PBMPLS-RM Series DC/AC SINEWAVE INVER TER FEATURES • • • • • • 500W - 7000W True Sinewave Output Massive Overload Capability High Efficiency Toroidal TRX CCT Breaker/ Batt Isolator Switch Rack Mounting SPECIFICATIONS INPUT ALARMS & INDICATORS Input Voltage 12V, 24V, 48V, 96V, 120Vdc (Standard). 36V, 72Vdc, and others (Also available). Voltage range -20% to +45% of nominal. OUTPUT Output Voltage 240Vac ±4% (Standard) > 110Vac ±4% (Option) Output Frequency 50/60Hz ±0.1 Output waveform True sinewave < 4% THD. Power factor All conditions. Crest factor >4 Overload Capacity 300% 5 Seconds (all models) 120% 30 minutes (110% 12V models) Load start sensitivity 0-20W Efficiency 94% Typical PROTECTION Inverter Operation When inverter is switched on all 3 LEDS light up for one second for system check procedure Power Indicator Green LED. Flashes when in standby mode (no load connected). When load applied LED illuminates continuously Undervolts/Overvolts Red LED. In order to protect the battery the inverter will shutdown after 5 seconds if the battery voltage falls below its limit (Undervolts) LED remains continous or exceeds the maximum (Overvolts) LED will continue to flash. Over temperature Red LED, If the internal temperature exceeds safe operating limits for more than 5 secnds, the inverter will shut down in Over temp with this LED on continuously. Allow 5mins for the inverter to cool and reset the unit. Over load Red LED, if the load demands more current than the inverter can safely supply for more than 5 seconds, the inverter will shutdown in Overload and this LED will flash AC and DC isolation 3500V, via toroidal transformers Over-load protection Yes. OPTIONAL FEATURES Over-temperature protection Yes. CODE ADD OPTION TO THE END OF INVERTER PART NUMBER Short circuit protection Yes. Battery under and over voltage protection D Yes. RCD fitted in place of hardware junction box of AC output. G MIL spec conformal coating applied to final assembly. R Ruggedisation for high vibration environment. Battery Isolator The circuit breaker is designed for ease of operation and safety. If the inverter shuts down due to Overload, Undervolts or Overvolts, it can be reset by turning the Circuit Breaker OFF, waiting 10 seconds (or until LED goes out), then turning it on again K Automatic transfer switch 25Amp for 1000W to 1800W. KX Automatic transfer switch with ON delay timer and voltage sensing module. 40Amps for 2000W to 4000W and 65Amp for 5000W to 7000W models. V AC output voltage e.g. 100-120Vac. H Frequency 60Hz L "AC OK" alarm relay contact C Twin switched GPO (available only on 1000W to 5000W models). DC Twin switched RCD GPO (available only on 1000W to 5000W models). ENVIRONMENTAL Temperature range -10°C to 50°C Derate above 40°C by 10% Cooling Thermostatically controlled 2-speed fan. STANDARDS & APPROVALS Safety standards AS3100, AS3000 C-tick AS/NZS CISPR14, AS/NZS 1044 EMC standards EN61000-6-1, EN61000-6-3, AS2279, AS3000, AS3100 and EN55014 MECHANICAL AC connectors Screw terminal junction box. DC Connectors Heavy duty low loss battery leads. Dimensions 19", 3RU x 350mm – all models Weight See Selection Table www.powerbox.com.au - 1800 251 380 www.powerbox.co.nz - 0800 104 480 Doc. No. PBMPLS-RM Rev.E 11-03-16 PBMPLS-RM Series DC/AC SINEWAVE INVER TER SELECTION TABLE MODEL NUMBER DC INPUT INPUT RANGE CONTINOUS RATING ½ HOUR RATING SURGE 5 SEC WEIGHT PBMPLS-12U-RM 12Vdc 10-17V 500W 550W 1500W 7KG PBMPLS-12W-RM 12Vdc 10-17V 1000W 1150W 3000W 12KG PBMPLS-12V-RM 12Vdc 10-17V 1500W 1600W 4500W 16KG PBMPLS-12I-RM 12Vdc 10-17V 2000W 2200W 6000W 22KG PBMPLS-24X-RM 24Vdc 21-34V 600W 750W 2000W 7KG PBMPLS-24V-RM 24Vdc 21-34V 1200W 1600W 3600W 12KG PBMPLS-24I-RM 24Vdc 21-34V 1800W 2200W 5400W 16KG PBMPLS-24IA-RM 24Vdc 21-34V 2300W 2800W 7000W 22KG PBMPLS-24Z-RM 24Vdc 21-34V 3000W 3700W 9000W 24KG PBMPLS-48X-RM 48Vdc 42-68V 600W 750W 2000W 7KG PBMPLS-48V-RM 48Vdc 42-68V 1200W 1600W 3600W 12KG PBMPLS-48I-RM 48Vdc 42-68V 1800W 2200W 5400W 16KG PBMPLS-48IA-RM 48Vdc 42-68V 2500W 3000W 7500W 22KG PBMPLS-48Z-RM 48Vdc 42-68V 3500W 4100W 10500W 24KG PBMPLS-48ZC-RM 48Vdc 42-68V 5000W 6000W 15000W 30KG PBMPLS-96X-RM 96Vdc 77-140V 600W 750W 2000W 7KG PBMPLS-96V-RM 96Vdc 77-140V 1200W 1600W 3600W 12KG PBMPLS-96I-RM 96Vdc 77-140V 1800W 2200W 5400W 16KG PBMPLS-96IA-RM 96Vdc 77-140V 2500W 3000W 7500W 22KG PBMPLS-96Z-RM 96Vdc 77-140V 3500W 4100W 10500W 24KG PBMPLS-120X-RM 120Vdc 95-177V 600W 750W 2000W 7KG PBMPLS-120V-RM 120Vdc 95-177V 1200W 1600W 36000W 12KG PBMPLS-120I-RM 120Vdc 95-177V 1800W 2200W 5400W 16KG PBMPLS-120IA-RM 120Vdc 95-177V 2500W 3000W 7500W 22KG PBMPLS-120Z-RM 120Vdc 95-177V 3500W 4100W 10500W 24KG www.powerbox.com.au - 1800 251 380 www.powerbox.co.nz - 0800 104 480 Doc. No. PBMPLS-RM Rev.E 11-03-16