8PH SINGLE-PHASE FULL WAVE BRIDGE 8 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING mponent under the co n o iti n g co dicates re s, inc. This mark in derwriters Laboratorie n U f o program PRV/Leg Type No. 50V 8PH05 100V 200V 400V 600V 800V 1000V 8PH10 8PH20 8PH40 8PH60 8PH80 8PH100 ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unl es s Oth erw ise Spe ci fie d) Average Output Current. lo @65 C Tc (Fig.1) 8 Amp Max. Forward Voltage Drop, VF=1.0 V @ IF = 2.5 Amp Max.DC Reverse Current @ PRV, IR 10 A Max.DC Reverse Current @ PRV,and 100 OC, IR 300 A Max.Peak Surge Current, IFSM 300 Amp O (8.3ms) (Fig.2) Thermal Resistance , R0 j-c 5.8 o C/ W Ambient Operating Temperature Range,TA -55 to +150 o Storge TemperatureRange,TSTG -55 to +150 o C C Note 1:Derate Io by 20% for capacitive loads EDI reserves the right to change these specifications at any time without notice 8PH FIG.2 NON-REPETITIVE SURGE CURRENT FIG.1 CURRENT DERATING 1000 BRIDGE OUTPUT RES.-IND. LOADS 10 500 Derate current by 20% for capacitive loads 65 8 O TC HEAT SINK MOUNTING 65 6 O TL PC BOARD MOUNTING WITH 3/8 LEADS 4 2 MAX.PEAK SURGE CURRENT IFSM lO.AVERAGE L FORWARD CURRENT(AMP) 12 200 100 0 50 20 10 0 25 75 50 100 125 150 1 5 2 10 20 50 100 NUMBER OF CYCLES AT 60 CPS O TEMPERATURE ( C) FIG.3 CASE STYLE FOR 8PH .160 .140 .700 .660 .760Max .935 .895 .185 .165 45 .085 .065 .455 .405 .075R.Typ. (2 Places) 1.0Min .280 .260 .205 .185 .260 .180 .220 .180 .052 .048 Dielectric test voltage 2,500 V rms.,max. 50-60Hz NOTE Maximum lead and terminal temperature for soldering, 3/8 inch from case, 5 seconds at 250 C. ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 Ee-mail:[email protected] *Wwebsite: http://www.edidiodes.com * FAX 914-965-5531 * 1-800-678-0828