STMICROELECTRONICS TS3V393I

TS3V393
3V MICROPOWER DUAL VOLTAGE COMPARATORS
.
.
.
.
.
.
.
DEDICATED TO 3.3V OR BATTERY SUPPLY
(specified at 3V and 5V)
EXTREMELY LOW SUPPLY CURRENT :
9µA typ/comparator
WIDE SINGLE SUPPLY RANGE
2.7V to 16V
EXTREMELY LOW INPUT CURRENTS :
1pA TYP
INPUT COMMON-MODE VOLTAGE RANGE
INCLUDES GND
FAST RESPONSE TIME : 2.5µs typ for
5mV overdrive
PIN-TO-PIN AND FUNCTIONALLY
COMPATIBLE WITH BIPOLAR LM393
DESCRIPTION
The TS3V393 is a micropower dual CMOS voltage
comparator with extremely low consumption of
9µA typ / comparator (20 times less than bipolar
LM393). Similar performances are offered by the
dual micropower comparator TS3V3702 with a
push-pull CMOS output.
Thus response times remain similar to the LM393.
N
DIP8
(Plastic Package)
D
SO8
(Plastic Micropackage)
ORDER CODES
Temperature
Range
Part Number
-40oC, +125oC
TS3V393I
Package
N
D
●
●
PIN CONNECTIONS (top view)
October 1997
Output 1
1
Inverting Input 1
2
-
Non-inverting Input 1
3
+
VCC -
4
8
V CC +
7
Output 2
-
6
Inverting Input 2
+
5
Non-inverting Input 2
1/6
TS3V393
SCHEMATIC DIAGRAM (for 1/2 TS3V393)
VCC +
T 10
T1
T2
T9
T 17
T 11
R1
T 12
Input T3
T 18
Input +
T4
Output
T 20
T 13
T8
T 19
T5
T7
T14
T15
T 16
T6
VCC -
MAXIMUM RATINGS
Symbol
+
Parameter
Value
Unit
Supply Voltage - (note 1)
18
V
Vid
Differential Input Voltage - (note 2)
± 18
V
VCC
Vi
Input Voltage - (note 3)
18
V
VO
Output Voltage
18
V
IO
Output Current
20
mA
Toper
o
Operating Free-Air Temperature Range
C
TS3V393I
Tstg
Notes : 1.
2.
3.
4.
Storage Temperature Range
-40 to +125
-65 to +150
o
C
All voltage values, except differential voltage, are with respect to network ground terminal.
Differential voltages are the non-inverting input terminal with respect to the inverting input terminal.
The magnitude of the input and the output voltages must never exceed the magnitude of the positive supply voltage.
Short circuit from outputs to VCC+ can cause excessive heating and eventual destruction.
OPERATING CONDITIONS
Symbol
2/6
Parameter
VCC+
Supply Voltage
Vicm
Common Mode Input Voltage Range
Value
2.7 to 16
+
0 to VCC -1.5
Unit
V
V
TS3V393
ELECTRICAL CHARACTERISTICS
VCC+ = 3V, VCC- = 0V, Tamb = 25°C (unless otherwise specified)
Symbol
Vio
Iio
Iib
Parameter
Min.
Typ.
Input Offset Voltage - (note 1)
Vic = 1.5V
Tmin. ≤ Tamb ≤ Tmax.
Max.
mV
5
6.5
Input Offset Current - (note 2)
Vic = 1.5 V
Tmin. ≤ Tamb ≤ Tmax.
1
Input Bias Current - (note 2)
Vic = 1.5 V
Tmin. ≤ Tamb ≤ Tmax.
1
pA
300
pA
600
0 to VCC+-1.2
0 to VCC+ -1.5
V
Vicm
Input Common Mode Voltage Range
Tmin. ≤ Tamb ≤ Tmax.
CMR
Common-mode Rejection Ratio
Vic = Vicm min.
70
Supply Voltage Rejection Ratio
+
VCC = 3V to 5V
70
High Level Output Current
Vid = +1V, VOH = 3V
Tmin. ≤ Tamb ≤ Tmax.
2
40
1000
Low Level Output Voltage
Vid = -1V, IOL = +6mA
Tmin. ≤ Tamb ≤ Tmax.
400
550
800
9
20
25
SVR
IOH
VOL
ICC
tPLH
tPHL
dB
dB
nA
mV
Supply Current (each comparator)
No load - Outputs low
Tmin. ≤ Tamb ≤ Tmax.
