Ordering number: EN 5162 Monolithic Linear IC LA6518M 2-Channel Power Operational Amplifier Package Dimensions Applications The LA6518M is a 2-output power operational amplifier developed for use in consumer and industrial equipment. unit : mm 3097-MFP16FS [LA6518M] Features and Functions . High output current (I max = 0.5 A) . High gain . Includes current limiter . Wide operating voltage range (±2 to ±18 V) . Single power supply operation possible (4 to 36 V) . Thermal shutdown function built in O Allowable power dissipation, Pd max — W SANYO : MFP16FS Pd max — Ta Independent IC Ambient temperature, Ta — °C Specifications Maximum Ratings at Ta = 25 °C Parameter Symbol Conditions Ratings Unit Maximum supply voltage VCC/VEE ±18 V Differential input voltage VID 30 V Common-mode input voltage VIN ±15 V Allowable power dissipation Pd max 0.7 W Operating temperature Topr –20 to +75 °C Storage temperature Tstg –55 to +150 °C SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN 92995HA(II) No.5162-1/4 LA6518M Operating Conditions at Ta = 25 °C Parameter Recommended supply voltage Symbol Conditions VCC/VEE Ratings Unit ±2 to ±16 V Electrical Characteristics at Ta = 25 °C, VCC/VEE = ±15 V Parameter No-load current drain Input offset voltage Input offset current Input bias current Common-mode input voltage range Common-mode signal rejection ratio Maximum output voltage Voltage gain Slew rate Supply voltage rejection ratio Limit current (built-in type) . Thermal shutdown function built in. Symbol ICC VIO IIO IB VICM CMR VO VGO SR SVR ISC Conditions min RS % 10 kΩ RL = 33 Ω GV = 0, RL = 33 Ω, R = 10 Ω, L = 0.1 µF −14 65 ±11 typ 8 2 10 100 80 ±12 85 0.15 30 0.5 max 20 7 100 300 +13 300 Unit mA mV nA nA V dB V dB V/µs µV/V A Block Diagram and Pin Assignment Thermal shutdown and current limiter Do not use the NC pin. Top view No.5162-2/4 LA6518M Test Circuit No.5162-3/4 LA6518M Oscilloscope short wave Pulse generator No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment, nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or indirectly cause injury, death or property loss. Anyone purchasing any products described or contained herein for an above-mentioned use shall: 1 Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and expenses associated with such use: 2 Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally. Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use or any infringements of intellectual property rights or other rights of third parties. This catalog provides information as of September, 1995. Specifications and information herein are subject to change without notice. No.5162-4/4