LB05S THRU LB10S MINIATURE GLASS PASSIVATED SINGLE-PHASE SURFACE MOUNT BRIDGE RECTIFIER REVERSE VOLTAGE: 50 to 1000 VOLTS FORWARD CURRENT: 0.5 AMPERE LBXS FEATURES · Surge overload rating: 30 amperes peak · Ideal for printed circuit board · Plastic material has Underwriters Laboratory Flammability Classification 94V-0 · Low leakage · Reliable low cost construction utilizing molded MECHANICAL DATA Case: Molded plastic, LBXS Epoxy: UL 94V-O rate flame retardant Terminals: Leads solderable per MIL-STD-202, method 208 guaranteed Dimensions in inches and (millimeters) Mounting position: Any Weight: 0.00528ounce, 0.134gram Maximum Ratings and Electrical Characteristics Ratings at 25 ℃ ambient temperature unless otherwise specified. Single phase, half wave, 60H Z, resistive or inductive load. LB05S LB1S LB2S LB4S LB6S LB8S LB10S Units Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Volts Maximum Average Forward Rectified Current (see Fig. 1) on glass-epoxy P.C.B (Note 2) I(AV) on aluminum substrate (Note 3) 0.5 Amp 0.8 Peak Forward Surge Current, 8.3ms single half-sine-wave IFSM 30 Amp VF 1.0 Volts superimposed on rated load (JEDEC method) Maximum Forward Voltage at 0.4A DC and 25℃ Maximum Reverse Current at TA=25℃ at Rated DC Blocking Voltage T A=125℃ Typical Junction Capacitance (Note 1) Typical Thermal Resistance (Note 3) Typical Thermal Resistance (Note 2) Operating and Storage Temperature Range IR 5.0 500 uAmp CJ 13 pF RθJA 60 ℃/W RθJL 16 ℃/W TJ，Tstg -55 to +150 ℃ NOTES: 1- Measured at 1 MHZ and applied reverse voltage of 4.0 VDC. 2- On glass epoxy P.C.B. mounted on 0.05 x 0.05" (1.3 x 1.3mm) pads 3- On aluminum substrate P.C.B. with an area of 0.8" x 0.8" (20 x 20mm) mounted on 0.05 x 0.05" (1.3 x 1.3mm) solder pad MDD ELECTRONICS MINIATURE GLASS PASSIVATED SINGLE-PHASE SURFACE MOUNT BRIDGE RECTIFIER Characteristic Curves (TA=25 ℃ unless otherwise noted) MDD ELECTRONICS