CYPRESS EZ-PDTM CCG1: USB Type-C Port Controller with Power Delivery Convert USB 3.1 Design Deliver 100 W of Power to New Type-C Connector and P R O D UC T O VE RVI E W F E AT U R E S INTRODUCTION: EZ-PDTM CCG1 is the industry’s first Type-C port controller, with an integrated Type-C • 32-Bit MCU subsystem: Transceiver, supporting USB Power Delivery (PD). Based on Cortex -M0 MCU with 32 KB flash, CCG1 enables users to convert their USB designs to Type-C connectivity. CCG1 - 48-MHz ARM® Cortex®-M0 MCU - 32 KB Flash and 4 KB SRAM can be used to implement Type-C Cables and USB PD application for power adapters, • Integrated analog blocks notebooks, monitors and docking stations. CCG1 integrates digital and analog building - 12 bit, 1-MSPS ADC to monitor VBUS - Dynamic overcurrent and overvoltage protection ® blocks required for Type-C transceiver and monitoring circuitry for voltage and currents. Available in 3 different packages (35-WLCSP 16-SOIC and 40-QFN) CCG1 caters to a wide range of applications. • Type-C support - Integrated transceiver to support two Type-C ports Display Port USB Micro-B - I2C/SPI/UART interface to system controller USB Type-A • Power 4.7 mm 1.8 mm 4.5 mm - Wide operating voltages: 1.71 V – 5.5 V - Low current: deep sleep – 1.3 uA, hibernate – 150 nA • Package 10.4 mm 2.4 mm 4.0 mm Power USB Type-C - Combines all in one USB Type-B USB Type-C is the new, slimmer, all-in-one 100-W connector KEY APPLICATIONS Cables, tablets, notebooks, adapters, chargers, monitors, docking stations, dongles cypress.com/ccg1 - 40-QFN, 35-WLCSP, 16-SOIC P R O D UC T O VE RVI E W BLOCK DIAGRA MS Programmable Analog Blocks CORTEX -M0 ® 48 MHZ Flash (32 KB) SRAM (4 KB) Serial Wire Debug Advanced High-Performance Bus (AHB) IDAC Data Lines (USB SuperSpeed, USB Hi-Speed, PCle1, Display Port2) 12 I/O Subsystem ADC Comparators Programmable Digital Blocks TCPWM1 SCB2 (I2C, SPI, UART) Profiles and Configurations VBUS3 Type-C Port 1 Programmable Interconnect and Routing MCU Subsystem CC4 VCONN5 CCG1 CYPD1103-35FNXIT Type-C Port 2 GND Peripheral Component Interconnect Express is an interface standard for connecting peripherals 1 A display interface standard developed by the Video Electronics Standards Association used primarily to connect a video source to a display such as a computer monitor 2 GPIOs Baseband MAC Baseband PHY The power wire of the USB bus 3 1 Timer, counter, pulse-width modulation block 4 2 Serial communication block configurable as UART, SPI or I2C 5 Configuration Channel USB Type-C bus wire used to power the IC in the EMCA CCG1: USB Type-C Port Controller with PD Type-C cable with CCG1 CCG1 PORTFOLIO Part Number Application Type-C Ports Overcurrent Protection Over voltage Protection Termination Resistor Role Package Si ID CYPD1103-35FNXIT Cable, EMCA 1 No No Ra Cable 35-WLCSP 0490 CYPD1121-40LQXI Monitor 1 Yes Yes RP , Rd DRP 40-QFN 0489 CYPD1122-40LQXI Notebook, 1 Yes Yes RP , Rd DRP 40-QFN 048A CYPD1131-35FNXIT Notebook, Tablet, Smartphone 1 Yes Yes RP , Rd DRP 35-WLCSP 0491 CYPD1132-16SXI Power Adapter 1 Yes Yes Rp DFP 16-SOIC 0498 CYPD1132-16SXQ Power Adapter 1 Yes Yes RP DFP 16-SOIC 0498 CYPD1134-40LQXI Notebook, Desktop 1 Yes Yes Rp DFP 40-QFN 048B GET TING STARTED For more information on CCG1 email us at [email protected] or visit www.cypress.com/ccg1 Cypress Semiconductor Corporation 198 Champion Court, San Jose CA 95134 phone +1 408.943.2600 toll free +1 800.858.1810 (U.S. only) © 2015 Cypress Semiconductor Corporation. All Rights Reserved. Cypress and Cypress logo are registered trademarks of Cypress Semiconductor Corp. ARM and Cortex are registered trademarks of ARM Limited. All other trademarks are the property of their respective owners. 001-95699 Rev*A