ATMEL AT90SC12872RCFT

Features
General
• High-performance, Low-power secureAVR Core Enhanced RISC Architecture
•
•
•
•
•
•
•
– 137 Powerful Instructions (Most Executed in a Single Clock Cycle)
Bond Pad Locations Conforming to ISO 7816-2
ESD Protection to ± 6000V
Operating Ranges: from 2.7V to 5.5V
Compliant with ICAO specifications; EMV 2000 Specifications; PC Industry Compatible
Power-saving Wait and Very Low-power Stop Modes
Power-up Detection
Available in Wafers, Modules, Dual Interface Module, Contactless Module or Inlay and
Industry-standard Packages
Contactless Mode
Secure
Microcontroller
for Smart Cards
• Contactless Interface Controller (CIC) with Full Support for ISO/IEC 14443 Type A and
•
•
•
•
•
•
•
•
•
•
B Protocols
Supply Voltage Clamp and Regulation
Full-bridge Power Rectification
On-chip Tuning Capacitance: 10 pF up to 120 pF
3.4 MHz Internal Bus Maximum Frequency with a Clock Extracted From the External
Clock and 20 (AVR®) or 40 MHz (AdvX) if the Clock is Internally Generated
13.56 MHz Clock Extraction
3.4 MHz Internal Bus Frequency
Reader-to-card:
– ISO/IEC Type A: 100% ASK Modulation and Modified Miller Bit Coding
– ISO/IEC Type B: 10% ASK Modulation and NRZ Bit Coding
Card-to-reader:
– ISO/IEC Type A: Generation of 847.5Khz Subcarrier with OOK Modulation and
Manchester Bit Coding
– ISO/IEC Type B: Modulation of Incoming RF Carrier by Resistive Load Switching /
Generation of 847.5Khz Subcarrier with BPSK Modulation / NRZ Data Encoding
Baud Rates: Up to 424 kbps
RF Frame: Up to 256 Bytes
AT90SC
12872RCFT
Summary
Memory
• 128K Bytes of ROM Program Memory
• 72K Bytes of EEPROM, Including 128 OTP Bytes and 384-byte Bit-addressable Area
– 1 to 128-byte Program / Erase
– 2 ms Program / 2 ms Erase
– Typically More than 500,000 Write/Erase Cycles at Temperatures of 250C
– Minimum 10 Years Data Retention
• 5K Bytes of RAM + 256 Bytes of DMA Dedicated RAM
• 32K Bytes of ROM Dedicated to Atmel’s Crypto Library
Peripherals
• One ISO 7816 Controller
•
•
•
•
•
•
– Up to 625 kbps at 5 MHz
– Compliant with T= 0 and T= 1 Protocols
Two I/O Ports (Configurable to Support ISO7816-3, 2-wire protocols...)
Programmable Internal Oscillator (Up to 40 Mhz for AdvX and Up to 20 Mhz for Internal
CPU clock)
Three16-bit Timers (Watchdog capability)
Random Number Generator (RNG)
2-level, 8-vector Interrupt Controller
Hardware DES and Triple DES (DPA, SPA, DEMA Resistant)
6502AS–SMIC–05Apr05
Note: This is a summary document. A complete document will be
available under NDA. For more information, please contact your
local Atmel sales office.
• Checksum Accelerator
• CRC 16 & 32 Engine (Compliant with ISO/IEC 3309)
• 32-Bit AdvX Cryptographic Accelerator for Public Key Operations
– RSA, DSA, ECC, Diffie-Hellman
• DMA Controller (Used to Speed-Up Data Transfers when Communicating via the Contactless Interface)
Security
•
•
•
•
•
•
•
•
•
Dedicated Hardware for Protection Against SPA/DPA/DEMA Attacks
Advanced Protection Against Physical Attack, Including Active Shield
Environmental Protection Systems
Voltage Monitor
Frequency Monitor
Temperature Monitor
Light Protection
Secure Memory Management/Access Protection (Supervisor Mode)
Designed to meet Common Criteria EAL4+
Development Tools
• Voyager Emulation Platform (ATV4 Advanced) to Support Software Development
• IAR Embedded Workbench® V3.20c Debugger or Atmel’s AVR Studio® Version 4.07 or Above
• Software Libraries and Application Notes
Description
The AT90SC12872RCFT is a low-power, high-performance, 8-/16-bit microcontroller with ROM program memory,
EEPROM data memor y, based on the secureAVR enhanced RISC architecture and with a dual interface
(contact+contactless).
By executing powerful instructions in a single clock cycle, the AT90SC12872RCFT achieves throughputs close to 1 MIPS
per MHz. Its Harvard architecture includes 32 general-purpose working registers directly connected to the ALU, allowing
two independent registers to be accessed in one single instruction executed in one clock cycle.
