Ordering number: EN 4089 Monolithic Linear IC LA6511 Power Operational Amplifier Package Dimensions Overview The LA6511 is a BLT-dedicated 1-channel driver developed for use in consumer and industrial equipment. (Do not use with ± power supply) unit : mm 3024A-SIP10H [LA6511] Features and Functions . High output current (I max = 2.0 A) . High gain . Wide operating voltage range (4 to 24 V) . Includes mute circuit (active low) O Specifications SANYO : SIP10H Maximum Ratings at Ta = 25 °C Parameter Symbol Ratings Unit Maximum supply voltage VCCmax 24 V Differential input voltage VID 24 V Input common-mode voltage range VIN 24 V Pd max 3.1 W Allowable power dissipation Operating temperature Topr –20 to +75 °C Storage temperature Tstg –55 to +150 °C Operating Characteristics at Ta = 25 °C, VCC = 12V Parameter Current drain with no load Input offset voltage Input offset voltage difference Input offset current Input bias current Input common-mode voltage range Common-mode signal rejection ratio Maximum output voltage Voltage gain Slew rate Supply voltage rejection ratio Mute-off voltage Mute pin output current Symbol ICC VIO DVIO IIO IB VICM CMR VO VGO SR SVR VMOFF IMUTE Conditions min 17 RS % 10 kΩ RS % 10 kΩ 0.5 70 RL = 8.0 Ω typ 25 3 1 10 50 max 35 7 3 100 500 10 80 8 85 0.15 30 1.0 40 Unit mA mV mV nA nA V dB V dB V/µs µV/V V µA Notes) Thermal shutdown function on chip. The mute voltage operates versus the VMref voltage. . . SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN 51695HA(II) No.4089-1/3 With infinitely large heat sink Al heat sink Tightening torque: 4 kg cm Coated with silicone grease No heat sink Storage temperature, Ta - °C . Thermal resistance of heat sink, θf - °C/W Allowable power dissipation,Pd max - W LA6511 Al heat sink t = 1.5 mm Tightening torque: 4 kg cm Coated with silicone grease . Area of heat sink, Sf - cm2 Pin Assignment Sample Application Circuit No.4089-2/3 LA6511 No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or indirectly cause injury, death or property loss. Anyone purchasing any products described or contained herein for an above-mentioned use shall: 1 Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and expenses associated with such use: 2 Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally. Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use or any infringements of intellectual property rights or other rights of third parties. This catalog provides information as of May, 1995. Specifications and information herein are subject to change without notice. No.4089-3/3