Xeon 1 Power Pure White LED OSW4X3E1E1E VER C.0 ■Features ■Outline ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior UV Resistance Dimension 3.6 ■Applications BackView ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext Part NO Unit:mm Tolerance:±0.30mm Tolerances are for reference only Technology Soldering Conditions OSW4M3E1E1E Molding Reflow Soldering OSW4Z3E1E1E Lens Hand Soldering ■Absolute Maximum Rating Item (Ta=25℃) ■Directivity Symbol Value Unit DC Forward Current IF 150 mA Pulse Forward Current* IFP 300 mA Reverse Voltage VR 15 V Power Dissipation PD 1710 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - *Pulse width Max.10ms 30° 60° 90° 1 60° 0.5 0 0.5 1 Duty ratio max 1/10 ■Electrical -Optical Characteristics (Ta=25℃) Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=120mA 9.0 9.6 11.4 V DC Reverse Current IR VR=15V - - 10 µA Luminous Flux Φv IF=120mA 80 90 105 lm Color Temperature CCT IF=120mA - 6500 - K Chromaticity x IF=120mA - 0.31 - - Coordinates* y IF=120mA - 0.33 - - 2θ1/2 IF=120mA - 140 - deg 50% Power Angle 0 30° Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series. LED & Application Technologies http://www.optosupply.com VER C.0 90° Xeon 1 Power Pure White LED OSW4X3E1E1E VER C.0 ■OSW4M3E1E1E - Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER C.0