MN101EF35D MN101EF35D Type Internal ROM type FLASH ROM (byte) 64K+4K RAM (byte) 4K Package (Lead-free) Minimum Instruction Execution Time TQFP048-P-0707B (Under development) 0.042 µs (at 3.0 V to 3.6 V, 24 MHz) 62.5 µs (at 3.0 V to 3.6 V, 32 kHz) Interrupts RESET, Watchdog, External 0 to 4, External 5 (key interrupt dedicated), External 6, Timer 0 to 4, Timer 6, Timer 7 (2 systems), Timer 8 (2 systems), Timer 9 (2 systems), Time base, Serial 1 (2 systems), Serial 2 (2 systems), Serial 4 (2 systems), A/D conversion finish, USB interrupts Timer Counter Timer counter 0 : 8-bit × 1 (square-wave output, PWM output, event count, simple pulse width measurement) (square-wave/PWM output to large current terminal P03 (TM0IOB) possible) Clock source................ 1/2, 1/4 of system clock frequency; 1/1, 1/4, 1/16, 1/32, 1/64 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency; external clock input Interrupt source ........... coincidence with compare register 0 Timer counter 1 : 8-bit × 1 (square-wave output, event count, serial transfer clock) Clock source................ 1/2, 1/8 of system clock frequency; 1/1, 1/4, 1/16, 1/64, 1/128 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency; external clock input Interrupt source ........... coincidence with compare register 1 Timer counter 0, 1 can be cascade-connected. Timer counter 2 : 8-bit × 1 (square-wave output, PWM output, event count, simple pulse width measurement, serial transfer clock) (square-wave/PWM output to large current terminal P03 (TM2IOB) possible) Clock source................ 1/2, 1/4 of system clock frequency; 1/1, 1/4, 1/16, 1/32, 1/64 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency; external clock input Interrupt source ........... coincidence with compare register 2 Timer counter 3 : 8-bit × 1 (square-wave output, event count) Clock source................ 1/2, 1/8 of system clock frequency; 1/1, 1/4, 1/16, 1/64, 1/128 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency; external clock input Interrupt source ........... coincidence with compare register 3 Timer counter 2, 3 can be cascade-connected. Timer counter 4 : 8-bit × 1 (square-wave output, PWM output, event count, simple pulse width measurement) Clock source................ 1/2, 1/8 of system clock frequency; 1/1, 1/4, 1/16, 1/64, 1/128 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency; external clock input Interrupt source ........... coincidence with compare register 4 Timer counter 6 : 8-bit freerun timer Clock source................ 1/1 of system clock frequency; 1/1, 1/128, 1/8192 of OSC oscillation clock frequency; 1/1, 1/128, 1/8192 of XI oscillation clock frequency Interrupt source ........... coincidence with compare register 6 Timer counter 7 : 16-bit × 1 (square-wave output, PWM output (cycle / duty continuous variable), event count, pulse width measurement, input capture) (square-wave/PWM output to large current terminal P00 (TM7IOB) possible) Clock source................ 1/1, 1/2, 1/4, 1/16 of system clock frequency; 1/1, 1/2, 1/4, 1/16 of OSC oscillation clock frequency; 1/1, 1/2, 1/4, 1/16 of external clock input frequency Interrupt source ........... coincidence with compare register 7 (2 lines), input capture register MAD00061AEM MN101EF35D Timer counter 8 : 16 bit × 1 (square-wave output, PWM output (cycle / duty continuous variable), event count, pulse width measurement, input capture) (square-wave/PWM output to large current terminal P01 (TM8IOB) possible) Clock source................ 1/1, 1/2, 1/4, 1/16 of system clock frequency; 1/1, 1/2, 1/4, 1/16 of OSC oscillation clock frequency; 1/1, 1/2, 1/4, 1/16 of external clock input frequency Interrupt source ........... coincidence with compare register 8 (2 lines), input capture register Timer counter 9 : 16 bit × 1 (square-wave output, PWM output (cycle / duty continuous variable), event count, pulse width measurement, input capture) Clock source................ 1/1, 1/2, 1/4, 1/16 of system clock frequency; 1/1, 1/2, 1/4, 1/16 of OSC oscillation clock frequency; 1/1, 1/2, 1/4, 1/16 of external clock input frequency Interrupt source ........... coincidence with compare register 8 (2 lines), input capture register Time base timer (one-minute count setting) Clock source................ 1/1 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency Interrupt source ........... 1/128, 1/256, 1/512, 1/1024, 1/4096, 1/8192, 1/16384, 1/32768 of clock source frequency Watchdog timer Interrupt source ........... 