EXPLOSION HAZARD DO NOT DISCONNECT WHILE CIRCUIT IS LIVE UNLESS AREA IS KNOWN TO BE NON – HAZARDOUS This device complies with Part 15.247 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation + DC Load 1m minimum WEATHERPROOF CONNECTORS WITH “3M 23” TAPE COAXIAL CABLE ANT +24V DOT All I/O must be SELV. CAUTION! For continued protection against risk of fire, replace the module fuse only with the same type and rating MAST PROVIDE GOOD GROUND CONNECTION TO MAST, MODULE AND SURGE ARRESTOR RADIO TELEMETRY MODULE INPUTS - +AI 2 +AI 1 +24V DI 4 4 COM DI 1 SOL GND SUP1 SUP2 SOL GND IF GROUND CONDITION IS POOR INSTALL MORE THAN 1 STAKE SUP1 EARTH STAKE SUP2 INSTALL AERIAL ABOVE LOCAL OBSTRUCTIONS 3 - 2 1 DI 3 WI-I/O GND STRESS RELIEF LOOP WI-I/O 9-2 NOTES DI 2 SURGE ARRESTOR (OPTIONAL) AI 6+ OUTPUT 1. COLINEAR ANTENNA AI 5+ AI 4+ BAT+ 2A THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS 1 DIVISION 2 GROUPS ABC AND D OR NON HAZARDOUS LOCATIONS ONLY Aerial Installation Digital Output Max 30VDC, 500mA DC Relay Supply + - COM FCC Notice AI 3+ Installation Guide 11-15VDC Supply or Optional 12V Backup Battery to 12 Amphour for AC/DC to 100 Amphour for Solar COM WARNING! GND WI-I/O 9-2 ANTENNA INSTALLATION Antennas should be installed by experienced contractors. + - WI-I/O 9-2 Installation Power supply: (A) 12-24VAC 1.5 Amp CSA Certified Class 2 (B) 15-30VDC 1.5 Amp CSA Certified Class 2 (C) Supply battery or 11-15VDC (D) Solar panel with solar battery Choose option and wire as shown AC Supply 12-24VAC min 15VAC for Battery Charging. Do not earth SUP1 or SUP2 connections 12V Solar Panel Supply max 20VDC max 30W panel + - DC Supply 15-30VDC min 17VDC for Battery Charging Digital Input Voltage Free Contact OR Transistor Device Loop Powered Analog Transducer + Ext. Powered AnalogTransducer To Earth Connection Weidmuller Inc., v1.4