CP300 THRU CP3010 SINGLE-PHASE SILICON BRIDGE-P.C. MTG 2A, HEAT-SINK MTG 3A VOLTAGE - 50 to 1000 Volts CURRENT - 3.0 Amperes CP-3 Recongnized File #E111753 FEATURES l Surge overload rating—50 Amperes peak l Low forward voltage drop and reverse leakage l l Small size, simple installation Plastic package has Underwriter Laboratory l Flammability Classification 94V-O Reliable low cost construction utilizing molded plastic technique MECHANICAL DATA Terminals: Leads solderable per MIL-STD-202, Method 208 Weight: 0.08 ounce, 2.5 grams MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS At 25 ¢J ambient temperature unless otherwise noted; resistive or inductive load at 60Hz. Max Recurrent Peak Rev Voltage Max Bridge Input Voltage RMS Max Average Rectified Output at TC=50 ¢J * See Fig.2 at TA=25 ¢J ** Peak One Cycle Surge Overload Current Max Forward Voltage Drop per element at 1.5A DC & 25 ¢J . See Fig.3 Max Rev Leakage at Rated DC Blocking Voltage per element at 25 ¢J See Fig.4 at 100 ¢J 2 I t Rating for fusing ( t<8.3ms) CP300 CP301 CP302 CP304 CP306 CP308 50 35 100 70 200 140 400 280 3.0 2.0 600 420 800 560 Typical Junction capacitance per leg(Note 4)CJ Typical Thermal Resistance per leg(Note 2) R £KJA (Note 3) R £KJL Operating Temperature Range Storage Temperature Range CP3010 UNITS 1000 700 50 1.0 A V 10.0 1.0 £g A mA 15.0 21.0 12.0 8.0 -55 TO +125 -55 TO +150 A Sec PF ¢J /W NOTES: 1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface for maximum heat transfer with #6 screw. 2. Unit mounted on 4.0 ¡Ñ 4.0 ¡Ñ 0.11” thick (10.5 ¡Ñ 10.5 ¡Ñ 0.3cm) AL. Plate. 3. Unit mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5 ¡Ñ 0.5” (12 ¡Ñ 12mm) copper pads. 4. Measured at 1 MHz and applied reverse voltage of 4.0 Volts. V V A 2 ¢J ¢J RATING AND CHARACTERISTIC CURVES CP300 THRU CP3010 FORWARD SURGE CURRENT, AMPERES pk (HALF SINE-WAVE) 50 OUTPUT CURRENT AMPERES 40 30 20 10 0 2 4 6 10 20 40 60 5 60Hz RESISTIVE OR INDUCTIVE LOAD HEAT SINK 4 3 MOUNTING TC 2 2.0" sq × 0.62 thick Copper Plate 1 P.C. BOARD 0 0 100 50 100 150 AMBIENT TEMPERATURE, ¢J Fig. 1- NON-RECURRENT SURGE RATING Fig. 2- DERATING CURVE FOR OUTPUT RECTIFIED CURRENT 5 10 4 3 2 1 .9 .8 .7 .5 .3 INSTANTANEOUS REVERSE CURRENT, MICROAMPERES INSTANTANEOUS FWD CURRENT AMPERES NUMBER OF CYCLES AT 60hz TYPICAL DISTRIBUTION .2 .1 .07 .05 .03 .02 MEDIAN .01 0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 TA = 100 ¢J 1.0 .1 TA = 25¢J .01 0 INSTANTANEOUS FWD VOLTAGE, VOLTS Fig. 3- T YPICAL FORWARD CHARACTERISTICS(25 ¢J) 20 40 60 80 100 120 140 PERCENT OF PEAK REVERSE VOLTAGE Fig. 4- TYPICAL REVERSE CHARACTERISTICS