1/65536, 1/262144, 1/1048576 of system clock frequency Serial interface Serial 1 : synchronous type/UART (full-duplex) × 1 Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 1 or 2; 1/2, 1/4, 1/16, 1/64 of OSC oscillation clock frequency, external clock Serial 2 : synchronous type/UART (full-duplex) × 1 Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 1 or 2; 1/2, 1/4, 1/16, 1/64 of OSC oscillation clock frequency, external clock Serial 4 : synchronous type/multi-master I²C × 1(applicable for 7-bit/10-bit address setting, general call) USB Functions Conforms to USB2.0. (Full-speed (12 Mbps) supported.) USB transceiver built-in 3 endpoints (FIFO built-in independently) FIFO size (EP0, 1, 2) : 16, 128, 128 bytes ・EP0 Control transfer IN/OUT (bi-direction) ・EP1 to EP2 Interrupt/Bulk/Isochronous transfer supported. Settable to IN or OUT. Double Buffering function supported. When the MAXP size is set to a half or less of the MAXFIFO size for each EP, the Double Buffering function is made validated automatically. I/O Pins I/O 37 Common use , Specified pull-up resistor available, Input/output selectable (bit unit) A/D converter 10-bit × 8-ch. (with S/H) Special Ports USB ports (D+, D–), Buzzer output, remote control carrier signal output, high-current drive port, clock output ROM Correction Correcting address designation : up to 7 addresses possible MAD00061AEM Development tools In-circuit Emulator (Under development) P52, KEY2, SBT2B P54, NBUZZERA, KEY4, SBO2B, TXD2B 25 P51, KEY1, TM9IOB 28 P53, BUZZERA, KEY3, SBI2B, RXD2B P50, KEY0, TM1IOB 29 26 P63, TM3IOB 30 27 P65, SBI4A P66, SBO4A, SDA4A 33 P64, TM4IOB P67, SBT4A, SCL4A 34 31 P70, SBO2A, TXD2A 35 32 P71, SBI2A, RXD2A 36 Pin Assignment P72, SBT2A 37 24 CLKOUT, KEY5, P55 P75 38 23 KEY6, P56 D+ 39 22 KEY7, P57 D- 40 21 RMOUTC, TM0IOC, IRQ6, P10 PA0, AN0, TM0IOA, RMOUTA 41 20 IRQ4, P24 19 IRQ3, P23 18 IRQ2, P22 PA1, AN1, TM1IOA 42 PA2, AN2, TM2IOA 43 PA3, AN3, TM3IOA 44 17 ACZ1, IRQ1, P21 PA4, AN4, TM4IOA 45 16 ACZ0, IRQ0, P20 PA5, AN5, TM7IOA 46 15 RMOUTB, TM2IOB, TM0IOB, LED3, P03 PA6, AN6, TM8IOA 47 14 SBT1A, LED2, P02 PA7, AN7, TM9IOA 48 13 RXD1A, SBI1A, TM8IOB, LED1, P01 7 8 9 10 11 12 VDD5 VDD18 DMOD TXD1A, SBO1A, TM7IOB, LED0, P00 5 XO, P90 OSC2 4 XI, P91 6 3 VSS 2 MMOD NRST, P27 OSC1 1 Vref+ MN101EF35D TQFP048-P-0707B MAD00061AEM Request for your special attention and precautions in using the technical information and semiconductors described in this book (1) If any of the products or technical information described in this book is to be exported or provided to non-residents, the laws and regulations of the exporting country, especially, those with regard to security export control, must be observed. (2) The technical information described in this book is intended only to show the main characteristics and application circuit examples of the products, and no license is granted under any intellectual property right or other right owned by our company or any other company. Therefore, no responsibility is assumed by our company as to the infringement upon any such right owned by any other company which may arise as a result of the use of technical information described in this book. (3) The products described in this book are intended to be used for standard applications or general electronic equipment (such as office equipment, communications equipment, measuring instruments and household appliances). Consult our sales staff in advance for information on the following applications: – Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the products may directly jeopardize life or harm the human body. – Any applications other than the standard applications intended. (4) The products and product specifications described in this book are subject to change without notice for modification and/or improvement. At the final stage of your design, purchasing, or use of the products, therefore, ask for the most up-to-date Product Standards in advance to make sure that the latest specifications satisfy your requirements. (5) When designing your equipment, comply with the range of absolute maximum rating and the guaranteed operating conditions (operating power supply voltage and operating environment etc.). Especially, please be careful not to exceed the range of absolute maximum rating on the transient state, such as power-on, power-off and mode-switching. Otherwise, we will not be liable for any defect which may arise later in your equipment. Even when the products are used within the guaranteed values, take into the consideration of incidence of break down and failure mode, possible to occur to semiconductor products. Measures on the systems such as redundant design, arresting the spread of fire or preventing glitch are recommended in order to prevent physical injury, fire, social damages, for example, by using the products. (6) Comply with the instructions for use in order to prevent breakdown and characteristics change due to external factors (ESD, EOS, thermal stress and mechanical stress) at the time of handling, mounting or at customer's process. When using products for which damp-proof packing is required, satisfy the conditions, such as shelf life and the elapsed time since first opening the packages. (7) This book may be not reprinted or reproduced whether wholly or partially, without the prior written permission of Matsushita Electric Industrial Co., Ltd. Industrial Co., Ltd.