SPECIFICATION CONTROL DRAWING MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene fluoride. 2. MELTABLE INSERTS: Low-outgassing thermoplastic, color-natural. 3. SEAMLESS STUB SPLICE: Base Metal: Copper Alloy 101 or 102 per ASTM B-75. Plating: Tin plated per MIL-T-10727. CMA Range: 300 to 1510 circular mils. APPLICATION 1. This system is designed to provide an environmentally resistant splice in wires rated for at least 125°C. Splices may be either two wire stub splices or 1 to 1 or 2 to 1 parallel splices. If two wires exit from one end, they must have a combined outer diameter of less than 2.03 (0.080). 2. Parts when installed as detailed on Raychem Specification Control Drawing D-436-58/-59 shall meet performance requirements of MIL-S-81824. 3. Acceptance testing shall be in accordance with Paragraph 4.6 of MIL-S-81824. Tyco Electronics Corporation 305 Constitution Drive Menlo Park, CA 94025, USA UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS. INCHES DIMENSIONS ARE BETWEEN BRACKETS. Tyco Electronics reserves the right to amend this ANGLES: N/A TOLERANCES: drawing at any time. Users should evaluate the 0.00 N/A suitability of the product for their application. ROUGHNESS IN 0.0 N/A MICRON 0 N/A DRAWN BY: REPLACES: DCR NUMBER: M. FORONDA D001280 TITLE : Raychem Products D010047 If this document is printed it becomes uncontrolled. Check for the latest revision. DOCUMENT NO.: STUB SPLICE SEALING SYSTEM, TIN PLATED CRIMP D-436-0128 DATE: DOC ISSUE: 2 26-Jan.-00 PROD. REV. A SCALE: None SIZE: A SHEET: 1 of 1