TS7900 Series 3-Terminal Fixed Negative Voltage Regulator TO-220 ITO-220 TO-263 2 (D PAK) Pin Definition: 1. Ground 2. Input (tab) 3. Output General Description The TS7900 series of fixed output negative voltage regulators are intended as complements to the popular TS7800 series device. These negative regulators are available in the same seven-voltage options as the TS7900 devices. In addition, one extra voltage option commonly employed in MECL systems is also available in the negative TS7900A Series. Available in fixed output voltage options from -5.0 to -24 volts, these regulators employ current limiting, thermal shutdown, and safe-area compensation--making them remarkably rugged under most operating conditions. With adequate heat sinking they can deliver output currents in excess of 1 ampere. This series is offered in 3-pin TO-220, ITO-220 & TO-263 package. Features Standard Application Circuit ● Output Voltage: -5 & -12V ● Output current up to 1A ● No external components required ● Internal thermal overload protection ● Internal short-circuit current limiting ● Output transistor safe-area compensation ● Output voltage offered in 4% tolerance A common ground is required between the input and the output voltages. The input voltage must remain typically 2.0V above the output voltage even during the low point on the Input ripple voltage. XX = these two digits of the type number indicate voltage. * = Cin is required if regulator is located an appreciable distance from power supply filter. ** = Co is not needed for stability; however, it does improve transient response. Ordering Information Part No. Package Packing TS79xxCZ C0 TO-220 50pcs / Tube TS79xxCZ C0G TO-220 50pcs / Tube TS79xxCI C0 ITO-220 50pcs / Tube TS79xxCM RN TO-263 800pcs / 13” Reel Note: Where xx denote voltage option Note: “G” denote for Green Product Halogen Free Absolute Maximum Rating (Ta = 25oC unless otherwise noted) Parameter Symbol Limit Unit Input Voltage VIN -35 V Power Dissipation PD Internal Limited Junction Temperature TJ Storage Temperature Range Note: * Follow the derating curve TSTG 1/8 W +150 o C -65~+150 o C Version: C07 TS7900 Series 3-Terminal Fixed Negative Voltage Regulator TS7905 Electrical Characteristics o o (Vin= -10V, Iout=500mA, 0 C≤Tj≤125 C, Cin=0.33uF, Cout=0.1uF; unless otherwise specified.) Parameter Symbol Test Condition o Tj=25 C Output voltage Vout Line Regulation REGline Load Regulation REGload Quiescent Current Iq Quiescent Current Change ΔIq Output Noise Voltage Ripple Rejection Ratio Voltage Drop Output Short Circuit Current Peak Output Current Temperature Coefficient of Output Voltage Vn RR Vdrop Ios Io peak ΔVout/ ΔTj -7.5V≤Vin≤-20V, 10mA≤Iout≤1A, PD≤15W o Tj=25 -7.5V≤Vin≤-25V C -8V≤Vin≤-12V o Tj=25 10mA≤Iout≤1A C 250mA≤Iout≤750mA o Iout=0, Tj=25 C -7.5V≤Vin≤-25V 10mA≤Iout≤1A o 10Hz≤f≤100KHz, Tj=25 C f=120Hz, -8V≤Vin≤-18V o Iout=1A, Tj=25 C o Tj=25 C o Tj=25 C o o Iout=10mA, 0 C≤Tj≤125 C Min Typ Max Unit -4.80 -5 -5.20 -4.75 -5 -5.25 --------62 ---- 3 1 15 5 4 --40 74 2 750 2.1 100 50 100 50 8 1.3 0.5 ------ -- -0.1 -- mV/ C Unit V mV mA µV dB V mA A o TS7912 Electrical Characteristics o o (Vin= -19V, Iout=500mA, 0 C≤Tj≤125 C, Cin=0.33uF, Cout=0.1uF; unless otherwise specified.) Parameter Symbol Test Condition Min Typ Max Tj=25 C -14.5V≤Vin≤-27V, 10mA≤Iout≤1A, PD ≤15W -14.5V≤Vin≤-30V o Tj=25 C -15V≤Vin≤-19V 10mA≤Iout≤1A o Tj=25 C 250mA≤Iout≤750mA o Tj=25 C, Iout=0 -14.5V≤Vin≤-30V 10mA≤Iout≤1A o 10Hz≤f≤100KHz, Tj=25 C f=120Hz, -15V≤Vin≤-25V o Iout=1A, Tj=25 C o Tj=25 C o Tj=25 C -11.53 -12 -12.48 -11.42 -12 -12.60 --------55 ---- 10 3 12 4 4.3 --75 70 2 350 2.1 240 120 240 120 8 1 0.5 ------ o Output Voltage Vout Line Regulation REGline Load Regulation REGload Quiescent Current Quiescent Current Change Iq ΔIq V mV mA Output Noise Voltage Vn uV Ripple Rejection Ratio RR dB Voltage Drop Vdrop V Output Short Circuit Current Ios mA Peak Output Current Io peak A Temperature Coefficient of o o o ΔVout/ ΔTj Iout=10mA, 0 C≤Tj≤125 C --1 -mV/ C Output Voltage Pulse testing techniques are used to maintain the junction temperature as close to the ambient temperature as possible, and thermal effects must be taken into account separately. This specification applies only for DC power dissipation permitted by absolute maximum ratings. 