Contents Mains filter Mains filter Mains filter Mains filter E.2 E 2028840000 E.1 Mains filter Mains filter Mains filter WAVEFILTERS for simple radio interference suppression in the control cabinet The WAVEFILTER series eliminates the time consuming work of screwing in mains filters. These filters are simply clipped on to the TS35 rail and connected to the device requiring suppression. The two-stage WAVEFILTER with overall width 22.5 mm in 3 A, 6 A and 10 A versions offers high attenuation. The WAVEFILTER, with current-compensating choke, is ideal for applications in drive technology and control/automation systems, e.g. for suppressing continuous interference types such as “noise” or “ripple” caused by interfering radiation from other systems, or interference from frequency converters and switch-mode power supplies. A short, low ohm mass connection is required for the WAVEFILTER to function perfectly. We recommend earthing all devices directly with the largest possible cross-section to a central earthing point in the control cabinet. E Insertion loss WAVEFILTER 3 A dB 80 70 60 50 40 30 20 10 0 -10 Hz -20 10K 100K 1M 10M 100M 200M 50 Ohms insertion loss (CISPR 17) – Differential Mode (symmetrical) – Common Mode (asymmetrical) WAVEFILTER 6 A dB 80 70 60 50 40 30 20 10 0 -10 Hz -20 10K 100K 1M 10M 100M 200M 50 Ohms insertion loss (CISPR 17) – Differential Mode (symmetrical) – Common Mode (asymmetrical) WAVEFILTER 10 A dB 80 70 60 50 40 30 20 10 0 -10 Hz -20 10K 100K 1M 10M 100M 200M 50 Ohms insertion loss (CISPR 17) – Differential Mode (symmetrical) – Common Mode (asymmetrical) Interference signals We distinguish between two types of induced transient and continuous interference signals: symmetrical (differential mode) and asymmetrical (common mode). The symmetrical interference signals generate a voltage between the signal leads of the system. The asymmetrical interference voltages occur between the signal leads and earth. The WAVEFILTER is suitable for attenuating both kinds of interference signal. In addition, WAVEFILTER 10 A also has an earthing conductor choke. This earthing conductor choke supports both attenuation on the earthing conductor for the filter and additional attenuation of asymmetrical interference voltages. The WAVEFILTER has cULus approval. E.2 2028840000 Mains filter Mains filter Installation height 112.4 mm Installation height 92.4 mm E Dimensions Dimensions 72 73.4 69.2 92.4 112.4 38 22.2 92.4 90 2028840000 71 E.3 Mains filter Mains filter WAVEFILTER 3 A 250 V WAVEFILTER 6 A 250 V Mains filter • Clips to TS 35 • High symmetrical and asymmetrical attenuation • Suitable for voltages from 5 V to 250 V LOAD LINE L L' L Cx L' Cx N' N Cy LOAD LINE N Cy N' Cy Cy Technical data E Rated voltage Rated current Capacitance Inductance L and L1 Leakage current at Un Test voltage P/N-PE Test voltage P-N Ambient temperature (operational) Approvals Approvals Standards Dimensions Clamping range (nominal / min. / max.) Height x width x depth Note mm² mm 250 V 3A Cx / Cy: 33nF 2 mH 190 µA 2000 V AC 1700 V DC -20 °C...40 °C 250 V 6A Cx: 33 nF / Cy: 22 nF 0.8 mH 190 µA 2000 V AC 1700 V DC -20 °C...40 °C cURus; EAC cURus; EAC 2.5 / 0.5 / 2.5 73.4 / 22.5 / 73.4 2.5 / 0.5 / 2.5 73.4 / 22.5 / 73.4 See attenuation curve in the introductory text in Chapter E See attenuation curve in the introductory text in Chapter E Ordering data Type WAVEFILTER 3A Qty. 1 Order No. 8614780000 Type WAVEFILTER 6A Qty. 1 Order No. 8614800000 Note Accessories Note E.4 2028840000 Mains filter Mains filter WAVEFILTER 10 A 250 V Mains filter • Clips to TS 35 • High symmetrical and asymmetrical attenuation • Suitable for voltages from 5 V to 250 V LOAD LINE L' L Cx N N' Cy Cy Technical data Rated voltage Rated current Capacitance Inductance L and L1 Leakage current at Un Test voltage P/N-PE Test voltage P-N Ambient temperature (operational) Approvals Approvals Standards Dimensions Clamping range (nominal / min. / max.) Height x width x depth Note E 250 V 10 A Cx: 470 nF / Cy: 4.7 nF 0.8 mH 190 µA 2000 V AC 1700 V DC -20 °C...40 °C cURus; EAC mm² mm 2.5 / 0.5 / 2.5 73.4 / 22.5 / 73.4 See attenuation curve in the introductory text in Chapter E Ordering data Type WAVEFILTER 10A Qty. 1 Order No. 8614770000 Note Accessories Note 2028840000 E.5 Mains filter E E.6 2028840000