AWS5504-S14 A GaAs IC High Power Positive Control SPDT Reflective Switch DC-2.0 GHz Advanced Product Information Rev. 1 FEATURES High Linearity (IP3 55 dBm @ 0.9 GHz) Low Insertion Loss (0.35 dB @ 0.9 GHz) +3 V to +5 V Operation Low DC Power Consumption Ultra Miniature SOT-6 Package DESCRIPTION The AWS5504 is a Single Pole Double Throw (SPDT) GaAs MMIC switch assembled in a SOT-6 plastic package. The AWS5504 is designed for analog and digital applications that require low insertion loss, high linearity, and small size. The switch can be controlled with positive, negative, or a combination of both voltages. S14 SOT-6 6 Pin Plastic Package Typical applications include: transmit/receive switch, diversity switching, and antenna selection. ELECTRICAL SPECIFICATIONS AT 25 °C (0, +5V) Parameter 1 Frequency Insertion Loss 3 2 Min Typ Max Unit DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz - 0.3 0.4 1.0 0.4 0.6 1.2 dB Isolation DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz 20 15 8 23 17 10 - dB VSWR 4 DC - 1.0 GHz DC - 2.0 GHz - 1.3:1 1.3:1 1.4:1 1.8:1 dB OPERATING CHARACTERISTICS AT 25° C (0, +5V) Parameter Condition Frequency Min Typ Max Unit Switching Characteritics 5 Rise, Fall (10/90% or 90/10% RF) On, Off (50% CTL to 90%/10% RF) Video Feedthru - - 60 100 50 - ns ns mV Intermodulation Intercept Point (IP3) For Two-tone Input Power +10 dBm 0.9 GHz - +55 - dBm 0.9 GHz - +38 - dBm Input Power for 1dB Compression Control Voltage 1. 2. 3. 4. 5. VLOW = 0 to 0.2 V @ 20 uA Max VHIGH = +3 V @ 100 uA Max to +5 V @ 200 uA Max VS = VHIGH + 0.2V All measurements made in a 50 ohm system, unless other specified. DC = 300 kHz. Insertion loss changes by 0.003 dB/°C. Insertion loss state. Video feedthru measured with 1 ns rise time pulse and 500 MHz bandwidth. AWS5504-S14 Advanced Product Information - Rev. 0 ABSOLUTE MAXIMUM RATINGS Characteristics Value RF Input Power 6 W Max > 900 MHz, 0/-5 V Control TRUTH TABLE Control Voltage -0.2 V, +8 V V1 V2 J1 - J2 J1 - J3 Operating Temperature -40° C to +85°C 0 VHigh Isolation Insertion Loss Storage Temperature -65°C to +150°C VHigh 0 Insertion Loss Isolation qJC VHigh = +3 to +5 V (VS = Vhigh + 0.2 V) 25° C/W PIN OUT Vs 5 4 C2 3 RFOUT 2 (J3) 6 GND 2 C1 1 RFOUT 1 (J2) V1 10KW C3 RFIN (J1) V2 DC block capacitors C1, 2, 3 must be supplied externally. C1, 2 , 3 = 100 pF for operation >500 MHz P in Function D escription 1 RFOUT 1 (J2) 2 GND Ground connecti on. K eep as short as possi ble. 3 RFOUT 2 (J3) RF port can be used as an i nput or an ouput. 4 V2 5 RFIN (J1)/V s 6 V1 RF port can be used as an i nput or as an output. C ontrol Voltage 2, Low 0V , Hi gh 3V to 5V RF common port and bi as voltage for posi ti ve control (3V to 5V ). C ontrol Voltage 1, Low 0V , Hi gh 3V to 5V TEST CIRCUIT LAYOUT A 2 AWS5504-S14 Advanced Product Information - Rev. 0 PACKAGE OUTLINE DRAWING S504 θ NOTES: 1. Package body sizes exclude mold flash and gate burrs. 2. Dimension L is measured in gage plane 3. Coplanarity: 0.1000 mm 4. Tolerance + 0.1000 mm (4 mil) unless otherwise specified. SYMBOLS A A1 A2 b C D E e H L θ1 DIMENSIONS IN MILLIMETERS MIN 1.00 0.00 0.70 0.35 0.10 2.70 1.40 2.60 0.37 1° NOM 1.10 −−− 0.80 0.40 0.15 2.90 1.60 1.90(TYP) 2.80 −−− 5° MAX 1.30 0.10 0.90 0.50 0.25 3.10 1.80 3.00 −−− 9° DIMENSIONS IN INCHES MIN 0.039 0.00 0.027 0.014 0.004 0.106 0.055 NOM 0.043 −−− 0.031 0.016 0.006 0.114 0.063 0.075(TYP) 0.102 0.110 0.015 −−− 1° 5° MAX 0.051 0.004 0.035 0.020 0.010 0.122 0.071 0.118 −−− 9° ANADIGICS, Inc. 35 Technology Drive Warren, New Jersey 07059 Tel: (908) 668-5000 / Fax: (908) 668-5132 Email: [email protected] www.anadigics.com IMPORTANT NOTICE ANADIGICS, Inc. reserves the right to make changes to its products or discontinue any product at any time without notice. The Advanced Product data sheets and product specifications contained in this data sheet are subject to change prior to a products formal introduction. The information in this data sheet has been carefully checked and is assumed to be reliable. However, ANADIGICS assumes no responsibility for inaccuracies. ANADIGICS strongly urges customers to verify that the information they are using is current before placing orders. WARNING ANADIGICS products are not intended for use in life support appliances, device, or systems. Use of an ANADIGICS product in any such application without written consent is prohibited. A 3