CYPRESS 128Mb to 512Mb KS-S (1.8-V) / KL-S (3.0-V) HyperFlash™ Memory P R O D UC T O VE RVI E W INTRODUCTION F E AT U R E S The Cypress HyperFlash NOR Flash Memory product family offers higher bandwidth than CLOCK RATE parallel NOR Flash Memory with one-third the number of pins. HyperFlash offers a 166-MHz 2 DDR mode providing a read bandwidth of up to 333-MBps. HyperFlash uses a small 48-mm 24-ball package, sharing a common footprint with Quad SPI and Dual-Quad SPI parts, to simplify board layout. On-chip ECC is included to ensure high system reliability. For systems requiring higher temperature ranges, an extended operating temperature range of -40°C to +125°C is offered. Cypress applies stringent testing and qualification processes to ensure all parts meet our world-class quality requirements, and offers AEC-Q100 qualification. • 166 MHz (KS-S) • 100 MHz (KL-S) READ BANDWIDTH • 333 MBps (KS-S) • 200 MBps (KL-S) ON-CHIP ECC • Single-bit Soft Error correction PROGRAM AND ERASE TIMES (TYP) HIGH READ BANDWIDTH • 475-µs Page Program (512 Bytes) • High read bandwidth is necessary to enable instant-on systems and quick execution of program code for execute in place (XIP) requirements • HyperFlash offers a 166-MHz DDR mode which provides a high read bandwidth of 333-MBps • 2.7-V to 3.6-V Supply Voltage (KL-S) • Industrial-plus: -40°C to +105°C signals at double data rate (DDR), delivering bandwidth of up to 333 MBps • Low-pin-count interfaces reduce the number of signal layers required on PCBs, reducing cost 2 • The HyperBus interface also enables a small 48-mm 24-ball package, which shares a common footprint with Quad SPI and Dual-Quad SPI products • HyperBus is supported by a wide ecosystem of host controllers and memory types HIGH RELIABILITY • On-chip ECC prevents single-bit soft error data corruption • An extended temperature range of -40°C to +125°C is offered • AEC-Q100-qualified parts and PPAP support available www.cypress.com/HyperFlash • 1.70-V to 1.95-V Supply Voltage (KS-S) • Industrial: -40°C to +85°C • HyperBus is a high-bandwidth, 12-signal interface that transfers information over 8 I/O SUPPLY VOLTAGE TEMPERATURE RANGES HYPERBUS™ INTERFACE • 930-ms 256KB Sector Erase • Extended: -40°C to +125°C AUTOMOTIVE SUPPORT • AEC-Q100 Qualification • PPAP Support PACKAGE • 24-ball BGA (6 mm x 8 mm) P R O D UC T O VE RVI E W TARGET APPLICATIONS Advanced driver assistance systems (ADAS) | Automotive instrument clusters and infotainment systems | Networking devices | Digital Cameras | Industrial applications DQ0 – DQ7 8 1.8-V 512Mb HyperFlash Memory Embedded Voltage Control CS# Hyper– Bus Array X Decoder CK CK# RWDS I/O Control Logic Y Decoder 26 256 RESET# Data Path INT# RSTO 1.8-V 512Mb HyperFlash Memory Block Diagram HYPERFL ASH MEMORY DEVICE PORTFOLIO MPN Density S26KS128S 128 Mbit S26KS256S 256 Mbit S26KS512S 512 Mbit S26KL128S 128 Mbit S26KL256S 256 Mbit S26KL512S 512 Mbit Voltage Speed (DDR) 1.8-V 166 MHz 3.0-V Package Temperature Range 24-ball BGA (6 mm x 8 mm) I = Industrial (–40°C to +85°C) V = Industrial-plus (–40°C to +105°C) N = Extended (–40°C to +125°C) 100 MHz GET STARTED NOW To learn more about HyperFlash Memory products, visit http://www.cypress.com/HyperFlash Cypress Semiconductor Corporation 198 Champion Court, San Jose CA 95134 phone +1 408.943.2600 fax +1 408.943.6848 toll free +1 800.858.1810 (U.S. only) Press “1” to reach your local sales representative © 2016 Cypress Semiconductor Corporation. All rights reserved. All other trademarks are the property of their respective owners. 002-11003 Rev**