DA227Y Diodes Switching diode DA227Y zApplications Ultra high speed switching z Dimensions (Unit : mm) z Land size figure (Unit : mm) 0.5 0.13±0.05 (4) (3) 1.2±0.1 1.6±0.1 1.6±0.05 1.55 zFeatures 1) Ultra small mold type. (EMD4) 2) High reliability. 0.45 1.6±0.05 1.6±0.1 0.22±0.05 0～0.1 1.0 (1) zConstruction Silicon epitaxial planar EMD4 (2) 0.5 0.5 1.0±0.1 0.5±0.05 z Structure ROHM : EMD4 JEITA : SC-75A Size dot (year w eek factory) z Taping specifications(Unit : mm) φ1.5±0.1 0 2.0±0.05 0.3±0.1 1PIN φ0.8±0.1 4.0±0.1 8.0±0.2 1.65±0.01 0～0.1 1.65±0.1 1.7±0.05 1.65±0.1 5.5±0.2 3.5±0.05 1.75±0.1 4.0±0.1 0.65±0.1 zAbsolute maximum ratings (Ta=25°C) Parameter Reverse voltage (repetitive peak) Reverse voltage (DC) Forward current (Single) Average rectified forward current (Single) Surge current （t=1us） (Single) Power dissipation （*1） Junction temperature Storage temperature Rated in slash put frequency Limits Symbol Unit 80 VRM V 80 VR V 300 IFM mA 100 Io mA 4 Isurge A 150 Pd mW/Total 150 Tj ℃ -55 to +150 Tstg ℃ 100 ｆ MHｚ （*1） Pd=120mW when only 1 circuit is operating. CONDITION = Each terminal mounted on a recommended land pattern. (0.35×0.9mm) zElectrical characteristics (Ta=25°C) Parameter Forward voltage Reverse current Capacitance between terminals Reverse recovery time Symbol VF IR Ct trr Min. - Typ. - Max. 1.2 0.1 3.5 4 Unit V µA pF ns Conditions IF=100mA VR=70V VR=6V , f=1MHz VR=6V , IF=5mA , RL=50Ω Rev.A 1/2 DA227Y Diodes zElectrical characteristic curves (Ta=25°C) Ta=150℃ Ta=150℃ Ta=-25℃ 1 Ta=75℃ 100 Ta=25℃ 10 Ta=-25℃ 1 0.1 0.01 10 20 30 40 50 60 70 REVERSE VOLTAGE：VR(V) VR-IR CHARACTERISTICS 80 0 REVERSE CURRENT:IR(nA) 940 Ta=25℃ VR=80V n=10pcs 90 930 920 910 AVE:921.7mV 900 80 9 70 60 50 40 30 AVE:9.655n 20 7 6 5 4 AVE:1.17pF 3 2 10 1 0 0 VF DISPERSION MAP IR DISPERSION MAP 20 Ct DISPERSION MAP 5 15 8.3ms 10 5 AVE:3.50A 0 Ta=25℃ VR=6V IF=5mA RL=50Ω n=10pcs 9 8 7 6 5 4 3 2 1 PEAK SURGE FORWARD CURRENT:IFSM(A) RESERVE RECOVERY TIME:trr(ns) 10 1cyc Ifsm Ifsm 4 8.3ms 8.3ms 1cyc 3 2 1 AVE:1.93ns 0 0 1 IFSM DISRESION MAP trr DISPERSION MAP t 10 1 0.1 1 10 TIME:t(ms) IFSM-t CHARACTERISTICS 100 Rth(j-a) 100 Rth(j-c) Mounted on epoxy board IM=1mA IF=10mA 10 1ms time 300us 1 0.001 100 9 ELECTROSTATIC DISCHARGE TEST ESD(KV) Ifsm 10 NUMBER OF CYCLES IFSM-CYCLE CHARACTERISTICS 10 1000 TRANSIENT THAERMAL IMPEDANCE:Rth (℃/W) PEAK SURGE FORWARD CURRENT:IFSM(A) 100 20 Ta=25℃ VR=6V f=1MHz n=10pcs 8 CAPACITANCE BETWEEN TERMINALS:Ct(pF) Ta=25℃ IF=100mA n=30pcs 5 10 15 REVERSE VOLTAGE:VR(V) VR-Ct CHARACTERISTICS 10 100 950 1 0.1 0 0 100 200 300 400 500 600 700 800 900 100 0 FORWARD VOLTAGE：VF(mV) VF-IF CHARACTERISTICS FORWARD VOLTAGE:VF(mV) f=1MHz CAPACITANCE BETWEEN TERMINALS:Ct(pF) Ta=25℃ 0.1 PEAK SURGE FORWARD CURRENT:IFSM(A) 10 1000 Ta=125℃ 10 Ta=125℃ 10000 Ta=75℃ REVERSE CURRENT:IR(nA) FORWARD CURRENT:IF(mA) 100 8 7 6 5 3 10 TIME:t(s) Rth-t CHARACTERISTICS AVE:0.97kV 2 1 0 0.1 AVE:2.54kV 4 1000 C=200pF R=0Ω C=100pF R=1.5kΩ ESD DISPERSION MAP Rev.A 2/2 Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.1