Response Time Low to High
Vic = 0V, f = 10kHz, RL = 5.1kΩ, C L = 15pF,
Response Time High to Low
Vic = 0V, f = 10kHz, RL = 5.1kΩ, C L = 15pF,
Unit
Overdrive = 5mV
TTL Input
1.5
0.7
Overdrive = 5mV
TTL Input
2.5
0.08
µA
µs
µs
Note : 1. The specified offset voltage is the maximun value required to drive the output up to 4.5V or down to 0.3V.
2. Maximum values including unavoidable inaccuracies of the industrial test.
3/6
TS3V393
ELECTRICAL CHARACTERISTICS
VCC+ = 5V, VCC- = 0V, Tamb = 25°C (unless otherwise specified)
Symbol
Vio
Iio
Iib
Typ.
Max.
Input Offset Voltage - (note 1)
Vic = 2.5V
Tmin. ≤ Tamb ≤ Tmax.
Parameter
Min.
1.4
5
6.5
Input Offset Current - (note 2)
Vic = 2.5 V
Tmin. ≤ Tamb ≤ Tmax.
1
Input Bias Current - (note 2)
Vic = 2.5 V
Tmin. ≤ Tamb ≤ Tmax.
1
mV
pA
300
pA
600
0 to VCC+-1.2
0 to VCC+ -1.5
V
Vicm
Input Common Mode Voltage Range
Tmin. ≤ Tamb ≤ Tmax.
CMR
Common-mode Rejection Ratio
Vic = Vicm min.
70
Supply Voltage Rejection Ratio
+
VCC = +5V to +10V
80
High Level Output Current
Vid = 1V, VOH = +5V
Tmin. ≤ Tamb ≤ Tmax.
2
40
1000
Low Level Output Voltage
Vid = -1V, IOL = 6mA
Tmin. ≤ Tamb ≤ Tmax.
260
400
650
Supply Current (each comparator)
No load - Outputs low
Tmin. ≤ Tamb ≤ Tmax.
10
20
25
SVR
IOH
VOL
ICC
tPLH
tPHL
Response Time Low to High
Vic = 0V, f = 10kHz, RL = 5.1kΩ, C L = 15pF,
Response Time High to Low
Vic = 0V, f = 10kHz, RL = 5.1kΩ, C L = 15pF,
dB
dB
nA
mV
Overdrive = 5mV
TTL Input
1.5
0.7
Overdrive = 5mV
TTL Input
2.5
0.08
Note : 1. The specified offset voltage is the maximun value required to drive the output up to 4.5V or down to 0.3V.
2. Maximum values including unavoidable inaccuracies of the industrial test.
4/6
Unit
µA
µs
µs
TS3V393
PM-DIP8.EPS
PACKAGE MECHANICAL DATA
8 PINS - PLASTIC DIP
Millimeters
Min.
A
Typ.
Min.
3.32
a1
0.51
B
1.15
b
0.356
b1
0.204
Typ.
0.131
1.65
0.045
0.065
0.55
0.014
0.022
0.304
0.008
0.012
10.92
7.95
9.75
0.430
0.313
0.384
e
2.54
0.100
e3
7.62
0.300
e4
7.62
F
Z
0.300
6.6
i
L
0260
5.08
3.18
Max.
0.020
D
E
Inches
Max.
3.81
1.52
0.200
0.125
DIP8.TBL
Dim.
0.150
0.060
5/6
TS3V393
PM-SO8.EPS
PACKAGE MECHANICAL DATA
8 PINS - PLASTIC MICROPACKAGE (SO)
A
a1
a2
a3
b
b1
C
c1
D
E
e
e3
F
L
M
S
Min.
Millimeters
Typ.
0.1
0.65
0.35
0.19
0.25
Max.
1.75
0.25
1.65
0.85
0.48
0.25
0.5
Min.
Inches
Typ.
0.026
0.014
0.007
0.010
Max.
0.069
0.010
0.065
0.033
0.019
0.010
0.020
0.189
0.228
0.197
0.244
0.004
o
45 (typ.)
4.8
5.8
5.0
6.2
1.27
3.81
3.8
0.4
0.050
0.150
4.0
1.27
0.6
0.150
0.016
0.157
0.050
0.024
8o (max.)
SO8.TBL
Dim.
 1997 SGS-THOMSON Microelectronics – Printed in Italy – All Rights Reserved
SGS-THOMSON Microelectronics GROUP OF COMPANIES
Australia - Brazil - Canada - China - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco
The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A.
6/6
ORDER CODE :
Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility
for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics.
Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all
information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use as critical components in life
support devices or systems without express written approval of SGS-THOMSON Microelectronics.