GBU6A THRU GBU6K GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes GBU FEATURES l Plastic package has Underwriters Laboratory Flammability Classification 94V-O l Ideal for printed circuit board l Reliable low cost construction utilizing molded plastic technique l Surge overload rating: 175 Amperes peak l High temperature soldering guaranteed: 260 /10 seconds/.375”(9.5mm) lead length at 5 lbs. (2.3kg) tension MECHANICAL DATA Case: Reliable low cost construction utilizing molded plastic technique Terminals: Leads solderable per MIL-STD-202, Method 208 Mounting position: Any Mounting torque: 5 in. lb. Max. Weight: 0.15 ounce, 4.0 grams MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25 ambient temperature unless otherwise specified. Resistive or inductive load, 60Hz. For Capacitive load derate current by 20%. Maximum Recurrent Peak Reverse Voltage Maximum RMS Input Voltage Maximum DC Blocking Voltage Maximum Average Forward TC=100 Rectified Output Current at I2t Rating for fusing ( t<8.3ms) Peak Forward Surge Current single sinewave superimposed on rated load (JEDEC method) Maximum Instantaneous Forward Voltage Drop per element at 6.0A Maximum Reverse Leakage at rated TA=25 Dc Blocking Voltage per element TC=100 Typical Thermal Resistance per leg (Note 2) R JA Typical Thermal Resistance per leg (Note 3) R JL GBU6A 50 35 50 GBU6B 100 70 100 GBU6D GBU6G 200 400 140 280 200 400 6.0 GBU6J 600 420 600 GBU6K UNITS 800 VRRM 560 VRMS 800 VDC A(AV) 127 175 A2Sec APK 1.0 VPK 5.0 500 8.6 3.1 A A /W Operating and Storage Temperature Range, TJ,TSTG -55 TO +150 NOTES: 1. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw. 2. Units Mounted in free air, no heatsink, P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5” (12×12mm)copper pads. 3. Units Mounted on a 2.6×1.4” ×0.06” thick (6.5×3.5×0.15cm) AL plate. RATING AND CHARACTERISTIC CURVES GBU6A THRU GBU6K Fig. 1-DERATING CURVE FOR OUTPUT Fig. 2-TYPICAL INSTANTANEOUS FORWARD RECTIFIED CURRENT CHARACTERISTICS PER ELEMENT Fig. 3-TYPICAL REVERSE CHARACTERISTICS Fig. 4- MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT Fig. 5-TYPICAL JUNCTION CAPACITANCE PER ELEMENT