ANAREN 800-50T-S

Model RFP-800-50T-S
Flanged Termination
800 Watts, 50Ω
General Specifications
Resistive Element
Substrate
Cover
Mounting flange
Leads
Thick film
Beryllium oxide ceramic
Alumina ceramic
Copper, nickel plated per QQ-N-290
99% pure silver (.005” thick)
Electrical Specifications
Features:
• DC – 500 MHz
• 800 Watts
• BeO Ceramic
• Non-Nichrome Resistive
Element
Resistance Range:
Frequency Range;
Power:
VSWR:
50 ohms, ± 5%
DC – 500 MHz
800 Watts
1.5:1 @ 0.5 GHz
2.0:1 @ 1.0 GHz
Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed
applicable portions of MIL-E-5400. Operating temperature is -55ºC to 155ºC (see
chart for derating temperatures).
• Welded Silver Leads
All dimensions in inches.
• Low VSWR
Specifications subject to change with out notice.
• 100% Tested
Outline Drawing
800-50T-S (097) Rev B
Available on Tape
and Reel For Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 544-2414
+44 2392-232392
Model RFP-800-50T-S
Typical Performance:
Power De-rating:
Mounting Footprint and Procedure:
SUGGESTED MOUNTING PROCEDURES:
1.
.025 MIN.
(2 PLACES)
2.
3.
BOARD LOWER
THAN LEAD.
BOARD EVEN
WITH LEAD.
BOARD LOWER
THAN LEAD.
BOARD HIGHER
THAN LEAD.
SUGGESTED STRESS RELIEF METHODS
NOT RECOMMENDED APPLICATION
SCALE: NONE
SCALE: NONE
4.
5.
MAKE SURE THAT THE DEVICES ARE MOUNTED ON
FLAT SURFACES (.001" UNDER THE DEVICE) TO
OPTIMIZE THE HEAT TRANSFER.
DRILL & TAP THE HEATSINK FOR THE APPROPRIATE
THREAD SIZE TO BE USED.
COAT HEATSINK WITH A MINIMUM AMOUNT OF HIGH
QUALITY SILICONE GREASE (.001" MAX. THICKNESS).
POSITION DEVICE ON MOUNTING SURFACE & SECURE
USING SOCKET HEAD SCREWS, FLAT & SPLIT WASHER.
TORQUE SCREWS TO THE APPROPRIATE VALUE. MAKE
SURE THAT THE DEVICE IS FLAT AGAINST THE HEATSINK.
(CARE SHOULD BE TAKEN TO AVOID UPWARD PRESSURE OF
THE LEADS TOWARDS THE LID).
SOLDER LEADS IN PLACE USING APPROPROATE SOLDER WITH
A CONTROLLED TEMPERATURE IRON.
** FOR MORE DETAILS CONTACT FACTORY **
800-50T-S (097) Rev B
USA/Canada:
Toll Free:
Europe:
(315) 432-8909
(800) 544-2414
+44 2392-232392
Available on Tape and
Reel For Pick and Place
Manufacturing.