CP800 THRU CP808 SINGLE-PHASE SILICON BRIDGE VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 8A CP-8 FEATURES l Surge overload rating—200 Amperes peak l Low forward voltage drop and reverse leakage l Small size, simple installation l Plastic package has Underwriter Laboratory Flammability Classification 94V-O l Reliable low cost construction utilizing molded plastic technique MECHANICAL DATA Mounting position: Any Weight: 0.24 ounce, 6.9 grams Terminals: Leads solderable per MIL-STD-202, Method 208 Mounting torque: Thro hole for #6 screw MACXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS At 25 ambient temperature unless otherwise noted; resistive or inductive load at 60Hz . Max Recurrent Peak Reverse Voltage Max Bridge Input Voltage RMS Max Average Rectified Output at TC=50 * See Fig. 2 at TA=40 ** Peak One Cycle Surge Overload Current Max Forward Voltage Drop per element at 4.0A DC & 25 . See Fig. 3 Max Rev Leakage at rated Dc Blocking Voltage per element at 25 See Fig 4 at100 I2t Rating for fusing ( t<8.3ms) Typical junction capacitance per leg (Note 4) CJ Typical Thermal Resistance per leg (Note 3) R JA Typical Thermal Resistance per leg (Note 2) R JL Operating Temperature Range Storage Temperature Range CP800 50 35 CP801 100 70 CP802 CP804 200 400 140 280 8.0 3.0 200 1.1 CP806 600 420 10.0 1.0 166 200 21 6 -55 TO +125 -55 TO +150 NOTES: 1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface for maximum heat transfer with #6 screw. 2. Units Mounted on a 8.6”×8.6” ×24” thick (22×22×0.6cm) AL plate heatsink. 3. Units Mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5×0.5”(12×12mm)copper pads. CP808 UNITS 800 V 560 V A A A V A mA A2Sec PF /W 4. Measured at 1.0MHZ and applied reverse voltage. RATING AND CHARACTERISTIC CURVES CP800 THRU CP808 Fig. 1-NON-RECURRENT SURGE RATING Fig. 2-DERATING CURVE FOR OUTPUT RECTIFIED CURRENT Fig. 3-TYPICAL FORWARD CHARACTERISTICS Fig. 4- TYPICAL REVERSE CHARACTERISTICS