TSOP Series Ultra Precision Molded Resistor Networks The content of this specification may change without notification 1/01/06 Custom solutions are available. HOW TO ORDER TSOP 08 A 1003 B C TCR (PPM/°C) R = +5 S = +10 E = +25 C = +50 Resistance Tolerance A = +.05 B = +.10 C = +.25 FEATURES Resistance Value 3 sig. fig & 1 multiplier +1% TSOP High Precision NiCr Thin Film Resistor Circuit Type/Pattern Refer to Circuit Schematic A, B, C, D, E 10 Standard Circuits Networks with tight ratio and tracking Excellent to relative Tolerance and TCR High Stability Thin Film Pins 8, 14,16, 20 2.3mm High from PC Board, most fit for Series Ultra Precision Molded Resistor high density compacted instruments. Custom Circuit Configuration is Available ELECTRICAL SPECIFACTIONS MECHANICAL SPECIFACTIONS Rated Power per Resistor at 70ºC Mechanical Protection Epoxy Molded Maximum Working Voltage 60mW 75V Resistive Element NiCr Film Maximum Overload Voltage 150V Terminal Leads Tinned 50, 25,10, 5 Absolute Tolerance % 0.25, 0.1, 0.05 TYPICAL PERFORMANCE T C R Absolute TCR ppm/ºC O L TSOP 08 SCHEMATIC TSOP 08 ABS TRACKING ± 5ppm 1, 2, 3, 5 ± 10ppm 1, 2, 3, 5, 10 ± 25ppm 1, 2, 3, 5, 10 ± 50ppm 1, 2, 3, 5, 10 ABS RATIO ± 0.05% 0.025, 0.05, 0.1 ± 0.10% 0.025, 0.05, 0.1, 0.2 ± 0.25% 0.025, 0.05, 0.1, 0.25, 0.5 TSOP 16 DIMENSIONS (mm) Model A B C D E F G H TSOP 08 5.5 ± 0.3 5.3 ± 0.3 2.3 max 8.0 ± 0.2 1.27 ± 0.2 0.4 ± 0.05 0.2 ± 0.1 0.3 min TSOP 16 10.5 ± 0.5 5.3 ± 0.3 2.3 max 8.0 ± 0.2 1.27 ± 0.2 0.4 ± 0.05 0.2 ± 0.1 0.3 min American Accurate Components, Inc. 188 Technology Drive, Unit H, Irvine, CA 92618 TEL: 949-453-9888 FAX: 949-453-8889 1 TSOP Series Ultra Precision Molded Resistor Networks The content of this specification may change without notification 1/01/06 CIRCUIT SPECIFICATION Circuit Symbol A B C D E 50.0 ~ 22.0K 50.0 ~ 10.0K 50.0 ~ 22.0K 50.0 ~ 22K 500 ~ 10.0K TSOP 08 Circuit Layout Options Resistance Range (Ω) CIRCUIT SPECIFICATION – 16 PINS Circuit Symbol A B C 50.0 ~ 22.0K 50.0 ~ 10.0K 50.0 ~ 22.0K D E 50.0 ~ 22K 500 ~ 10.0K TSOP 16 Circuit Layout Options Resistance Range (Ω) Circuit Symbol TSOP 16 Circuit Layout Options Resistance Range (Ω) PERFORMANCE TEST TEST METHOD Operating Temperature Range Short Time Overload Temperature Cycle Resistance to Solder Heat Moisture Resistance Load Life Load Life at 70°C American Accurate Components, Inc. REQUIREMENTS -55ºC ~ 155ºC 2.5 x rated voltage for 5 seconds ± (0.02% + 0.01Ω) -55ºC ~ 155ºC for 5 cycles ± (0.02% + 0.01Ω) 250ºC for 10 seconds ± (0.02% + 0.01Ω) 40°C, 90 ~ 95% R.H. rated voltage, 1,000 hours ± (0.02% + 0.01Ω) 70°C, rated voltage, 1.5 hours on, 0.5 hours off, 1,000 hours ± (0.02% + 0.01Ω) 188 Technology Drive, Unit H, Irvine, CA 92618 TEL: 949-453-9888 FAX: 949-453-8889 2