Datasheet p i c o P a k P o t e n t i o m e t e r Tr a n s m i t t e r The picoPak ™ Potentiometer Transmitter is just 6mm wide and acts as a 2 wire (loop powered) interface for position sensing potentiometers. Features include: • mounts on 32mm and 35mm DIN rails • span and zero adjustments • open wiper detection • input compensated for temperature drift United States Canada Mexico Weidmuller Inc. Weidmuller Ltd. Weidmuller, S.A. de C.V. 821 Southlake Blvd. 10 Spy Court 5 Sur No. 4311 Richmond, Virginia 23236 Markham, Ontario L3R 5H6 Col. Huexotitla Telephone: (800) 849-9343 Telephone: (800) 268-4080 72534 Puebla, Pue. Mexico Facsimile: (804) 379-2593 Facsimile: (905) 475-2798 Telephone: (22) 37 2549 Email: [email protected] Email: [email protected] Facsimile: (22) 43 1981 Website: www.weidmuller.com Website: www.weidmuller.ca Email: [email protected] 4/13 picoPak Potentiometer Transmitter Rated Data Input Range Impedance Maximum ratings / type of protection Field device excitation Other input specification Output Range Load Burnout level Zero adjustment Span adjustment Protection Other output specification Supply Range Consumption General Accuracy / Linearity Temperature coefficient (drift) Transmission Frequency Response time, 90% span Other general specification Status LED Isolation (# of ports) Operating / Storage temperature Housing (mounting) Dimensions in mm (length x width x height) Wire range (conductor size) Tightening torque / insulation stripping length Approvals Ordering Data picoPakTM End plate (width) 2 3 wire potentiometer (slidewire position sensor) M minimum 0 -1000M Ω min. 500kΩ 1.2 volts, 1.2 mA max. noise susceptibility increases with higher impedance potentiometers DC current 4-20mA (0-100% of input) 0-500M or Rmax=(Vs-14)/0.02M 4mA (P+ opened), 20mA (P- opened), 23mA (opened wiper) minimal, for calibration purposes only minimal, for calibration purposes only DC voltage in output loop (2 wire) 19-32Vdc, 24Vdc nominal 23mA typical (open wiper error detection) 1% typical over temperature range -15°C to 55°C / -20°C to 70°C DK5 (TS32 and TS35) 78.0 x 6.0 x 60.5 22-12AWG (0.5-4.0mm2) 0.4Nm / 7mm Type DK5/POT-I AP (1.5mm) Cat.No. 990881 0000 C9039986 Subject to technical changes · Printed in Canada ·99990256 ·12/01 4/14