WARNING ! EXPLOSION HAZARD THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS 1 DIVISION 2 GROUPS ABC AND D OR NON HAZARDOUS LOCATIONS 1 WEATHERPROOF CONNECTORS WITH “3M 23” TAPE COAXIAL CABLE ANT +24V AO 8 AO 6 AO 7 AO 5 +24V DO 8 All I/O must be SELV. CAUTION! For continued protection against risk of fire, replace the module fuse only with the same type and rating MAST PROVIDE GOOD GROUND CONNECTION TO MAST, MODULE AND SURGE ARRESTOR RADIO TELEMETRY MODULE OUTPUTS +24V AO 4 AO 2 4 AO 1 COM DO 4 DO 1 SOL GND SUP1 SUP2 SOL GND IF GROUND CONDITION IS POOR INSTALL MORE THAN 1 STAKE SUP1 EARTH STAKE SUP2 INSTALL AERIAL ABOVE LOCAL OBSTRUCTIONS 3 AO 3 2 1 DO 3 WI-I/O GND STRESS RELIEF LOOP 4 WI-I/O 9-3 DO 2 SURGE ARRESTOR (OPTIONAL) 3 NOTES 1. COLINEAR ANTENNA DO 7 2 OUTPUTS Aerial Installation 1m minimum DO 6 DO 5 2A COM This device complies with Part 15.247 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation - + + - BAT+ FCC Notice DO NOT DISCONNECT WHILE CIRCUIT IS LIVE UNLESS AREA IS KNOWN TO BE NON HAZARDOUS COM Installation Guide Analog Output externally powered. Loop is earthed (not floating) 11-15VDC Supply or Optional 12V Backup Battery to 12 Amphour for AC/DC to 100 Amphour for Solar GND WI-I/O 9-3 ANTENNA INSTALLATION Antennas should be installed by experienced contractors. + - WI-I/O 9-3 Installation Power supply: (A) 12-24VAC 1.5 Amp CSA Certified Class 2 (B) 15-30VDC 1.5 Amp CSA Certified Class 2 (C) Supply battery or 11-15VDC (D) Solar panel with solar battery Choose option and wire as shown + - AC Supply 12-24VAC min 15VAC for Battery Charging. Do not earth SUP1 or SUP2 connections 12V Solar Panel Supply max 20VDC max 30W panel DC Supply 15-30VDC min 17VDC for Battery Charging Digital Output max 30VDC 500mA DC Relay Supply Analog Output Loop Powered. Loop is earthed (not floating) To Earth Connection Weidmuller Inc., v1.5