Preliminary PLL600-27F Low Power 5 Output XO 10MHz to 52MHz FEATURES Generates 5 CMOS outputs. 10 to 52MHz fundamental or 3 rd OT crystal input. Low phase noise (-130 dBc @ 10kHz offset). Low jitter (RMS): 2.5ps period jitter. 12mA drive capability at TTL output. 1.62V to 3.63V DC operation. Available in 14 pin 150mil SOIC. DESCRIPTION The PLL600-27F is part of PhaseLink’s low cost family of XO IC’s, designed to replace multiple XO solutions saving the cost and board space of clock distribution buffers. In addition, it provides among the lowest current on the market for the 10MHz to 52MHz range. It accepts input crystals from 10 to 52MHz (fundamental resonant mode) and provides low phase noise (<-130dBc at 10kHz offset at 30MHz), and very low jitter (2.5 ps RMS period jitter) outputs. XIN/FIN 1 14 XOUT GND 2 13 GND CLK1 3 12 CLK5 GND 4 11 VDD CLK2 5 10 CLK4 GND 6 9 VDD N/C 7 8 CLK3 PLL600-27F • • • • • • • PIN ASSIGNMENT BLOCK DIAGRAM XIN/FIN XOUT XTAL OSC CLK1 CLK2 CLK3 CLK4 CLK5 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 08/12/04 Page 1 Preliminary PLL600-27F Low Power 5 Output XO 10MHz to 52MHz PIN DESCRIPTION Name Pin # Type Description XIN GND CLK1 CLK2 N/C 1 2,4,6,13 3 5 7 I P O O - Crystal Input or Reference Clock input ( 10MHz to 52MHz ). Ground. Buffered clock output. Buffered clock output. No connection. CLK3 VDD CLK4 CLK5 XOUT 8 9,11 10 12 14 O P O O O Buffered clock output. Power supply. Buffered clock output. Buffered clock output. Crystal output. ELECTRICAL SPECIFICATIONS 1. Absolute Maximum Ratings PARAMETERS Supply Voltage Input Voltage, dc Output Voltage, dc Storage Temperature Ambient Operating Temperature* Junction Temperature Lead Temperature (soldering, 10s) ESD Protection, Human Body Model SYMBOL MIN. V DD VI VO TS TA TJ -0.5 -0.5 -65 -40 MAX. UNITS 4.6 V DD +0.5 V DD +0.5 150 85 125 260 2 V V V °C °C °C °C kV Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other conditions above the operational limits noted in this specification is not implied. * Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only. 2. AC Electrical Specifications PARAMETERS CONDITIONS Input Crystal Frequency Settling time Output Clock Rise/Fall Time VDD sensitivity Output Clock Duty Cycle Short Circuit Current MIN. TYP. 10 At power-up (Vdd reaches 1.62V) 0.8V ~ 2.0V with 10 pF load 0.3V ~ 3.0V with 15 pF load Frequency vs. VDD +/- 10% Measured @ 1.4V MAX. UNITS 52 MHz 10 ms 1.15 2.4 0.8 45 50 ±50 ns 0.8 55 ppm % mA 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 08/12/04 Page 2 Preliminary PLL600-27F Low Power 5 Output XO 10MHz to 52MHz 3. Jitter and Phase Noise Specifications PARAMETERS CONDITIONS RMS Period Jitter (1 sigma – 1000 samples) Phase Noise relative to carrier Phase Noise relative to carrier Phase Noise relative to carrier Phase Noise relative to carrier Phase Noise relative to carrier MIN. With capacitive decoupling between VDD and GND. 30MHz @100Hz offset 30MHz @1kHz offset 30MHz @10kHz offset 30MHz @100kHz offset 30MHz @1MHz offset TYP. MAX. UNITS 2.1 2.5 ps -80 -110 -130 -138 -145 dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz 4. DC Specifications PARAMETERS SYMBOL CONDITIONS I DD At 27MHz, Cload=10pF (3.3V) I DD V DD V OH V OL Output disabled V OHC I OH = -4mA (3.3V) Supply Current, Dynamic, with Loaded Outputs @ 3.3V Supply Current in tri-state Operating Voltage Output High Voltage Output Low Voltage Output High Voltage at CMOS level Output drive current MIN. TYP. MAX. 6.0 mA 520 3.63 1.62 2.4 I OH = -12mA (3.3V) I OL = 12mA (3.3V) 0.4 V DD – 0.4 At TTL level (3.3V) UNITS µA V V V V 12 17 mA 5. Crystal Specification PARAMETERS Crystal Resonator Frequency Crystal Loading Rating Maximum Sustainable Drive Level Operating Drive Level C0 (for frequencies below 30MHz) C0 (for frequencies above 30MHz) ESR SYMBOL MIN. F XIN C L (xtal) 10 TYP. MAX. UNITS 52 MHz pF 200 µW µW pF pF 8.5 50 RS 5 4 30 Ω Note: A detailed crystal specification document is also available for this part 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 08/12/04 Page 3 Preliminary PLL600-27F Low Power 5 Output XO 10MHz to 52MHz PACKAGE INFORMATION 14 PIN Narrow SOIC ( mm ) SOIC Symbol E Min. A 1.35 1.75 A1 0.10 0.25 B 0.33 0.51 C 0.19 0.25 D 9.80 10.00 E 3.80 4.00 H 5.80 6.20 L 0.40 e H Max. 1.27 1.27 BSC D A A1 C e L B ORDERING INFORMATION For part ordering, please contact our Sales Department: 47745 Fremont Blvd., Fremont, CA 94538, USA Tel: (510) 492-0990 Fax: (510) 492-0991 PART NUMBER The order number for this device is a combination of the following: Device number, Package type and Operating temperature range PLL600-27F SC TEMPERATURE C=COMMERCIAL I=INDUSTRIAL PART NUMBER PACKAGE TYPE S=SOIC Order Number PLL600-27F SC PLL600-27F SC-R Marking P600-27F SC P600-27F SC Package Option SOIC - Tube SOIC - Tape and Reel PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information furnished by PhaseLink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. LIFE SUPPORT POLICY: PhaseLink’s products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of PhaseLink Corporation. 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 08/12/04 Page 4