PLL602-20 200MHz XO IC With Selectable 4X/8X Multiplier FEATURES • • • • • Integrated crystal oscillator circuitry (XO). Very low Jitter and Phase Noise (-110dBc @ 10kHz offset) Selectable frequency multiplication (x4, x8). Accepts Fundamental Crystal input of 10MHz-30MHz Output Frequency: up to 200MHz CMOS Output enable (OE) pin with 60KΩ pull up resistor Operating temperature range from 0°C to 70°C 2.5 or 3.3V supply voltage. Available in Green/RoHS compliant 8-pin SOIC package XIN/FIN 1 GND 2 SEL4X/8X 3 CLK 4 8 XOUT 7 OE 6 NC 5 VDD PAD LAYOUT AND DIE ID DESCRIPTION The PLL602-20 is a general purpose low jitter and low phase noise (-110dBc @10kHz offset), high performance CMOS XO IC. This flexible device can be used as a XO with output frequencies ranging from F XIN x 4 to F XIN x 8 with the use of a single selector pin. This makes the PLL602-20 the ideal high performance, low-cost solution for a wide range of applications requiring up to 200MHz (including 77.76MHz, 125MHz and 155.52MHz). XIN 1 GND 2 GND 3 SEL4X/8X CLK 9 XOUT 8 OE 7 VDD 6 VDD 4 5 DIE SPECIFICATION BLOCK DIAGRAM SELx4x/8 Name XIn XO XOut PLL602-20 • • • • PIN CONFIGURATION Selectable PLL CLK Value Size 31.5x55.1 mil Reverse side GND Pad Opening 80 micron x 80 micron Die Thickness 10 mil 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 02/18/05 Page 1 C PLL602-20 200MHz XO IC With Selectable 4X/8X Multiplier PIN/PAD ASSIGNMENT and DESCRIPTION Name Pin # XIN/FIN 1 GND 2 Pad # Die Pads X (µm) Y(µm) 1 101.5 1274.0 2 101.5 1075.0 3 101.5 878.4 Type Description I Crystal or Reference Input Pin. P GND connection. Multiplier Selector Pin with 60KΩ pull-up resistor. Logic State 0 1(default) SEL4X/8X 3 4 101.5 671.8 O CLK 4 5 101.5 425.0 O Clock Output. VDD 5 6 697 483.0 7 697 790.0 P VDD connection. DNC 6 - - - - Do Not Connect. OE 7 8 697 1024.0 O XOUT 8 9 697 1274.0 O Multiplier x4 x8 Output Enable: ‘0’ to disable (tri-state output), 1’ (default value when not connected) to enable the output (internal (60KΩ pull up resistor). Crystal output. 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 02/18/05 Page 2 PLL602-20 200MHz XO IC With Selectable 4X/8X Multiplier ELECTRICAL SPECIFICATIONS ABSOLUTE MAXIMUM RATINGS PARAMETERS SYMBOL MIN. MAX. UNITS V DD - 0.5 4.6 V Input Voltage Range VI - 0.5 V DD + 0.5 V Output Voltage Range VO - 0.5 V DD + 0.5 V 260 °C -65 150 °C 0 70 °C Supply Voltage Range Soldering Temperature (Green package) Storage Temperature TS Ambient Operating Temperature Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other conditions above the operational limits noted in this specification is not implied. AC SPECIFICATIONS PARAMETERS CONDITIONS MIN. TYP. 10 MAX. UNITS 30 MHz 10 ms Crystal Input Frequency(XIN) Fundamental Crystal Settling Time At power-up (after VDD increases over 1.62V) Output Rise Time 15pF Load, 10/90%VDD 1.2 2.0 ns Output Fall Time 15pF Load, 90/10%VDD 1.2 2.0 ns Duty Cycle At VDD/2 50 55 % Period Jitter, peak-to-peak* (measured from 10,000 samples) With capacitive decoupling between VDD and GND. Operating only one output. 45 70 ps 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 02/18/05 Page 3 PLL602-20 200MHz XO IC With Selectable 4X/8X Multiplier DC SPECIFICATIONS PARAMETERS SYMBOL CONDITIONS TYP. At 80MHz, load=15pF, VDD=3.3V Supply Current, Dynamic, with Loaded Outputs I DD Operating Voltage V DD Output Low Voltage V OL I OL = +4mA Std. drive Output High Voltage V OH I OH = -4mA Std. drive Output Current I OSD V OL = 0.4V, V OH = 2.4V Short-circuit Current MIN. 2.25 MAX. UNITS 15 mA 3.63 V 0.4 V V DD – 0.4 V 24 IS ±50 mA mA JITTER AND PHASE NOISE SPECIFICATION PARAMETERS CONDITIONS MIN. TYP. MAX. UNITS at 155MHz, with capacitive decoupling between VDD and GND. 50 (PkPk – 10,000 samples) at 80MHz, with capacitive decoupling between VDD and GND. 55 Phase Noise relative to carrier 125MHz @100Hz offset -100 dBc/Hz Phase Noise relative to carrier 125MHz @1kHz offset -118 dBc/Hz Phase Noise relative to carrier 125MHz @10kHz offset -112 dBc/Hz Phase Noise relative to carrier 125MHz @100kHz offset -98 dBc/Hz Phase Noise relative to carrier 125MHz @1MHz offset -107 dBc/Hz Period Jitter ps 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 02/18/05 Page 4 PLL602-20 200MHz XO IC With Selectable 4X/8X Multiplier CRYSTAL SPECIFICATIONS PARAMETERS SYMBOL MIN. F XIN 10 Fundamental Crystal Resonator Frequency TYP. UNITS 30 MHz 11 C L (xtal) Crystal Loading Rating MAX. pF Maximum Sustainable Drive Level 500 Operating Drive Level µW µW 100 Crystal Shunt Capacitance C0 6 pF Effective Series Resistance, Fundamental, 10-30MHz RE 30 Ω Note: A detailed crystal specification document is also available for this part PACKAGE DRAWINGS (GREEN PACKAGE COMPLIANT) SOIC 8L Symbol A A1 A2 B C D E H L e Dimension in MM Min. Max. 1.35 1.75 0.10 0.25 1.25 1.50 0.33 0.53 0.19 0.27 4.80 5.00 3.80 4.00 5.80 6.20 0.40 0.89 1.27 BSC E H D A2 A A1 C e b L 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 02/18/05 Page 5 PLL602-20 200MHz XO IC With Selectable 4X/8X Multiplier ORDERING INFORMATION For part ordering, please contact our Sales Department: 47745 Fremont Blvd., Fremont, CA 94538, USA Tel: (510) 492-0990 Fax: (510) 492-0991 PART NUMBER The order number for this device is a combination of the following: Device number, Package type and Operating temperature range PLL602-20 PART NUMBER X X-R NONE= TUBE R=TAPE and REEL PACKAGE TYPE* S=SOIC TEMPERATURE C=COMMERCIAL I = INDUSTRIAL * PhaseLink Offers Green/RoHS Compliant Packaging Only. Part / Order Number PLL602-20SC PLL602-20SC-R Marking P602-20SC P602-20SC Package Option 8-Pin SOIC (Tube) 8-Pin SOIC (Tape & Reel) PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. LIFE SUPPORT POLICY: PhaseLink’s products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of PhaseLink Corporation. 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 02/18/05 Page 6