2/8 Version: C07 TS7900 Series 3-Terminal Fixed Negative Voltage Regulator Electrical Characteristics Curve Figure 1. Worse Case Power Dissipation as a Function of Ambient Temperature Figure 2. Peak Output Current as a Function of Input-Output Differential Voltage Figure 3. Ripple Rejection as a Function of Frequency Figure 4. Ripple Rejection as a Function of Output Voltage Figure 5. Output Voltage as a Function of Junction Temperature Figure 5. Output Voltage as a Function of Junction Temperature 3/8 Version: C07 TS7900 Series 3-Terminal Fixed Negative Voltage Regulator Application Information 2 Figure 7. D PAK Thermal Resistance and Maximum Power Dissipation vs. P.C.B Copper Length 4/8 Version: C07 TS7900 Series 3-Terminal Fixed Negative Voltage Regulator TO-220 Mechanical Drawing DIM A B C D E F G H I J K L M N O P TO-220 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 10.000 10.500 0.394 0.413 3.740 3.910 0.147 0.154 2.440 0.381 2.345 4.690 12.700 8.382 14.224 3.556 0.508 27.700 2.032 0.255 5.842 2.940 6.350 1.106 2.715 5.430 14.732 9.017 16.510 4.826 1.397 29.620 2.921 0.610 6.858 0.096 0.015 0.092 0.092 0.500 0.330 0.560 0.140 0.020 1.060 0.080 0.010 0.230 0.116 0.250 0.040 0.058 0.107 0.581 0.355 0.650 0.190 0.055 1.230 0.115 0.024 0.270 Marking Diagram XX Y M L CZ = Output Voltage (05=-5V, 12=-12V) = Year Code = Month Code (A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep, J=Oct, K=Nov, L=Dec) = Month Code for Halogen Free Product (O=Jan, P=Feb, Q=Mar, R=Apl, S=May, T=Jun, U=Jul, V=Aug, W=Sep, X=Oct, Y=Nov, Z=Dec) = Lot Code = Package Code for TO-220 5/8 Version: C07 TS7900 Series 3-Terminal Fixed Negative Voltage Regulator ITO-220 Mechanical Drawing DIM A B C D E F G H I J K L M N O ITO-220 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 9.96 10.36 0.392 0.407 6.20 (typ.) 0.244 (typ.) 2.20 (typ.) 0.087 (typ.) ∮1.40 (typ.) ∮0.055 (typ.) 15.07 16.07 0.593 0.632 0.80 (typ.) 0.031 (typ.) 2.44 2.64 0.096 0.104 13.08 13.48 0.514 0.530 1.47 (max.) 0.057 (max.) 3.20 3.40 0.125 0.133 4.60 4.80 0.181 0.188 1.15 (typ.) 0.045 (typ.) 2.44 2.64 0.096 0.104 2.60 2.80 0.102 0.110 6.55 6.65 0.258 0.262 Marking Diagram XX Y M L CI = Output Voltage (05=-5V, 12=-12V) = Year Code = Month Code (A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep, J=Oct, K=Nov, L=Dec) = Lot Code = Package Code for ITO-220 6/8 Version: C07 TS7900 Series 3-Terminal Fixed Negative Voltage Regulator TO-263 Mechanical Drawing DIM A B C D E F G H I J TO-263 DIMENSION MILLIMETERS INCHES MIN MAX MIN MAX 10.000 10.500 0.394 0.413 14.605 15.875 0.575 0.625 0.508 0.991 0.020 0.039 2.420 2.660 0.095 0.105 4.064 4.830 0.160 0.190 1.118 1.400 0.045 0.055 0.450 0.730 0.018 0.029 8.280 8.800 0.325 0.346 1.140 1.400 0.044 0.055 1.480 1.520 0.058 0.060 Marking Diagram XX = Output Voltage (05=-5V, 12=-12V) Y = Year Code M = Month Code (A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep, J=Oct, K=Nov, L=Dec) L = Lot Code CM = Package Code for TO-263 7/8 Version: C07 TS7900 Series 3-Terminal Fixed Negative Voltage Regulator Notice Specifications of the products displayed herein are subject to change without notice. TSC or anyone on its behalf, assumes no responsibility or liability for any errors or inaccuracies. Information contained herein is intended to provide a product description only. No license, express or implied, to any intellectual property rights is granted by this document. Except as provided in TSC’s terms and conditions of sale for such products, TSC assumes no liability whatsoever, and disclaims any express or implied warranty, relating to sale and/or use of TSC products including liability or warranties relating to fitness for a particular purpose, merchantability, or infringement of any patent, copyright, or other intellectual property right. The products shown herein are not designed for use in medical, life-saving, or life-sustaining applications. Customers using or selling these products for use in such applications do so at their own risk and agree to fully indemnify TSC for any damages resulting from such improper use or sale. 8/8 Version: C07