Photomicrosensor EE-SX4009-P10 (Transmissive) Dimensions Note: Features All units are in millimeters unless otherwise indicated. 70389-0037 (US Molex) • • • • Screw-mounting model. • Connects to US Molex connectors. High resolution with a 0.5-mm-wide sensing aperture. With a 5-mm-wide groove. Photo IC output signals directly connect with C-MOS and TTL. Absolute Maximum Ratings (Ta = 25°C) Two, R1 Item 0.5 (Aperture Width) VCC 10 V Output voltage VOUT 28 V Output current IOUT 16 mA Permissible output dissipation POUT 250 mW (see note) Ambient temperature e pe a u e Operating Topr –25°C to 75°C Storage Tstg –40°C to 85°C Tsol --- Soldering temperature O Unless otherwise specified, the tolerances are as shown below. G Terminal No. V Name Power supply (Vcc) O G Output (OUT) Ground (GND) Dimensions Tolerance 4 mm max. ±0.2 4 t mm v 16 ±0.3 16 t mm v 63 ±0.5 Rated value Power supply voltage Internal Circuit V Symbol Note: Refer to the temperature rating chart if the ambient temperature exceeds 25°C. Recommended Mating Connectors: US Molex 50-57-9403 15-47-4033 14-56-2036 (AWG28) 14-56-2034 (AWG26) 14-56-2032 (AWG24) 14-56-2037 (AWG22) Electrical and Optical Characteristics (Ta = 25°C, Vcc = 5 V ±10%) Item Symbol Value Condition Current consumption ICC 30 mA max. With and without incident Low-level output voltage VOL 0.3 V max. IOUT = 16 mA with incident High-level output voltage VOH (VCC x 0.9) V min. VOUT = VCC without incident, RL = 47 kΩ Response frequency f 3 kHz min. VOUT = VCC, RL = 47 kΩ (see note) Note: The value of the response frequency is measured by rotating the disk as shown below. Disk 2.1 mm 0.5 mm 174 0.5 mm t = 0.2 mm EE-SX4009-P10 EE-SX4009-P10 Engineering Data Output allowable dissipation Pc (mW) Output Allowable Dissipation vs. Ambient Temperature Characteristics Sensing Position Characteristics (Typical) Ambient temperature Ta (°C) VCC = 5 V, Ta = 25°C RL = 47 kΩ Center of optical axis Light interrupting plate Output transistor d1 = 0±0.3 mm Distance d (mm) 175