Photomicrosensor (Transmissive) EE-SX3009-P1/-SX4009-P1 Be sure to read Precautions on page 24. ■ Dimensions ■ Features Note: All units are in millimeters unless otherwise indicated. • • • • • • • 34 171825-3 (Tyco Electronics AMP) 23±0.2 ■ Absolute Maximum Ratings (Ta = 25°C) 4.2±0.2 dia. hole 3±0.1 dia, depth: 2 Two, R1 0.5 (Aperture width) Optical axis 10.5 7.5 4 0 −0.1 dia. Internal Circuit O O G Symbol Rated value VCC 10 V Output voltage VOUT 28 V Output current IOUT 16 mA Permissible output dissipation POUT 250 mW (see note) Ambient temper- Operating ature Storage Topr –25°C to 75°C Tstg –40°C to 85°C Soldering temperature Tsol --- Unless otherwise specified, the tolerances are as shown below. G V Item Power supply voltage Note: Refer to the temperature rating chart if the ambient temperature exceeds 25°C. V Terminal No. Screw-mounting model. High resolution with a 0.5-mm-wide sensing aperture. With a 5-mm-wide groove. Photo IC output signals directly connect with C-MOS and TTL. Connects to Tyco Electronics AMP’s EI-series connectors. Dark ON model (EE-SX3009-P1) Light ON model (EE-SX4009-P1) Name Dimensions Tolerance Power supply (Vcc) 4 mm max. ±0.2 Output (OUT) Ground (GND) 4 < mm ≤ 16 ±0.3 16 < mm ≤ 63 ±0.5 Recommended Mating Connectors: Tyco Electronics AMP 171822-3 (crimp connector) 172142-3 (crimp connector) OMRON EE-1005 (with harness) ■ Electrical and Optical Characteristics (Ta = 25°C, Vcc = 5 V ±10%) Item Symbol Value Condition Current consumption ICC 30 mA max. With and without incident Low-level output voltage VOL 0.3 V max. IOUT = 16 mA Without incident (EE-SX3009-P1) With incident (EE-SX4009-P1) High-level output voltage VOH (VCC x 0.9) V min. VOUT = VCC With incident (EE-SX3009-P1) Without incident (EE-SX4009-P1), RL = 47 kΩ Response frequency f 3 kHz min. VOUT = VCC, RL = 47 kΩ (see note) Note: The value of the response frequency is measured by rotating the disk as shown below. Disk 2.1 mm 0.5 mm 60 0.5 mm t = 0.2 mm EE-SX3009-P1/-SX4009-P1 Photomicrosensor (Transmissive) ■ Engineering Data Note: The values in the parentheses apply to the EE-SX4009-P1. Sensing Position Characteristics (Typical) Output allowable dissipation Pc (mW) Output Allowable Dissipation vs. Ambient Temperature Characteristics VCC = 5 V, Ta = 25°C RL = 47 kΩ ON (OFF) Center of optical axis Light interrupting plate Output transistor d1 = 0±0.3 mm OFF (ON) Ambient temperature Ta (°C) Distance d (mm) EE-1005 Connector 1,000±20 (1) (2) No. (3) Name Model Quantity Maker 1 Receptacle housing 171822-3 1 Tyco Electronics AMP 2 Receptacle contact 170262-1 3 Tyco Electronics AMP 3 Lead wire UL1007 AWG24 3 Wiring Connector circuit no. Lead wire color Output when connected to EE-SX4009-P1/EE-SX3009-P1 1 Red 2 Orange VCC GND 3 Yellow OUT --- EE-SX3009-P1/-SX4009-P1 Photomicrosensor (Transmissive) 61