HDP-240 240W Dual Output with PFC Function Features : Universal AC input / Full range Built-in active PFC function, PF 0.94 High efficiency up to 84% Protections: Short circuit / Overload / Over voltage / Over temperature Forced air cooling by built-in DC fan 1U low profile 36mm Conformal coated Built-in cooling fan ON-OFF control ZVS technology to reduce power dissipation LED indicator for power on 3 years warranty SPECIFICATION MODEL HDP-240 OUTPUT NUMBER V1 DC VOLTAGE +3.8V +2.8V RATED CURRENT 41.5A 25A CURRENT RANGE (max.) 0 ~ 50A RATED POWER 227.7W (typ.) OUTPUT POWER (max.) OUTPUT V2 0 ~ 27.5A 241W (max.) 241W continue. V1 total power output shall not exceed 200W (max. 50A) ; V2 total power output shall not exceed 82.5W (max. 27.5A) (The V1 & V2 combine total power output shall not exceed 241W) RIPPLE & NOISE (max.) Note.2 100mVp-p 100mVp-p VOLTAGE ADJ. RANGE Note.6 3.6 ~ 4V VOLTAGE TOLERANCE Note.3 2.0% 2.5 ~ 3V 2.0% LINE REGULATION 0.5% LOAD REGULATION 2.0% 0.5% 2.0% SETUP, RISE TIME 1000ms, 50ms/230VAC HOLD UP TIME (Typ.) 16ms/230VAC 16ms/115VAC at full load VOLTAGE RANGE Note.5 90 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz INPUT 127 ~ 370VDC POWER FACTOR (Typ.) PF 0.94/230VAC EFFICIENCY (Typ.) AC CURRENT (Typ.) 84% 3.3A/115VAC 1.3A/230VAC INRUSH CURRENT (Typ.) 30A/115VAC 45A/230VAC LEAKAGE CURRENT <2mA / 240VAC V1+V2: 105 ~ 150% max. output power ; or V2: 125 ~ 170% rated current OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE FUNCTION 2500ms, 50ms/115VAC at full load FAN CONTROL (Typ.) WORKING TEMP. PF 0.98/115VAC at full load Protection type: Hiccup mode, recovers automatically after fault condition is removed V2: 3.22 ~ 3.78V V1: 4.37 ~ 5.13V Protection type : Shut down o/p voltage, re-power on to recover 80 5 (TSW1) detect on heatsink of power transistor Protection type : Shut down o/p voltage, re-power on to recovery RTH4 50 Fan on ; RTH4 45 Fan off -30 ~ +70 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH TEMP. COEFFICIENT 0.03%/ (0 ~ 50 ) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC (Note 4) EMC EMISSION OTHERS I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) class B, EN61000-3-2,-3 EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN61000-6-2, heavy industry level, criteria A MTBF 111.3K hrs min. DIMENSION 215*115*36mm (L*W*H) 1Kg; 15pcs/16Kg/0.7CUFT PACKING NOTE UL60950-1, TUV EN60950-1 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC MIL-HDBK-217F (25 ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. 5. Derating may be needed under low input voltages. Please check the derating curve for more details. 6. Output voltage between V1 and V2 should be higher than 0.8V(V1-V2 0.8V). File Name:HDP-240-SPEC 2012-02-29 HDP-240 240W Dual Output with PFC Function Mechanical Specification Case No.206A Unit:mm 215 204.5 97.5 150 32.5 24 15.85 SVR1 33.5 Terminal Pin No. Assignment : Assignment Pin No. AC/L 4,5 AC/N 6,7 8,9,10,11 FG SVR1: V1(+3.8V)ADJ. SVR2: V2(+2.8V)ADJ. 44.75 34.4 Assignment V2(+2.8V) V1(+3.8V) COM 10 32.5 47.45 115 108 95 50 Pin No. 1 2 3 16 3.5 9.5 135 8.3 11 10 LED 9 8 7 4-M4 L=5mm 6 SVR2 5 4 3 2 5-M3 L=3mm 1 15 215 150 32.5 16max. 12.5 36 Air flow direction 4-M4 L=5mm Block Diagram FAN ON/OFF CONTROL ACTIVE INRUSH CURRENT LIMITING EMI FILTER I/P RECTIFIERS & PFC POWER SWITCHING O.T.P. O.L.P. PFC fosc : 65KHz PWM fosc : 80KHz RECTIFIERS & FILTER +V1 COM POWER SWITCHING DETECTION CIRCUIT FG PFC CONTROL FAN PWM CONTROL O.V.P. +V2 O.L.P. PWM CONTROL DETECTION CIRCUIT O.V.P. Derating Curve Output Derating VS Input Voltage 100 100 90 80 80 70 50 LOAD(%) LOAD (%) 60 40 20 -30 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 90 95 100 115 130 145 165 185 205 225 245 264 INPUT VOLTAGE (V) 60Hz File Name:HDP-240-SPEC 2012-02-29