Signal converters ACT20P – Universal measurement converter High process reliability Thanks to the high level of galvanic isolation amounting to 4 kV (600 V rated voltage), secure operation is guaranteed. N9 Flexible supply The wide supply range from 24 V UC to 230 V UC opens up a diverse range of applications for the ACT20P Pro DCDC II. D Precise data recording Measurement data is converted and transmitted with an accuracy level of 0.05 %. Universal solution Due to the multitude of adjustable measurement ranges from ± 300 V DC or ± 100 mA DC, the input range can be deployed in an extremely broad spectrum of applications. D.20 2028820000 ACT20P – Universal measurement converter Universal DC isolation amplifier ACT20P-PRO DCDC II-S Signal converters • Universally configurable input and output for voltage/ current • A ctive or passive output • U niversal voltage supply 24..230 V AC/DC • 3 -way isolation • C onvenient configuration on the device with DIP switches or by means of clear-text display + buttons, without reference source. D Technical data Input Input voltage Input current Input resistance, current Input resistance, voltage Output Output voltage Output current load impedance voltage load impedance current Offset voltage Cut-off frequency (-3 dB) General data Galvanic isolation Accuracy Temperature coefficient Configuration Power consumption Step response time Supply voltage Insulation coordination Rated voltage Standards Insulation voltage Impulse withstand voltage Pollution degree Overvoltage category Dimensions Clamping range (nominal / min. / max.) Length x width x height Note configurable, ±20 mV…±300 V configurable, ± 0.1mA...± 100 mA < 5 mA: approx. 100 Ω; >5 mA: approx. 5 Ω approx. 1 MΩ adjustable, 0...±10 V adjustable, 0...±20 mA ≥ 1 kΩ ≤ 600 Ω < 10 mV > 10 kHz/ < 10 Hz 3-way isolator, between input ⁄ output ⁄ supply ⁄ relay < 0.05 % of measuring range ≤0,01% des Messbereichs⁄°C DIP switch, or via display and push-buttons ≤2.3 W ≤50 ms, ≤50 µs 24…230 V DC ±20 %, 24…230 V AC ±10 % @ 48…62 Hz 600 V EN 60079-0, EN 60079-15, EN 61010-1:2011, EN 61140, EN 613261, UL 61010-1, SN29500 for MTBF 4 kVeff, input ⁄ output ⁄ power supply 5 kV (1.2/50 µs) 2 II Screw connection 2.5 / 0.5 / 2.5 / 12.5 / 117.2 Ordering data Type ACT20P-PRO DCDC II-S Qty. 1 Order No. 1481970000 Note Accessories Note 2028820000 D.21