The AT90SC12872RCFT uses the secureAVR architecture that allows the linear addressing of up to 8M bytes of code and
up to 16M bytes of data as well as a number of new functional and security features.
The AT90SC12872RCFT features 72K bytes of high-performance EEPROM (fast erase/write time, high endurance).This
allows system developers to offer their customers a true 64K bytes EEPROM, while still being able to use the remaining 8K
bytes for their own purposes (customization and patches, for example). The ability to map the EEPROM in the code space
allows parts of the program memory to be reprogrammed in-system.
The cryptographic accelerator featured in the AT90SC12872RCFT is the new AdvX, a N-bit multiplier-accumulator
dedicated to performing fast encryption and authentication functions. All cryptographic routines are executed on the
secureAVR core which uses the AdvX accelerator during encryption/decryption. AdvX is based on a 32-bit technology, thus
enabling fast computation and low power operation. AdvX supports standard finite fields arithmetic functions (including
RSA, DSA, DH and ECC) and GF(2N) arithmetic functions (including ECC).
Additional security features include power, frequency and temperature protection logic, logical scrambling on program data
and addresses, power analysis countermeasures, and memory accesses controlled by a supervisor mode.
This product is specifically designed for Smart Cards and targets Access Control and ID applications.
A block diagram of the AT90SC12872RCF is shown in Figure 1.
2
AT90SC12872RCFT
6502AS–SMIC–05Apr05
AT90SC12872RCFT
Figure 1. AT90SC12872RCFT Contact/Contactless secureAVR Enhanced Architecture
32K ROM
Cryptography
Data Bus
8-bit
Access
Control
72KB EEPROM
User Memory
+ OTP
PC
128KB
ROM Program
Memory
RNG
Interrupt
Unit
X
Y
Instruction
Register
Z
8
ISO 7816
Controller
8
16
Instruction
Decoder
CLK
GND
VCC
5KB RAM
Data Memory
General
Purpose
Registers
16
Secure
Control
ALU
16
8
Control
Lines
ISO 7816
I/O Port 0
IN/OUT0
ISO 7816
I/O Port 1
IN/OUT1
ISO14443
Controller (CIC)
Status
Register
Access
Control
DMA
Controller
RF1
RF Modulator
Power and Clock
RF2
Timers
DES/Triple DES
Reset
Circuit
RST
AdvX
Crypto-Accelerator
DPA Counter
Measures
CRC and
Checksum
Accelerator
3
6502AS–SMIC–05Apr05
Atmel Corporation
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 487-2600
Regional Headquarters
Europe
Atmel Sarl
Route des Arsenaux 41
Case Postale 80
CH-1705 Fribourg
Switzerland
Tel: (41) 26-426-5555
Fax: (41) 26-426-5500
Asia
Room 1219
Chinachem Golden Plaza
77 Mody Road Tsimshatsui
East Kowloon
Hong Kong
Tel: (852) 2721-9778
Fax: (852) 2722-1369
Japan
9F, Tonetsu Shinkawa Bldg.
1-24-8 Shinkawa
Chuo-ku, Tokyo 104-0033
Japan
Tel: (81) 3-3523-3551
Fax: (81) 3-3523-7581
Atmel Operations
Memory
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
RF/Automotive
Theresienstrasse 2
Postfach 3535
74025 Heilbronn, Germany
Tel: (49) 71-31-67-0
Fax: (49) 71-31-67-2340
Microcontrollers
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
La Chantrerie
BP 70602
44306 Nantes Cedex 3, France
Tel: (33) 2-40-18-18-18
Fax: (33) 2-40-18-19-60
ASIC/ASSP/Smart Cards
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Fax: 1(719) 540-1759
Biometrics/Imaging/Hi-Rel MPU/
High Speed Converters/RF Datacom
Avenue de Rochepleine
BP 123
38521 Saint-Egreve Cedex, France
Tel: (33) 4-76-58-30-00
Fax: (33) 4-76-58-34-80
Zone Industrielle
13106 Rousset Cedex, France
Tel: (33) 4-42-53-60-00
Fax: (33) 4-42-53-60-01
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Fax: 1(719) 540-1759
Scottish Enterprise Technology Park
Maxwell Building
East Kilbride G75 0QR, Scotland
Tel: (44) 1355-803-000
Fax: (44) 1355-242-743
Literature Requests
www.atmel.com/literature
Disclaimer: The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any
intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY
WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF INFORMATION) ARISING OUT
OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no
representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications
and product descriptions at any time without notice. Atmel does not make any commitment to update the information contained herein. Atmel’s products are not
intended, authorized, or warranted for use as components in applications intended to support or sustain life.
©Atmel Corporation 2005. All rights reserved. Atmel®, logo and combinations thereof, and others are registered trademarks. Everywhere You
Are SM and others are the trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others.
Printed on recycled paper.
6502AS–SMIC–05Apr05