NTE580 General Purpose Silicon Rectifier Fast Recovery Features: D High Temperature Metallurgically Bonded–No Compression Contacts D Fast Switching for High Effeciency D 3A Operation at TA = +25°C with No Thermal Runaway Maximum Ratings and Electrical Characteristics: (TA = +25°C unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%) Maximum Recurrent Peak Reverse Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 600V Maximum RMS Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 420V Maximum DC Blocking Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 600V Maximum Average Forward Rectified Current (.375” (9.5mm) Lead Length, TA = +75°C) . . . . . . 3A Peak Forward Surge Current (8.3ms Single Half Sine–Wave Superimposed on Rted Load) . 100A Maximum Instantaneous Forward Voltage (IF = 3A) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.3V Maximum DC Reverse Current (VDC = 600V, TA = +25°C) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5µA Maximum Average Reverse Current (PRV = 600V) TA = +25°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2µA TA = +100°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100µA Maximum Reverse Recovery Time (Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150ns Typical Junction Capacitance (Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65pF Operating Junction Temperature Range, TJ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65° to +175°C Storage Temperature Range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65° to +175°C Lead temperature (During Soldering, .375” (9.5mm) from case, 10sec), TL . . . . . . . . . . . . . . +350°C Note 1. Reverse Recovery Test Conditions: IF = 0.5A, IR = 1.0A, IRR = 0.25A. Note 2. Measured at 1MHz and applied reverse voltage of 4V. 1.000 (25.4) Min .042 (1.07) Max .300 (7.6) Max .180 (4.6) Max Color Band Denotes Cathode