RECTRON FMD1S SEMICONDUCTOR THRU TECHNICAL SPECIFICATION SINGLE-PHASE GLASS PASSIVATED MINI FAST RECOVERY SURFACE MOUNT BRIDGE RECTIFIER FMD7S VOLTAGE RANGE 50 to 1000 Volts CURRENT 0.8 Ampere FEATURES * Surge overload rating - 30 amperes peak * Ideal for printed circuit board * Reliable low cost construction utilizing molded * Glass passivated device * Polarity symbols molded on body * Mounting position: Any * Weight: 0.5 gram MD-S MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 o C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in millimeters MAXIMUM RATINGS (At TA = 25oC unless otherwise noted) SYMBOL FMD1S FMD2S FMD3S FMD4S FMD5S FMD6S FMD7S UNITS Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Bridge Input Voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Volts RATINGS Maximum Average Forward Output Rectified Current TA = 30oC -on glass-epoxy P.C.B. ( NOTE 1 ) -on aluminum substrate ( NOTE 2 ) Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) 0.5 IO Amp 0.8 IFSM 30 Amps pF Typical Junction Capacitance ( Note3 ) CJ 15 Operating and Storage Temperature Range TJ,TSTG -55 to + 150 0 C ELECTRICAL CHARACTERISTICS (At TA = 25oC unless otherwise noted) CHARACTERISTICS SYMBOL Maximum Forward Voltage Drop per Bridge Element at 0.4A DC FMD2S FMD3S @TA = 25 C DC Blocking Voltage per element @TA = 125oC IR trr FMD4S FMD5S FMD6S FMD7S 1.30 o Maximum Reverse Current at rated Maximum Reverse Recovery Time ( Note 4 ) FMD1S VF 150 UNITS Volts 10 uAmps 100 uAmps 250 500 NOTE: 1. On glass-epoxy P.C.B. mounted on 0.05 X 0.05” (1.3 X 1.3mm) pads. 2. On aluminum substrate P.C.B. with an area of 0.8 X 0.8 X 0.25” (20 X 20 X 6.4mm) mounted on 0.05 X 0.05” (1.27 X 1.27mm) solder pad. 3. Measured at 1MHz and applied reverse voltage of 4.0 volts. 4. Test Conditions: IF = 0.5A, IR = 1.0A, IRR = 0.25A. 5. Suffix “-S” Surface Mount for Mini Dip Bridge. nSec 1998-8 RECTRON