Xeon 1 Power Pure Green &Red & Blue LED OSTCXBEAC1E VER.A.4 ■Features ● ■Outline Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance ● 4.4 Highest Luminous Flux ● 2.75 .3 7 4 Automotive Interior/Exterior Lighting / Signal Lighting Architectural Lighting ● B LCD TV / Monitor Backlight Projector Light Source / Traffic Signals / Task Lighting 4 Decorative / Pathway Lighting / Household Applications ■Absolute Item Symbol Back View 1 R G ℃ Value Red Green/Blue ■Directivity Unit DC Forward Current IF 400 400 mA Pulse Forward Current* IFP 500 500 mA Reverse Voltage VR 5 5 V Power Dissipation PD 1200 1600 mW Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40 ~ +100 Lead Soldering Temperature Tsol 260 ℃ ℃ ℃/5sec - *Pulse width Max.10ms Duty ratio max 1/10 ■Electrical ℃ (Ta=25 ) -Optical Characteristics Item DC Forward Voltage Symbol Condition Min. Typ. Max. Unit V F (R ) IF=350mA 2.0 2.5 3.0 V VF (B/G) IF=350mA 3.0 3.3 4.0 V IR VR=5V - - 10 µA λD(Red) IF=350mA 620 625 630 nm λD(Green) IF=350mA 520 525 535 nm λD(Blue) IF=350mA 455 460 465 nm v (Red) IF=350mA 40 50 - lm v (Green) IF=350mA 80 95 - lm v (Blue) IF=350mA 15 20 - lm 2θ1/2 IF=350mA - 120 - deg DC Reverse Current Domi. Wavelength Φ Luminous Flux Φ Φ 50% Power Angle Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 Power emitter series. LED & Application Technologies 4,5,6.Anode 1,2,3.Cathode Unit:mm Tolerance±0.30mm 6 5 (Ta=25 ) Maximum Rating Red Anode 6 2 3 Mobile Phone Flash 5 6 0.2 Mark ● ● .54 1 0. 5 Water Clear Type ● ● 5.3 1.0 3 2 1 ■Applications ● Dimension 0 0 Xeon 1 Power Pure Green &Red & Blue LED OSTCXBEAC1E VER.A.4 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies