Photoelectric sensors FLDM 170C1011/S42 Copy counters dimension drawing 70 64 30 17 158 M16 x 0,75 Display and keypad 47° Laser beam Interface connector Main connector 68 35 23,5 6 M6 ø 6,4 170 13 12 general data photo measuring distance Sd 0 ... 90 mm optimum operating distance 70 mm counting rate < 3000000 copies/h object speed 5 m/sec object cycle distance > 1 mm sensitivity single sheet/edge thickness 0,1 mm sync. input yes measuring point visible red laser line 6 mm light source pulsed red laser diode wave length 670 nm laser class 2 edge indicator LED yellow power on indication LED green false pulse suppression 4 program options direct gap detection yes sensitivity adjustment 4 preset levels or level set by customer connection diagram (3) (1) electrical data 200mA 10 Ω polyfuse voltage supply range +Vs 10 ... 30 VDC current consumption max. (no load) 230 mA (2) output circuit opto isolated (6) output pulse length 0,3 ... 100 ms selectable short circuit protection yes reverse polarity protection yes interface serial for ScaDiag software +VS output output ground laser warning LASER RADIATION DO NOT STARE INTO BEAM Wavelength: 620...680nm Max. av. Output: < 1mW IEC 60825-1, Ed. 2, 2007 CLASS 2 LASER PRODUCT mechanical data width / diameter 30 mm type rectangular housing material die-cast zinc connector base (main connector) DIN 45322, 6 pin connector base (interface) DIN 45326, 8 pin front (optics) glass Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to laser notice No. 50, dated June 24, 2007 A software package called ScaDiag allows to control all functions and settings. ambient conditions operating temperature 0 ... +50 °C protection class IP 54 FLDM 170C1011/S42 Also the software allows to record and display measurement sequences speeding up troubleshooting. www.baumer.com 11/11/2015