RGP10A THRU RGP10M Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 1.0 Amp Glass Passivated Junction Fast Recovery Rectifiers 50 to 1000 Volts Features • • • • • High temperature metallurgically bonded construction Glass passivated cavity-free junction 1.0 ampere operation at TA= 55OC with no thermal runaway. Typical IR less than 0.1uA Fast switching for high efficiency DO-41 Maximum Ratings • • • Operating Temperature: -55OC to +150CC Storage Temperature: -55CC to +150 CC Typical Thermal Resistance: 55OC/W Junction to Ambient Part Number RGP10A RGP10B RGP10D RGP10G RGP10J RGP10K RGP10M Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage Maximum DC Blocking Voltage 35V 70V 140V 280V 420V 560V 700V 50V 100V 200V 400V 600V 800V 1000V D A Cathode Mark B D Electrical Cha racteristics @ 25OC Unless Otherwise Specified Maximum Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage Maximum DC Reverse Current At Rated DC Blocking Voltage Typical Junction Capacitance Maximum Reverse Recovery Time RGP10A-10G RGP10J RGP10K-10M TA = 55OC IF(AV) 1.0 A IFSM 30A 8.3ms, half sine VF 1.3V IFM = 1.0A; TA = 25OC IR 5.0uA 200uA CJ 15pF Trr 150nS 250nS 500nS TA = 25OC TA = 150OC C DIMENSIONS DIM A B C D INCHES MIN .166 .080 .028 1.000 Measured at 1.0MHz, V R=4.0V TJ =25OC I F=0.5A I R=1.0A I RR=0.25A www.cnelectr.com MAX .205 .107 .034 --- MM MIN 4.10 2.00 .70 25.40 MAX 5.20 2.70 .90 --- NOTE RGP10A thru RGP10M Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 1.2 6 4 1.0 2 25OC Amps .8 1 .6 .6 Amps .4 .4 .2 .2 .1 Single Phase, Half Wave 60Hz Resistive or Inductive Load .06 0 .04 0 50 75 100 125 150 175 O C .02 .01 .4 .6 Average Forward Rectified Current - Amperes versus Ambient Temperature - OC .8 1.4 1.0 1.2 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF TJ =25OC 10 6 4 2 1 .1 .2 .4 1 2 4 10 20 40 100 200 Volts Junction Capacitance - pF versus Reverse Voltage - Volts www.cnelectr.com 400 1000 RGP10A thru RGP10M Figure 4 Peak Forward Surge Current 60 50 40 30 Amps 20 10 01 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.cnelectr.com