Magnetic Component Specification Specification Number SGE2675-1 Rev. B This Document describes and specifies the electrical and mechanical characteristics of SGE2675-1 high voltage transformer. This component should be designed and manufactured in accordance with Engineering Specification LES2608T-01 1. Electrical Characteristics Items L1-2 (uH) L2-3 (uH) L4-5 (mH) Inductance ( at 10Khz, 0.1V) Min Nom Max 60 60 85 112 85 112 428 Inductance ( at 100Khz, 1Vrms) LLKG1-2 ,LLKG2-3 18 19 20 LLKG1-2 /LLKG2-3 0.96 1 1.04 Secondary Self Capacitance C4-5(pF) 1.9 2.2 3 Dielectric Voltage Withstand Secondary to Core 60 Hz.,Arc-detect enabled, 5 sec. Primary to Core min., 200uA max. leakage current Primary to Secondary Operating Test V4-5 Primary driven with 80 kHz. sine wave source (pin 1-3), secondary measured with Tektronix P6015 (or equiv.).. D.C Resistance Items Min Rdc1-2(mΩ) Rdc2-3(mΩ) Rdc4-5(Ω) Nom Max 198 198 493 570 Should be shorted pin 4-5 Bifilaring HP4280A 1Mhz C meter, Floating mode 1500Vrms min. ( 1min. 60Hz) 750Vrms min. 750Vrms min. 1200Vrms min. 2. Winding Specifications Winding Sequence Wire Size & Type Number of Turns Winding Method Primary Pin 1 – 2 Pin 2-3 1S-2F 2S-3F 0.18φ, Single Insulation, 0.18φ, Single Insulation, 130°C 130°C 22 22 Bifilar Secondary Pin 4-5 4S-5F 0.03φ, Triple insulation, 130°C 1600 3. Physical Specification & Wiring Diagram Linfinity Microelectronics, Inc., 11861 Western Ave., Garden Grove, CA 92841 tel. (714) 898-8121