INFINEON TLE4927C

Data Sheet Supplement
Version 1.1
Dynamic Differential Hall Effect Sensor
TLE4927C
For all parameters not specified in this document the TLE4925C data sheet is valid.
PG-SSO-3-9
Type
Marking
Ordering Code
Package
TLE4927C
27C
SP000373702
PG-SSO-3-9
Page 1 of 5
TLE4927C supplement
1.
Magnetic Characteristics in Running Mode
Minimum signal
∆Bmin
0.35
0.75
amplitude
Page 2 of 5
1.35
mT
TLE4927C supplement
S (N)
N (S)
Pin 3 (Q)
Pin 1 (Vs)
B2
B1
Branded Side
Crankshaft Wheel Profile
Small airgap
Magnetic Field Difference
∆B=B1-B2
∆BENOP
Large airgap
Hidden Adaptive
Hysteresis
∆BENRP
Output Signal
VQ
Enabling point for releasing output: B1-B2<∆BENRP. Next zero crossing switches the
output OFF (VQ=HIGH).
Enabling point for operate point: B1-B2>∆BENOP. Next zero crossing switches the
output ON (VQ=LOW).
∆BHYS=|∆BENOP-∆BENRP|
Outside of a permanent magnet the magnetic induction (=flux density)
points from north to the south pole. It is common to define positive flux
if the south pole of a magnet is on the branded side of the IC. This is equivalent to the
north pole of the magnet on the rear side of the IC.
Figure 1
System operation with hidden adaptive hysteresis
Page 3 of 5
TLE4927C supplement
2.
Typical Hysteresis Values
PGA
GainRange
Hysteresis (peak
to peak)
FullRange
=MaxSignal
Percentage
thresholds
X1
6
13.5 mT
±120mT
5,625%
X2
5
10.12 mT
±60mT
8.433%
X4
4
6.75 mT
±30mT
11.25%
X8
3
4.5 mT
±15mT
15%
X16
2
3 mT
±7,5mT
20%
X32
1
2 mT
±3,75mT
26.66%
X64
0
1.5mT
±1,875mT
40%
Page 4 of 5
TLE4927C supplement
Revision History:
December 2007
Version 1.1
Previous Version: 1.0
Page
1
Subjects (major changes since last revision)
Ordering code added
Infineon Technologies AG
© Infineon Technologies AIM SC
All Rights Reserved.
http://www.infineon.com/products/sensors
We Listen to Your Comments
Any information within this document that you feel is wrong, unclear or missing at all?
Your feedback will help us to continuously improve the quality of this document.
Please send your proposal (including a reference to this document) to:
[email protected]
Page 5 of 5