SENSITRON PB5038

SPDN Series
COBRA
SENSITRON
SEMICONDUCTOR
Product Brief 5038, Rev B
COBRA Series Programmable Multi-Channel
Solid State Power Controllers
The Cobra Series of Programmable Multi-Channel Solid
State Power Controllers (SSPC) are multi-channel,
microcontroller based, Solid State Power Controller boards
designed to for 28VDC applications. Each channel of the
Cobra series is software programmable for rated current
up to 25A and can operate grouped with other channels to
support large loads up to 150A of current. The Cobra is
intended to be used where multiple Solid State Power
Controller channels need to be co-located on the same
card or in a power distribution box. These boards have
integrated current sensing, temperature and voltage
sensing with no derating over the full operating
temperature range and communicate with the system
controller over an RS-232, RS-422, and RS-485 or CAN
serial bus.
Features:
•
•
•
•
•
•
•
Up to 6 channels can be grouped together
Programmable from 1 Amp to 25 Amps
Parallel channel capability up to 150 amps
Trip disable and maintenance modes
Power-up and continuous built-in test
Non-volatile storage of parameters
True I2t and thermal memory protection
•
•
•
•
•
•
•
Internally generated isolated supply
High control circuit isolation
Soft turn-on to reduce EMC issues
Trip-free reset circuit
Optically isolated input and outputs
-55oC to 100oC operating temp range
No heat sinking required
Benefits:
Sensitron’s SSPC technology and products combine functionalities of electro-mechanical breakers, solid
state relays and system monitors and provide the following benefits to our customers:
•
•
•
•
•
Electrical load protection and monitoring - current, voltage and temperature measurements
Operational improvements by allowing for diagnostics, prognostics and condition-based maintenance
Life cycle cost savings and reduced cost of ownership
Increased radius of operation through power budgeting and load shedding
Crew offloading and network-controlled intelligent load management
Application Areas:
Sensitron’s SSPC products are ideal for use in Power Management applications in the following markets:
•
•
•
•
Military Ground Vehicles
Unmanned Aerial Vehicles
Marine Vessels
Test & Industrial Equipment
•
•
•
•
Communication and Command Centers
Energy Exploration Equipment
Off Highway and Heavy Duty Vehicles
Medical Emergency Vehicles
• Phone (631) 586 7600 • www.sensitron.com • E-Mail: [email protected] • Page 1
SPDN Series
COBRA
SENSITRON
SEMICONDUCTOR
Product Brief 5038, Rev B
Figure 1 – Block Diagram
I/O DEFINITIONS
Control & Status (TTL/CMOS Compatible)
5.0V DC Nominal, 7.0V DC Absolute Maximum
4.5V to 5.5 VDC
105 mA typ
150 mA, max (RS-422/RS-485 Serial I/O)
Voh=3.7V, min, at Ioh=-20mA
Vol=0.4V, max, at Iol=20mA
BIAS (Vcc)
BIAS (Vcc) Current
BIT* Output
MAINTENANCE MODE and BATTLESHORT Inputs
VT+ (Positive-going input threshold voltage)
VT− (Negative-going input threshold voltage)
ΔVT Hysteresis (VT+ VT−)
Power
Input Voltage – Continuous
– Transient
Power Dissipation – Single Channel1
Power Dissipation – Six Channels1
(Each channel at indicated current)
Output Rise Time (turn-on)
Output Fall Time under normal turn-off
Output Fall Time under Fault
Min Load Requirement
2.0V, min, 3.5V, max
1.2V, min, 2.3V, max
0.6V, min, 1.4V, max
0 to 40V DC, 50V DC Absolute Maximum
+600V or –600V Spike (< 10 uS)
< 0.68W typ @ 15A @ 25°C
< 2.25W max @ 25A @ 25°C
< 4.5W typ @ 15A @ 25°C
< 15.0W max @ 25A @ 25°C
760 μsec typ, 500 μsec, min.
160 μsec typ, 100 μsec, min.
75 μsec typ
Nil
Table 1- Electrical Characteristics
© 2009 Sensitron Semiconductor • Phone (631) 586 7600 • www.sensitron.com • [email protected] •
Page 2
SPDN Series
COBRA
SENSITRON
SEMICONDUCTOR
Product Brief 5038, Rev B
Figure 2 – Trip Times
The Cobra Series board measures current for each individual channel and calculates I2t and Instant Trip. If
the trip condition is met, the channel turns of 28VDC rails from the load. This condition is stored on the
board and can be queried by the Power Management Computer (PMC) via the communications interface.
Figure 3 – Outline Drawing
© 2009 Sensitron Semiconductor • Phone (631) 586 7600 • www.sensitron.com • [email protected] •
Page 3
SPDN Series
COBRA
SENSITRON
SEMICONDUCTOR
Product Brief 5038, Rev B
SUPPORT
Sensitron’s Graphical User Interface provides a quick way to interact with the Diamondback board. This PC- based
program is designed for lab use and enables the user to evaluate the board. The GUI sends the commands to the board
to perform tasks such as channel turn on/off, measurement readings, channel paralleling, etc.
Please contact the factory to obtain a copy of this program.
COMPLIANT DOCUMENTS & STANDARDS
MIL-STD-1275D
MIL-STD-704F
MIL-STD-217F, Notice 2
Characteristics of 28 Volt DC Electrical Systems in Military Vehicles
Aircraft Electrical Power Characteristics
Reliability Prediction of Electronic Equipment
PART NUMBERING ORDERING INFORMATION :
DISCLAIMER:
1- The information given herein, including the specifications and dimensions, is subject to change without prior notice to improve product
characteristics. Before ordering, purchasers are advised to contact the Sensitron Semiconductor sales department for the latest version of the
datasheet(s).
2- In cases where extremely high reliability is required (such as use in nuclear power control, aerospace and aviation, traffic equipment, medical
equipment , and safety equipment) , safety should be ensured by using semiconductor devices that feature assured safety or by means of users’
fail-safe precautions or other arrangement .
3- In no event shall Sensitron Semiconductor be liable for any damages that may result from an accident or any other cause during operation of
the user’s units according to the datasheet(s). Sensitron Semiconductor assumes no responsibility for any intellectual property claims or any
other problems that may result from applications of information, products or circuits described in the datasheets.
4- In no event shall Sensitron Semiconductor be liable for any failure in a semiconductor device or any secondary damage resulting from use at
a value exceeding the absolute maximum rating.
5- No license is granted by the datasheet(s) under any patents or other rights of any third party or Sensitron Semiconductor.
6- The datasheet(s) may not be reproduced or duplicated, in any form, in whole or part, without the expressed written permission of Sensitron
Semiconductor.
7- The products (technologies) described in the datasheet(s) are not to be provided to any party whose purpose in their application will hinder
maintenance of international peace and safety nor are they to be applied to that purpose by their direct purchasers or any third party. When
exporting these products (technologies), the necessary procedures are to be taken in accordance with related laws and regulations.
© 2009 Sensitron Semiconductor • Phone (631) 586 7600 • www.sensitron.com • [email protected] •
Page 4