurement Points
Connector Description
Label
Name
Description
A
B
C
D
VIN
GND
SHDN
VOUT
Supply Voltage
Ground
Shutdown
Output Voltage
Info
Supply voltage ranging from 2.0V to 5.5V
Pull this pin low to disable the LDO
Output voltage ranging from 1.5V to 4.5V
Measurement Point Description
Label
Name
Description
Info
E
F
G
H
I
J
VIN
GND
SHDN
VOUT
BP
Load
Supply Voltage
Ground
External Inductor
Output Voltage
Bypass
Measurement Points
Jumper for resistive load
ON: The AS1359 is enabled
SHDN
K
OFF: The AS1359 is disabled
Shutdown
No Jumper: Connect a valid enable signal
via external connector ā€œCā€.
Getting Started
The AS1359 Demoboard is designed to work with the AS1359 fixed output voltage version. The Demoboard can
also be used with the AS1358. The difference between AS1358 and AS1359 is the output current.
AS1358: IOUT = 150mA
AS1359: IOUT = 300mA
Bill of Materials
Ref.
Function
CIN
Input Capacitor
COUT
CBP
U1
Description
Manufacturer
1µF
1206 / X7R / 16V
diverse
Output Capacitor
1uF
1206 / X7R / 16V
diverse
Bypass Capacitor
10nF
0805 / X7R / 6.3V
diverse
LDO
ASxx
TSOT23 5-pin
Austriamicrosystems AG
www.austriamicrosystems.com
Value
Revision 1.00
Mfg. Order Nr.
AS1359-BTTT-xx
2-4
AS1359 - Demo Board Manual
Low Dropout Regulator
Layout of Demo Board
Board schematics and layout
Figure 3: Schematics
Figure 4: Top + Bottom Layer
www.austriamicrosystems.com
Revision 1.00
3-4
AS1359 - Demo Board Manual
Low Dropout Regulator
Copyright
Copyright © 1997-2010, austriamicrosystems AG, Tobelbaderstraße 30, 8141 Unterpremstätten - Graz, Austria Europe. Trademarks Registered ®. All rights reserved. The material herein may not be reproduced, adapted,
merged, translated, stored, or used without the prior written consent of the copyright owner.
All products and companies mentioned are trademarks or registered trademarks of their respective companies.
Disclaimer
Devices sold by austriamicrosystems AG are covered by the warranty and patent indemnification provisions
appearing in its Term of Sale. austriamicrosystems AG makes no warranty, express, statutory, implied, or by
description regarding the information set forth herein or regarding the freedom of the described devices from
patent infringement. Austriamicrosystems AG reserves the right to change specifications and prices at any time
and without notice. Therefore, prior to designing this product into a system, it is necessary to check with
austriamicrosystems AG for current information.
This product is intended for use in normal commercial applications. Applications requiring extended temperature
range, unusual environmental requirements, or high reliability applications, such as military, medical life-support
or life-sustaining equipment are specifically not recommended without additional processing by
austriamicrosystems AG for each application. For shipments of less than 100 parts the manufacturing flow might
show deviations from the standard production flow, such as test flow or test location.
The information furnished here by austriamicrosystems AG is believed to be correct and accurate. However,
austriamicrosystems AG shall not be liable to recipient or any third party for any damages, including but not
limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect,
special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing,
performance or use of the technical data herein. No obligation or liability to recipient or any third party shall arise
or flow out of austriamicrosystems AG rendering of technical or other services.
Contact Information
Headquarters
austriamicrosystems AG
Tobelbaderstraße 30
A-8141 Unterpremstätten - Graz, Austria
T. +43 (0) 3136 500 0
F. +43 (0) 3136 5692
For Sales Offices, Distributors and Representatives, please visit:
http://www.austriamicrosystems.com/contact
www.austriamicrosystems.com
Revision 1.00
4-4